Home
last modified time | relevance | path

Searched +full:regulator +full:- +full:booster (Results 1 – 9 of 9) sorted by relevance

/linux/Documentation/devicetree/bindings/regulator/
H A Dst,stm32-booster.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/regulator/st,stm32-booster.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: STMicroelectronics STM32 booster for ADC analog input switches
10 - Fabrice Gasnier <fabrice.gasnier@foss.st.com>
13 Some STM32 devices embed a 3.3V booster supplied by Vdda, that can be used
17 - $ref: regulator.yaml#
22 - st,stm32h7-booster
23 - st,stm32mp1-booster
[all …]
/linux/drivers/regulator/
H A Dstm32-booster.c1 // SPDX-License-Identifier: GPL-2.0
10 #include <linux/regulator/driver.h>
11 #include <linux/regulator/of_regulator.h>
29 .name = "booster",
43 return regmap_write(rdev->regmap, STM32MP1_SYSCFG_PMCSETR, in stm32mp1_booster_enable()
49 return regmap_write(rdev->regmap, STM32MP1_SYSCFG_PMCCLRR, in stm32mp1_booster_disable()
60 .name = "booster",
74 struct device *dev = &pdev->dev; in stm32_booster_probe()
75 struct device_node *np = pdev->dev.of_node; in stm32_booster_probe()
105 .compatible = "st,stm32h7-booster",
[all …]
/linux/Documentation/devicetree/bindings/iio/adc/
H A Dst,stm32-adc.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/iio/adc/st,stm32-adc.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 STM32 ADC is a successive approximation analog-to-digital converter.
13 stored in a left-aligned or right-aligned 32-bit data register.
17 voltage goes beyond the user-defined, higher or lower thresholds.
22 - Fabrice Gasnier <fabrice.gasnier@foss.st.com>
27 - st,stm32f4-adc-core
28 - st,stm32h7-adc-core
[all …]
/linux/Documentation/devicetree/bindings/sound/
H A Dcs35l33.txt5 - compatible : "cirrus,cs35l33"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VP-supply : power supplies for the device,
11 Documentation/devicetree/bindings/regulator/regulator.txt.
15 - reset-gpios : gpio used to reset the amplifier
17 - interrupts : IRQ line info CS35L33.
18 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
21 - cirrus,boost-ctl : Booster voltage use to supply the amp. If the value is
26 - cirrus,ramp-rate : On power up, it affects the time from when the power
27 up sequence begins to the time the audio reaches a full-scale output.
[all …]
/linux/sound/soc/codecs/
H A Dtfa989x.c1 // SPDX-License-Identifier: GPL-2.0-only
6 * Copyright (C) 2014-2020 NXP Semiconductors, All Rights Reserved.
14 #include <linux/regulator/consumer.h>
61 struct regulator *vddd_supply;
111 gpiod_set_value_cansleep(tfa989x->rcv_gpiod, ucontrol->value.enumerated.item[0]); in tfa989x_put_mode()
126 if (tfa989x->rev->rev == TFA9897_REVISION) in tfa989x_probe()
155 return -EINVAL; in tfa989x_find_sample_rate()
162 struct snd_soc_component *component = dai->component; in tfa989x_hw_params()
179 .name = "tfa989x-hifi",
248 /* Reduce slewrate by clearing iddqtestbst to avoid booster damage */ in tfa9897_init()
[all …]
/linux/include/ufs/
H A Dufshcd.h1 /* SPDX-License-Identifier: GPL-2.0-or-later */
4 * Copyright (C) 2011-2013 Samsung India Software Operations
5 * Copyright (c) 2013-2016, The Linux Foundation. All rights reserved.
16 #include <linux/blk-crypto-profile.h>
17 #include <linux/blk-m
[all...]
/linux/include/linux/ssb/
H A Dssb_regs.h1 /* SPDX-License-Identifier: GPL-2.0 */
33 #define SSB_MAX_NR_CORES ((SSB_ENUM_LIMIT - SSB_ENUM_BASE) / SSB_CORE_SIZE)
108 #define SSB_TMSHIGH_SERR 0x00000001 /* S-error */
168 * in two-byte quantities.
202 #define SSB_SPROM1_BINF_ANTBG 0x3000 /* Available B-PHY and G-PHY antennas */
204 #define SSB_SPROM1_BINF_ANTA 0xC000 /* Available A-PHY antennas */
218 #define SSB_SPROM1_MAXPWR_BG 0x00FF /* B-PHY and G-PHY (in dBm Q5.2) */
219 #define SSB_SPROM1_MAXPWR_A 0xFF00 /* A-PHY (in dBm Q5.2) */
225 #define SSB_SPROM1_ITSSI_BG 0x00FF /* B-PHY and G-PHY*/
226 #define SSB_SPROM1_ITSSI_A 0xFF00 /* A-PHY */
[all …]
/linux/drivers/net/wireless/broadcom/b43/
H A Db43.h1 /* SPDX-License-Identifier: GPL-2.0 */
61 /* 32-bit DMA */
68 /* 64-bit DMA */
194 #define B43_BFH_BUCKBOOST 0x0020 /* has buck/booster */
202 #define B43_BFL2_RXBB_INT_REG_DIS 0x0001 /* external RX BB regulator present */
203 #define B43_BFL2_APLL_WAR 0x0002 /* alternative A-band PLL settings implemented */
209 #define B43_BFL2_BTC3WIRE 0x0080 /* used 3-wire bluetooth coexist */
211 #define B43_BFL2_SPUR_WAR 0x0200 /* has a workaround for clock-harmonic spurs */
212 #define B43_BFL2_GPLL_WAR 0x0400 /* altenative G-band PLL settings implemented */
234 #define B43_SHM_AUTOINC_R 0x0200 /* Auto-increment address on read */
[all …]
/linux/drivers/ufs/core/
H A Dufshcd.c1 // SPDX-License-Identifier: GPL-2.0-or-later
4 * Copyright (C) 2011-2013 Samsung India Software Operations
5 * Copyright (c) 2013-2016, The Linux Foundation. All rights reserved.
17 #include <linux/blk-pm.h>
24 #include <linux/regulator/consumer.h>
31 #include "ufshcd-priv.h"
34 #include "ufs-sysfs.h"
35 #include "ufs-debugfs.h"
36 #include "ufs-fault-injection.h"
38 #include "ufshcd-crypto.h"
[all …]