| /freebsd/sys/contrib/device-tree/Bindings/hwmon/ |
| H A D | adi,ltc2947.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Nuno Sá <nuno.sa@analog.com>
15 https://www.analog.com/media/en/technical-documentation/data-sheets/LTC2947.pdf
20 - adi,ltc2947
33 adi,accumulator-ctl-pol:
41 $ref: /schemas/types.yaml#/definitions/uint32-array
48 adi,accumulation-deadband-microamp:
55 adi,gpio-out-pol:
[all …]
|
| /freebsd/sys/arm/broadcom/bcm2835/ |
| H A D | bcm2835_firmware.h | 1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
153 uint32_t gpio; member
156 uint32_t gpio; member
163 uint32_t gpio; member
167 uint32_t gpio; member
173 uint32_t gpio; member
176 uint32_t gpio; member
178 uint32_t pol; member
186 uint32_t gpio; member
[all …]
|
| H A D | raspberrypi_gpio.c | 1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
5 * Copyright (c) 2012-2015 Luiz Otavio O Souza <loos@FreeBSD.org>
36 #include <sys/gpio.h>
43 #include <dev/gpio/gpiobusvar.h>
62 #define RPI_FW_GPIO_LOCK(_sc) sx_xlock(&(_sc)->sc_sx)
63 #define RPI_FW_GPIO_UNLOCK(_sc) sx_xunlock(&(_sc)->sc_sx)
66 {"raspberrypi,firmware-gpio", 1},
80 old_cfg.req.gpio = RPI_FW_GPIO_BASE + pin->gp_pin; in rpi_fw_gpio_pin_configure()
83 rv = bcm2835_firmware_property(sc->sc_firmware, in rpi_fw_gpio_pin_configure()
[all …]
|
| /freebsd/sys/contrib/device-tree/Bindings/extcon/ |
| H A D | wlf,arizona.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
20 wlf,hpdet-channel:
30 wlf,use-jd2:
35 wlf,use-jd2-nopull:
40 wlf,jd-invert:
45 wlf,micd-software-compare:
50 wlf,micd-detect-debounce:
[all …]
|
| /freebsd/sys/contrib/device-tree/Bindings/sound/ |
| H A D | cs35l36.txt | 5 - compatible : "cirrus,cs35l36"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VP-supply : power supplies for the device,
13 - cirrus,boost-ctl-millivolt : Boost Voltage Value. Configures the boost
18 - cirrus,boost-pea
[all...] |
| H A D | cirrus,cs35l45.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Ricardo Rivera-Matos <rriveram@opensource.cirrus.com>
11 - Richard Fitzgerald <rf@opensource.cirrus.com>
18 - $ref: dai-common.yaml#
23 - cirrus,cs35l45
31 '#sound-dai-cells':
34 reset-gpios:
37 vdd-a-supply:
[all …]
|
| /freebsd/sys/contrib/device-tree/include/dt-bindings/sound/ |
| H A D | cs35l45.h | 1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
3 * cs35l45.h -- CS35L45 ALSA SoC audio driver DT bindings header
12 * cirrus,asp-sdout-hiz-ctrl
14 * TX_HIZ_UNUSED: TX pin high-impedance during unused slots.
15 * TX_HIZ_DISABLED: TX pin high-impedance when all channels disabled.
21 * Optional GPIOX Sub-nodes:
22 * The cs35l45 node can have up to three "cirrus,gpio-ctrlX" ('X' = [1,2,3])
23 * sub-nodes for configuring the GPIO pins.
25 * - gpio-dir : GPIO pin direction. Valid only when 'gpio-ctrl'
30 * - gpio-lvl : GPIO level. Valid only when 'gpio-ctrl' is 1 and 'gpio-dir' is 0.
