Searched +full:phy +full:- +full:3 +full:p0 +full:- +full:supply (Results 1 – 5 of 5) sorted by relevance
| /linux/Documentation/devicetree/bindings/display/msm/ |
| H A D | dp-controller.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/display/msm/dp-controller.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Kuogee Hsieh <quic_khsieh@quicinc.com>
11 - Abhinav Kumar <quic_abhinavk@quicinc.com>
20 - enum:
21 - qcom,sa8775p-dp
22 - qcom,sc7180-dp
23 - qcom,sc7280-dp
[all …]
|
| /linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6q-bosch-acc.dts | 1 // SPDX-License-Identifier: GPL-2.0
3 * Support for the i.MX6-based Bosch ACC board.
8 * Copyright (C) 2019-2021 Bosch Thermotechnik GmbH, Matthias Winker <matthias.winker@bosch.com>
12 /dts-v1/;
14 #include <dt-bindings/gpio/gpio.h>
15 #include <dt-bindings/leds/common.h>
20 compatible = "bosch,imx6q-acc", "fsl,imx6q";
37 backlight_lvds: backlight-lvds {
38 compatible = "pwm-backlight";
40 brightness-levels = <0 61 499 1706 4079 8022 13938 22237 33328 47623 65535>;
[all …]
|
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | aspeed-bmc-facebook-bletchley.dts | 1 // SPDX-License-Identifier: GPL-2.0+
3 /dts-v1/;
5 #include "aspeed-g6.dtsi"
6 #include <dt-bindings/gpio/aspeed-gpio.h>
7 #include <dt-bindings/usb/pd.h>
8 #include <dt-bindings/leds/leds-pca955x.h>
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/i2c/i2c.h>
14 compatible = "facebook,bletchley-bmc", "aspeed,ast2600";
29 iio-hwmon {
[all …]
|
| /linux/drivers/usb/dwc3/ |
| H A D | core.c | 1 // SPDX-License-Identifier: GPL-2.0
3 * core.c - DesignWare USB3 DRD Controller Core file
5 * Copyright (C) 2010-2011 Texas Instruments Incorporated - https://www.ti.com
24 #include <linux/dma-mapping.h>
42 #include "../host/xhci-ext-caps.h"
47 * dwc3_get_dr_mode - Validates and sets dr_mode
53 struct device *dev = dwc->dev; in dwc3_get_dr_mode()
56 if (dwc->dr_mode == USB_DR_MODE_UNKNOWN) in dwc3_get_dr_mode()
57 dwc->dr_mode = USB_DR_MODE_OTG; in dwc3_get_dr_mode()
59 mode = dwc->dr_mode; in dwc3_get_dr_mode()
[all …]
|
| /linux/drivers/net/ethernet/broadcom/bnx2x/ |
| H A D | bnx2x_reg.h | 3 * Copyright (c) 2007-2013 Broadcom Corporation
13 * R - Read only
14 * RC - Clear on read
15 * RW - Read/Write
16 * ST - Statistics register (clear on read)
17 * W - Write only
18 * WB - Wide bus register - the size is over 32 bits and it should be
20 * WR - Write Clear (write 1 to clear the bit)
29 #define ATC_ATC_INT_STS_REG_ATC_RCPL_TO_EMPTY_CNT (0x1<<3)
32 /* [RW 1] Initiate the ATC array - reset all the valid bits */
[all …]
|