Searched full:lives (Results 1 – 25 of 198) sorted by relevance
12345678
39 /* IOC lives in PBUS PIO channel 6 */ in sgihpc_init()44 /* Full House comes with INT2 which lives in PBUS PIO in sgihpc_init()
27 * OCFS1 superblock. Lives at sector 0.78 * OCFS1 volume label. Lives at sector 1.
71 /* describes where the compressed ramdisk image lives (virtual address) */78 /* describes where the compressed ramdisk image lives (physical address) */
8 * for their registers/data areas. The IDPROM lives here too.
2 This UART uses a subset of the PL011 registers and consequently lives
3 * The native Linux system call table lives here also.
14 * This lives in the CLINT driver, but is accessed directly by timex.h to avoid
20 the RTL table version that lives in the Extended
4 lives somewhere in the memory map and specifies the address of the
14 The "timestamper" property lives in a phy node and links a time
21 /* determine whether OFW is available and lives in the proper memory */
21 * x86 has arch-specific MMU state beyond what lives in mm_struct.
33 * so it lives here.
40 * The task's pt_regs lives at the top of the task stack and will be in stackleak_task_high_bound()
18 lives until the final close. During this time, several callbacks from struct
57 Policy which lives shorter time in kernel should be a sub.
39 - The entire superblock up to the checksum field. The UUID lives inside
14 of structures is stored in terms of the block number the structure lives
54 This is common to all CPUs in the system so it lives
34 * make our lives much much simpler. :)
16 This module is intended to try to make the lives of input driver developers
103 /* Note: this hardware lives inside an I2C-based multi-function device. */
257 segment your device lives on doesn't have the proper class bit set and259 * The I2C driver usually detects devices, but your device lives at an
112 * amiga_a4000t_scsi_remove() lives in .exit.text. For drivers registered via