| /linux/Documentation/devicetree/bindings/hwmon/ |
| H A D | amd,sbrmi.yaml | 17 Mailbox Service Request and resembles a typical 8-pin remote power
|
| H A D | amd,sbtsi.yaml | 18 and resembles a typical 8-pin remote temperature sensor's I2C interface
|
| /linux/Documentation/timers/ |
| H A D | hpet.rst | 28 The driver provides a userspace API which resembles the API found in the
|
| /linux/Documentation/userspace-api/media/cec/ |
| H A D | cec-intro.rst | 18 connectors. The protocol closely resembles a crazy Rube Goldberg
|
| /linux/Documentation/driver-api/media/ |
| H A D | v4l2-intro.rst | 69 The framework closely resembles the driver structure: it has a v4l2_device
|
| /linux/kernel/trace/rv/ |
| H A D | rv.c | 82 * The user interface resembles kernel tracing interface. It presents
119 * received from the instrumentation. It resembles the "tracing_on"
125 * The "monitors/" directory resembles the "events" directory on
|
| H A D | rv_reactors.c | 29 * The user interface resembles the kernel tracing interface and
|
| /linux/Documentation/hwmon/ |
| H A D | sbrmi.rst | 40 power on AMD platforms using mailbox command and resembles a typical 8-pin remote
|
| /linux/Documentation/hid/ |
| H A D | amd-sfh-hid.rst | 8 In terms of architecture it resembles ISH, however the major difference is all
|
| H A D | intel-ish-hid.rst | 165 This protocol resembles bus messages described in the following document:
|
| /linux/Documentation/driver-api/usb/ |
| H A D | gadget.rst | 50 The gadget API resembles the host side Linux-USB API in that both use
226 protocols, USB resembles synchronous protocols like HDLC (N bytes per
|
| /linux/drivers/iommu/arm/arm-smmu-v3/ |
| H A D | arm-smmu-v3-test.c | 388 * Although no flow resembles this in practice, one way to force an STE in arm_smmu_v3_write_ste_test_non_hitless()
|
| /linux/Documentation/iio/ |
| H A D | ad4000.rst | 53 Datasheet "3-wire" mode is what most resembles standard SPI connection which,
|
| /linux/arch/parisc/mm/ |
| H A D | fault.c | 78 * It resembles an FDC instruction, except for bits in parisc_acctyp()
|
| /linux/drivers/net/phy/ |
| H A D | bcm54140.c | 521 * max_addr which resembles the range of PHY addresses of the same in bcm54140_get_base_addr_and_port()
|
| /linux/drivers/net/ethernet/atheros/atl1e/ |
| H A D | atl1e_main.c | 2500 * resembles the first-half of the e1000_resume routine.
2527 * its OK to resume normal operation. Implementation resembles the
|
| /linux/drivers/net/ethernet/intel/igbvf/ |
| H A D | netdev.c | 2542 * resembles the first-half of the igbvf_resume routine.
2566 * its OK to resume normal operation. Implementation resembles the
|
| /linux/drivers/net/ethernet/atheros/atl1c/ |
| H A D | atl1c_main.c | 2821 * resembles the first-half of the e1000_resume routine.
2849 * its OK to resume normal operation. Implementation resembles the
|
| /linux/net/netfilter/ |
| H A D | Kconfig | 1552 This match pretty much resembles the CONFIG_NET_CLS_ROUTE4 option
|
| /linux/include/linux/ |
| H A D | rcupdate.h | 242 * This macro resembles cond_resched(), except that it is defined to
|
| /linux/Documentation/filesystems/ |
| H A D | f2fs.rst | 854 initialized to zero. This default behavior closely resembles the
|
| /linux/drivers/net/ethernet/intel/ixgbevf/ |
| H A D | ixgbevf_main.c | 4843 * resembles the first-half of the ixgbevf_resume routine.
4871 * its OK to resume normal operation. Implementation resembles the
|
| /linux/mm/ |
| H A D | percpu.c | 3279 * The embedding helper is used because its behavior closely resembles
|
| /linux/drivers/net/ethernet/intel/igc/ |
| H A D | igc_main.c | 7655 * resembles the first-half of the __igc_resume routine.
7696 * its OK to resume normal operation. Implementation resembles the
|
| /linux/Documentation/networking/ |
| H A D | arcnet-hardware.rst | 992 The SMC710 card resembles the PC270 card, but is much more basic (i.e. no
|