Searched full:rails (Results 1 – 25 of 30) sorted by relevance
12
| /freebsd/sys/contrib/device-tree/src/arm64/rockchip/ |
| H A D | rk3399-gru.dtsi | 24 * In general an attempt is made to include all rails called out by
25 * the schematic as long as those rails interact in some way with
27 * - Rails that only connect to the EC (or devices that the EC talks to)
29 * - Rails _are_ included if the rails go to the AP even if the AP
34 * If two rails are substantially the same from the AP's point of
36 * put the child rail as an alias of the parent rail. Sometimes rails
40 * - The rails are actually connected to each other by a jumper and
|
| H A D | rk3328-rock64.dts | 41 /* Common enable line for all of the rails mentioned in the labels */
|
| /freebsd/sys/contrib/device-tree/Bindings/mfd/ |
| H A D | richtek,rt5120.yaml | 15 I/O, and peripheral rails in home entertainment devices. The I2C interface is
16 used for dynamic voltage scaling of the processor voltage, power rails on/off
|
| H A D | max77620.txt | 122 GPIO1/nRST_IO pins are HIGH only if all rails
124 If any of the rails goes down(which are enabled for POK
|
| H A D | bd9571mwv.txt | 30 rails need to be kept powered when backup mode is
|
| H A D | rohm,bd9571mwv.yaml | 40 This is a bitmask that specifies which DDR power rails need to be kept
|
| H A D | gateworks-gsc.yaml | 17 - Hardware monitor with ADC's for temperature and voltage rails and
|
| H A D | stericsson,db8500-prcmu.yaml | 62 power rails inside the silicon but some of those are also routed
|
| H A D | as3722.txt | 127 AS3722 supports the system power off by turning off all its rails.
|
| /freebsd/sys/contrib/device-tree/Bindings/regulator/ |
| H A D | max77650-regulator.yaml | 20 three independent power rails.
|
| H A D | tps65090.txt | 22 entry then driver will just configure this rails as external control
|
| H A D | pfuze100.yaml | 57 power rails when PMIC_STBY_REQ line is asserted during the power off sequence.
|
| H A D | richtek,rtq2208.yaml | 20 operation modes for all buck rails, automatic power saving mode (Auto mode) and forced continuous
|
| H A D | pfuze100.txt | 16 power rails when PMIC_STBY_REQ line is asserted during the power off sequence.
|
| /freebsd/sys/contrib/device-tree/src/arm64/qcom/ |
| H A D | sc7180-trogdor-kingoftown-r0.dts | 32 en_fp_rails: en-fp-rails-state {
|
| H A D | sa8155p.dtsi | 6 * Most notably, the RPMhPD setup differs: MMCX and LCX/LMX rails are gone,
|
| H A D | sc7180-trogdor-homestar.dtsi | 98 * rail and eDP rails are separate from each other on homestar (but
|
| /freebsd/sys/contrib/device-tree/Bindings/soc/qcom/ |
| H A D | qcom-stats.yaml | 14 sleep modes involving powering down of the rails and oscillator clock.
|
| /freebsd/sys/contrib/device-tree/Bindings/input/ |
| H A D | goodix,gt7375p.yaml | 49 with what the touchscreen is expecting for its IO rails.
|
| /freebsd/sys/contrib/device-tree/Bindings/display/panel/ |
| H A D | panel-dsi-cm.yaml | 45 because all its power rails can be driven by the same supply. In that case
|
| H A D | panel-common.yaml | 135 because all its power rails can be driven by the same supply. In that case
|
| /freebsd/sys/arm/nvidia/ |
| H A D | tegra_pmc.h | 73 /* PARTIDs for power rails */
|
| /freebsd/sys/contrib/device-tree/src/arm/renesas/ |
| H A D | r8a73a4-ape6evm.dts | 55 /* Common 1.8V and 3.3V rails, used by several devices on APE6EVM */
|
| /freebsd/sys/contrib/device-tree/src/arm/st/ |
| H A D | ste-hrefv60plus.dtsi | 71 /* Name the GPIO muxed rails on the HREF boards */
|
| H A D | ste-snowball.dts | 117 /* Name the GPIO muxed rails on the Snowball board */
|
12