Searched full:minimise (Results 1 – 25 of 56) sorted by relevance
123
234 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_single()277 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_mask()
53 priority to minimise the transfer latency on the bus (boolean)
61 * This is similar to s3c_pm_do_restore() except we try and minimise the
136 * we minimise the work between the two settings. in samsung_gpio_pm_2bit_resume()
20 * chosen to minimise the shift distances.
37 * We pick the reserved-ASID to minimise the impact. in __do_compat_cache_op()
48 * to eventually flush us, but to minimise latency just ask the in __busy_set_if_active()
73 not in use in order to minimise the need to use ifdefs.
171 minimise any system noise. The mute stops any digital data from
235 * priority to minimise the transfer latency on the bus.
103 * the latest supported version and wish to minimise code size.
10 are very small and all blocks are packed to minimise data overhead.
144 /* Minimise down-time: drop delay for up event. */ in linkwatch_schedule_work()
73 * Ramp OUT1 PGA volume to minimise pops at stream startup and shutdown.138 * Ramp OUT2 PGA volume to minimise pops at stream startup and shutdown.203 * minimise pop associated with DAPM power switching.204 * It's best to enable Zero Cross when ramping occurs to minimise any
69 * master to slave. We track the last DMA setup in order to minimise
86 * order to minimise this, a signal may be applied to the MASK pin to delay or
94 * order to minimise this, a signal may be applied to the MASK pin to delay or
260 /* pre and post sample - can be used to minimise any analog noise */
19 * equidistant from 0 and INT_MAX we minimise the scope for error:
127 * mobility are placed within the same pageblocks to minimise problems due
887 /* Restore the default value to minimise disruption */ in test_ctl_write_valid()1099 /* Restore the default value to minimise disruption */ in test_ctl_write_invalid()
374 * minimise I/O.
236 period is quite high to minimise overhead but the information collected can be
11 minimise data overhead. Block sizes greater than 4K are supported up to a