Home
last modified time | relevance | path

Searched +full:gpio1 +full:- +full:polarity +full:- +full:invert (Results 1 – 7 of 7) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Dcirrus,cs35l41.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - david.rhodes@cirrus.com
19 - cirrus,cs35l40
20 - cirrus,cs35l41
28 '#sound-dai-cells':
33 reset-gpios:
36 VA-supply:
39 VP-supply:
[all …]
/freebsd/sys/contrib/device-tree/Bindings/iio/addac/
H A Dadi,ad74115.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schema
[all...]
/freebsd/sys/contrib/device-tree/include/dt-bindings/sound/
H A Dcs35l45.h1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
3 * cs35l45.h -- CS35L45 ALSA SoC audio driver DT bindings header
12 * cirrus,asp-sdout-hiz-ctrl
14 * TX_HIZ_UNUSED: TX pin high-impedance during unused slots.
15 * TX_HIZ_DISABLED: TX pin high-impedance when all channels disabled.
21 * Optional GPIOX Sub-nodes:
22 * The cs35l45 node can have up to three "cirrus,gpio-ctrlX" ('X' = [1,2,3])
23 * sub-nodes for configuring the GPIO pins.
25 * - gpio-dir : GPIO pin direction. Valid only when 'gpio-ctrl'
30 * - gpio-lvl : GPIO level. Valid only when 'gpio-ctrl' is 1 and 'gpio-dir' is 0.
[all …]
/freebsd/sys/contrib/device-tree/src/arm/ti/omap/
H A Domap3-gta04.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
5 * Based on omap3-beagle-xm.dts
7 /dts-v1/;
10 #include <dt-bindings/input/input.h>
17 cpu0-supply = <&vcc>;
27 stdout-pat
[all...]
/freebsd/sys/contrib/device-tree/src/arm64/nvidia/
H A Dtegra210-smaug.dts1 // SPDX-License-Identifier: GPL-2.0
2 /dts-v1/;
4 #include <dt-bindings/input/input.h>
5 #include <dt-bindings/mfd/max77620.h>
6 #include <dt-bindings/pinctrl/pinctrl-tegra.h>
12 compatible = "google,smaug-rev8", "google,smaug-rev
[all...]
/freebsd/sys/dev/qlnx/qlnxe/
H A Dreg_addr.h2 * Copyright (c) 2017-2018 Cavium, Inc.
78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl…
79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea…
80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn…
81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea…
88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of …
90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
116 … (0x1<<9) // Fast back-to-back transaction ena…
128 … (0x1<<23) // Fast back-to-back capable. Not ap…
145 …l has_io_bar=0. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
[all …]
/freebsd/sys/dev/bxe/
H A Dbxe_elink.c1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
4 * Copyright (c) 2007-2017 QLogic Corporation. All rights reserved.
508 /* When this pin is active high during reset, 10GBASE-T core is power
509 * down, When it is active low the 10GBASE-T is power up
774 #define I2C_WA_PWR_ITER (I2C_WA_RETRY_CNT - 1)
936 (_phy)->def_md_devad, \
942 (_phy)->def_md_devad, \
970 * elink_check_lfa - This function checks if link reinitialization is required,
982 struct bxe_softc *sc = params->sc; in elink_check_lfa()
[all …]