[all …]
|
| /freebsd/sys/arm/allwinner/ |
| H A D | a33_codec.c | 1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
39 #include <sys/gpio.h>
47 #include <dev/gpio/gpiobusvar.h>
133 { "allwinner,sun8i-a33-codec", 1},
140 { -1, 0 }
152 #define CODEC_LOCK(sc) mtx_lock(&(sc)->mtx)
153 #define CODEC_UNLOCK(sc) mtx_unlock(&(sc)->mtx)
154 #define CODEC_READ(sc, reg) bus_read_4((sc)->res[0], (reg))
155 #define CODEC_WRITE(sc, reg, val) bus_write_4((sc)->res[0], (reg), (val))
[all …]
|
| /freebsd/sys/contrib/device-tree/Bindings/mfd/ |
| H A D | wlf,arizona.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
17 - $ref: /schemas/spi/spi-peripheral-props.yaml
18 - $ref: /schemas/sound/wlf,arizona.yaml#
19 - $ref: /schemas/regulator/wlf,arizona.yaml#
20 - $ref: /schemas/extcon/wlf,arizona.yaml#
21 - if:
26 - cirrus,cs47l24
[all …]
|
| /freebsd/sys/contrib/device-tree/Bindings/leds/ |
| H A D | leds-bcm6358.txt | 5 which can either be controlled by software (exporting the 74x164 as spi-gpio.
6 See Documentation/devicetree/bindings/gpio/fairchild,74hc595.yaml), or
10 - compatible : should be "brcm,bcm6358-leds".
11 - #address-cells : must be 1.
12 - #size-cells : must be 0.
13 - reg : BCM6358 LED controller address and size.
16 - brcm,clk-div : SCK signal divider. Possible values are 1, 2, 4 and 8.
18 - brcm,clk-dat-low : Boolean, makes clock and data signals active low.
21 Each LED is represented as a sub-node of the brcm,bcm6358-leds device.
23 LED sub-node required properties:
[all …]
|
| /freebsd/sys/contrib/device-tree/src/arm64/qcom/ |
| H A D | msm8994-msft-lumia-octagon.dtsi | 1 // SPDX-License-Identifier: BSD-3-Clause
12 #include <dt-bindings/gpio/gpio.h>
13 #include <dt-bindings/input/gpio-keys.h>
14 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
20 /delete-node/ &adsp_mem;
21 /delete-node/ &audio_mem;
22 /delete-node/ &cont_splash_mem;
23 /delete-node/ &mba_mem;
24 /delete-node/ &mpss_mem;
25 /delete-node/ &peripheral_region;
[all …]
|
| /freebsd/sys/arm/freescale/vybrid/ |
| H A D | vf_dcu4.c | 1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
47 #include <sys/gpio.h>
152 #define DCU_SFT_LCK_POL 0x114 /* Soft Lock POL */
157 #define DCU_CTRLDESCL(n, m) 0x200 + (0x40 * n) + 0x4 * (m - 1)
202 { -1, 0 }
212 if (!ofw_bus_is_compatible(dev, "fsl,mvf600-dcu4")) in dcu_probe()
241 if ((node = ofw_bus_get_node(sc->dev)) == -1) in get_panel_info()
245 if ((len = OF_getproplen(node, "panel-size")) <= 0) in get_panel_info()
247 OF_getencprop(node, "panel-size", dts_value, len); in get_panel_info()
[all …]
|
| /freebsd/sys/contrib/device-tree/src/arm/ti/omap/ |
| H A D | dra7.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2013 Texas Instruments Incorporated - https://www.ti.com/
8 #include <dt-bindings/bus/ti-sysc.h>
9 #include <dt-bindings/clock/dra7.h>
10 #include <dt-bindings/interrupt-controller/arm-gic.h>
11 #include <dt-bindings/pinctrl/dra.h>
12 #include <dt-bindings/clock/dra7.h>
17 #address-cells = <2>;
18 #size-cells = <2>;
21 interrupt-parent = <&crossbar_mpu>;
[all …]
|