| /linux/Documentation/devicetree/bindings/iio/filter/ |
| H A D | adi,admv8818.yaml | 49 Sets the minimum distance between the fundamental frequency of `rf_in`
58 Sets the minimum distance between the fundamental frequency of `rf_in`
|
| /linux/Documentation/PCI/ |
| H A D | pci-error-recovery.rst | 283 soft reset(default) and fundamental(optional) reset.
291 Powerpc fundamental reset is supported by PCIe cards only
296 Optional fundamental reset is provided to support a limited number
341 Drivers for PCIe cards that require a fundamental reset must
346 + /* Set EEH reset type to fundamental if required by hba */
|
| /linux/Documentation/devicetree/bindings/iio/frequency/ |
| H A D | adi,adf4350.yaml | 137 adi,aux-output-fundamental-enable:
140 Selects fundamental VCO output on the auxiliary RF output.
|
| /linux/Documentation/driver-api/surface_aggregator/ |
| H A D | internal.rst | 81 ``RQID``). This layer basically provides a fundamental interface to the SAM
106 Packets are the fundamental transmission unit of the SSH protocol. They are
155 The packet queue is the first of the two fundamental collections in the
168 The pending set is the second of the two fundamental collections in the
359 The request queue is the first of the two fundamental collections in the
374 The pending set is the second of the two fundamental collections in the
|
| /linux/drivers/misc/genwqe/ |
| H A D | card_base.c | 792 * genwqe_pci_fundamental_reset() - trigger a PCIe fundamental reset on the slot
806 * save state and issue PCIe fundamental reset in genwqe_pci_fundamental_reset()
839 /* Try recoverying the card with fundamental reset */ in genwqe_platform_recovery()
862 * Set the appropriate register and call fundamental reset to reaload the card
880 * partition on PCIe hot or fundamental reset in genwqe_reload_bistream()
888 * A fundamental reset failure can be caused in genwqe_reload_bistream()
1026 * If it's supported by the platform, we try a fundamental reset in genwqe_health_thread()
1122 /* EEH recovery requires PCIe fundamental reset */ in genwqe_pci_setup()
|
| /linux/Documentation/userspace-api/media/v4l/ |
| H A D | selections-common.rst | 10 similar, there's one fundamental difference between the two. On
|
| /linux/drivers/cxl/ |
| H A D | Makefile | 4 # - 'core' first for fundamental init
|
| /linux/fs/f2fs/ |
| H A D | Kconfig | 21 addressing the fundamental issues in LFS, which are snowball effect
|
| /linux/Documentation/process/ |
| H A D | 1.Intro.rst | 141 internal interface is a deliberate design decision; it allows fundamental
179 - Contribution of code is the fundamental action which makes the whole
|
| /linux/Documentation/driver-api/thermal/ |
| H A D | cpu-cooling-api.rst | 103 running time dynamic power coefficient in fundamental units of
|
| /linux/drivers/gpu/drm/i915/gt/uc/ |
| H A D | intel_uc.h | 66 * the HW and use them is a fundamental issue (e.g. no memory for our
|
| /linux/Documentation/admin-guide/cgroup-v1/ |
| H A D | pids.rst | 12 place, PIDs are a fundamental resource. As such, PID exhaustion must be
|
| /linux/include/uapi/linux/netfilter/ |
| H A D | x_tables.h | 89 * containing all the fundamental data types that are used in ipt_entry,
|
| /linux/Documentation/scheduler/ |
| H A D | sched-nice-design.rst | 53 But the fundamental HZ-sensitive property for nice+19 still remained,
|
| /linux/Documentation/RCU/ |
| H A D | UP.rst | 47 its arguments would cause it to fail to make the fundamental guarantee
|
| /linux/Documentation/arch/arm/omap/ |
| H A D | omap_pm.rst | 19 - specify PM parameters in terms of fundamental units, such as
|
| /linux/drivers/pci/controller/dwc/ |
| H A D | pcie-designware-ep.c | 802 * dw_pcie_ep_cleanup - Cleanup DWC EP resources after fundamental reset
805 * Cleans up the DWC EP specific resources like eDMA etc... after fundamental
807 * supporting PERST# or any other methods of fundamental reset.
|
| /linux/arch/powerpc/kernel/ |
| H A D | eeh.c | 786 * Each device might have its preferred reset type: fundamental or
825 * the appropriate flags, performing a fundamental or hot reset, and then
840 * Determine the type of reset to perform - hot or fundamental. in eeh_pe_reset_full()
842 * PE requires a fundamental reset. in eeh_pe_reset_full()
1447 * indicated type, either fundamental reset or hot reset.
|
| /linux/arch/powerpc/platforms/powernv/ |
| H A D | eeh-powernv.c | 772 * for fundamental or hot reset during deassert phase. in pnv_eeh_root_reset()
1043 * (usually bus#1), we apply hot or fundamental reset on the root port. in pnv_eeh_reset()
1097 * Fundamental resets need to be handled internally to EEH since the in pnv_eeh_reset()
1098 * PCI core doesn't really have a concept of a fundamental reset, in pnv_eeh_reset()
|
| /linux/Documentation/dev-tools/kunit/ |
| H A D | architecture.rst | 26 The test case is the fundamental unit in KUnit. KUnit test cases are organised
|
| /linux/Documentation/timers/ |
| H A D | hrtimers.rst | 32 timing inaccuracies. Cascading is a fundamental property of the timer
|
| H A D | timekeeping.rst | 50 the clock source, which provides the fundamental timeline for the system.
|
| /linux/Documentation/firmware-guide/acpi/ |
| H A D | osi.rst | 82 But _OS had fundamental problems. First, the BIOS needed to know the name
|
| /linux/Documentation/userspace-api/media/rc/ |
| H A D | rc-tables.rst | 730 It should be noted that, sometimes, there some fundamental missing keys
|
| /linux/Documentation/mm/ |
| H A D | page_owner.rst | 152 fundamental function::
|