/freebsd/sys/contrib/openzfs/tests/zfs-tests/tests/functional/redacted_send/ |
H A D | redacted_origin.ksh | 49 $POOL2/rBC $POOL2/rE 59 log_must eval "zfs receive $POOL2/rBC <$stream" 67 log_must eval "zfs receive -o origin=$POOL2/rBC@snap0 $POOL2/BCrF <$stream" 74 log_must eval "zfs send -i $POOL2/rBC@snap0 $POOL2/BCrF@snap >$stream"
|
/freebsd/sys/cam/ |
H A D | README.quirks | 23 and RBC. SCSI hard drives are usually SBC-compliant and smaller 24 devices like flash drives are usually RBC-compliant. Multimedia 52 by all SBC and RBC standards. Note that a warning message on 57 o DA_Q_NO_6_BYTE - The RBC spec (see Links below) does not allow
|
/freebsd/sys/contrib/device-tree/Bindings/ata/ |
H A D | ahci-mtk.txt | 13 - clock-names : Associated names must be: "ahb", "axi", "asic", "rbc", "pm". 41 clock-names = "ahb", "axi", "asic", "rbc", "pm";
|
H A D | mediatek,mtk-ahci.yaml | 39 - const: rbc 88 clock-names = "ahb", "axi", "asic", "rbc", "pm";
|
H A D | snps,dwc-ahci-common.yaml | 54 const: rbc
|
/freebsd/share/man/man4/ |
H A D | usb_quirk.4 | 133 pad RBC requests to 12 bytes 151 force RBC command protocol
|
/freebsd/sys/dev/usb/quirk/ |
H A D | usb_quirk.h | 87 UQ_MSC_RBC_PAD_TO_12, /* pad RBC requests to 12 bytes */ 96 UQ_MSC_FORCE_PROTO_RBC, /* force RBC command protocol */
|
/freebsd/sys/dev/cxgbe/firmware/ |
H A D | t5fw_cfg.txt | 83 mc_mode_brc[0] = 1 # mc0 - 1: enable BRC, 0: enable RBC 84 mc_mode_brc[1] = 1 # mc1 - 1: enable BRC, 0: enable RBC
|
H A D | t5fw_cfg_hashfilter.txt | 92 mc_mode_brc[0] = 0 # mc0 - 1: enable BRC, 0: enable RBC 93 mc_mode_brc[1] = 0 # mc1 - 1: enable BRC, 0: enable RBC
|
H A D | t6fw_cfg_hashfilter.txt | 79 mc_mode_brc[0] = 0 # mc0 - 1: enable BRC, 0: enable RBC
|
H A D | t6fw_cfg.txt | 86 #mc_mode_brc[0] = 1 # mc0 - 1: enable BRC, 0: enable RBC
|
H A D | t5fw_cfg_uwire.txt | 183 mc_mode_brc[0] = 1 # mc0 - 1: enable BRC, 0: enable RBC 184 mc_mode_brc[1] = 1 # mc1 - 1: enable BRC, 0: enable RBC
|
H A D | t6fw_cfg_uwire.txt | 198 #mc_mode_brc[0] = 1 # mc0 - 1: enable BRC, 0: enable RBC, 2: enable BRBC
|
/freebsd/sys/dev/aac/ |
H A D | aac_cam.c | 630 struct aac_resetbus *rbc; in aac_cam_reset_bus() local 652 rbc = (struct aac_resetbus *)&vmi->IoctlBuf[0]; in aac_cam_reset_bus() 653 rbc->BusNumber = camsc->inf->BusNumber; in aac_cam_reset_bus()
|
/freebsd/sys/dev/sym/ |
H A D | sym_fw2.h | 1677 * If WSR bit is set, either UA and RBC may 1689 SCR_STORE_REL (rbc, 4), 1704 * If WSR bit is set, either UA and RBC may 1716 SCR_STORE_REL (rbc, 4), 1789 * RBC[0..23]=0 is a special case that does not require 1792 SCR_FROM_REG (rbc), 1805 * RBC[0..23]=0.
|
/freebsd/usr.sbin/camdd/ |
H A D | camdd.8 | 112 Direct Access (type 0), WORM (type 4), CDROM (type 5), and RBC (Reduced
|
/freebsd/tests/sys/mac/bsdextended/ |
H A D | ugidfw_test.c | 122 "subject uid root object type rbc mode a",
|
/freebsd/sys/dev/usb/storage/ |
H A D | umass.c | 350 /* Pad all RBC requests to 12 bytes. */ 934 printf("RBC"); in umass_attach() 2700 /* these commands are defined in RBC: */ in umass_rbc_transform() 2714 * RBC specs. CAM however seems to want those, and at least in umass_rbc_transform() 2730 /* All other commands are not legal in RBC */ in umass_rbc_transform() 2732 DPRINTF(sc, UDMASS_SCSI, "Unsupported RBC " in umass_rbc_transform()
|
/freebsd/sys/dev/aacraid/ |
H A D | aacraid_cam.c | 1253 struct aac_resetbus *rbc; in aac_cam_reset_bus() local 1310 rbc = (struct aac_resetbus *)&vmi->IoctlBuf[0]; in aac_cam_reset_bus() 1311 rbc->BusNumber = camsc->inf->BusNumber - 1; in aac_cam_reset_bus()
|
/freebsd/sys/contrib/device-tree/src/arm64/mediatek/ |
H A D | mt7622.dtsi | 890 clock-names = "ahb", "axi", "asic", "rbc", "pm";
|
/freebsd/sys/dev/mthca/ |
H A D | mthca_main.c | 150 mthca_info(mdev, "No PCI-X capability, not setting RBC.\n"); in mthca_tune_pci()
|
/freebsd/sys/dev/qlnx/qlnxe/ |
H A D | ecore_dev.c | 2323 * 3. send an sdm_qm_cmd through the rbc interface to stop the QM 2325 * 5. send an sdm_qm_cmd through rbc interface to release the QM 2853 /* Poll on RBC */ in ecore_hw_init_chip() 2862 "RBC done failed to complete in PSWRQ2\n"); in ecore_hw_init_chip()
|
H A D | reg_addr.h | 10295 …f an independent stall source. This is the first of three provided via the RBC. The value written … 10296 … an independent stall source. This is the second of three provided via the RBC. The value written … 10297 …of an independent stall source. This is the last of three provided via the RBC. The value written … 10313 … ECC error injection the next time there is a write to the internal RAM by RBC. For this, any set … 10338 …ing register assigns bits 31:0 of the CAM mask in preparation for upcoming RBC requested SEARCH an… 10339 …ng register assigns bits 63:31 of the CAM mask in preparation for upcoming RBC requested SEARCH an… 10340 …ng register assigns bits 67:64 of the CAM mask in preparation for upcoming RBC requested SEARCH an… 10341 …ng register assigns bits 31:0 of the CAM value in preparation for upcoming RBC requested SEARCH, A… 10342 …g register assigns bits 63:32 of the CAM value in preparation for upcoming RBC requested SEARCH, A… 10343 …g register assigns bits 67:64 of the CAM value in preparation for upcoming RBC requested SEARCH, A… [all …]
|
H A D | ecore_int.c | 611 {"PGLUE B RBC", ATTENTION_PAR_INT, ecore_pglueb_rbc_attn_cb, BLOCK_PGLUE_B},
|
/freebsd/sys/dev/firewire/ |
H A D | sbp.c | 1568 * XXX Convert Direct Access device to RBC. in sbp_fix_inq_data()
|