Home
last modified time | relevance | path

Searched full:functioning (Results 1 – 25 of 87) sorted by relevance

1234

/linux/drivers/ntb/test/
H A DKconfig7 your ntb hardware and drivers are functioning at a basic level.
18 functioning at a basic level.
/linux/drivers/acpi/acpica/
H A Dnsinit.c548 * Run _STA to determine if this device is present and functioning. We in acpi_ns_init_one_device()
577 * other words, the device is present, ..., and functioning)" in acpi_ns_init_one_device()
584 * Examine the PRESENT and FUNCTIONING status bits in acpi_ns_init_one_device()
587 * not functioning case, so we assume functioning if present. in acpi_ns_init_one_device()
591 /* Device is not present, we must examine the Functioning bit */ in acpi_ns_init_one_device()
595 * Device is not present but is "functioning". In this case, in acpi_ns_init_one_device()
612 * Device is not present and is not functioning. We must abort the in acpi_ns_init_one_device()
/linux/Documentation/ABI/testing/
H A Dsysfs-bus-acpi66 functioning or present, if the method _STA is present.
76 Bit [3] Set if the device is functioning properly (cleared
H A Dsysfs-pps45 The /sys/class/pps/ppsX/mode file reports the functioning
/linux/arch/arm64/boot/dts/rockchip/
H A Drk3588-turing-rk1.dts4 * "compute node" system, where the carrier board is functioning more like a
/linux/Documentation/devicetree/bindings/pci/
H A Dsnps,dw-pcie-ep.yaml33 normal controller functioning. iATU memory IO region is also required
114 There is no mandatory IRQ signals for the normal controller functioning,
/linux/Documentation/devicetree/bindings/soc/fsl/
H A Dguts.txt22 contains a functioning "reset control register" (i.e. the board
/linux/drivers/ras/
H A DKconfig28 be functioning correctly. For example, a server may run forever and
/linux/Documentation/arch/arm/sunxi/
H A Dclocks.rst12 carelessly the system would stop functioning, but with the right
/linux/Documentation/filesystems/
H A Dbfs.rst33 that modprobe is functioning. Beware that umount will not deallocate
/linux/drivers/clk/
H A Dclk-bm1880.c203 * for the functioning of the SoC
217 * Clocks marked as CRITICAL are needed for the proper functioning
368 * Clocks marked as CRITICAL are needed for the proper functioning
395 * Clocks marked as CRITICAL are all needed for the proper functioning
/linux/Documentation/virt/kvm/x86/
H A Dmsr.rst151 data and functioning:
163 data and functioning:
/linux/Documentation/devicetree/bindings/power/
H A Dpower_domain.txt59 functioning of the current device at the current OPP (where this property is
/linux/Documentation/driver-api/memory-devices/
H A Dti-gpmc.rst24 functioning of the peripheral, while peripheral has another set of
/linux/drivers/cpuidle/
H A Dcpuidle-cps.c31 * system to have any hope of functioning. in cps_nc_enter()
/linux/Documentation/devicetree/bindings/pinctrl/
H A Dfsl,mxs-pinctrl.txt34 particular function, like SSP0 functioning as mmc0-8bit. That said, the
/linux/drivers/scsi/aic7xxx/
H A Daiclib.h13 * functioning of this software in any circumstances.
/linux/drivers/scsi/
H A Dimm.h43 * Due to work commitments and inability to get a "true" ECP mode functioning
/linux/Documentation/leds/
H A Dledtrig-transient.rst38 start functioning again.
/linux/tools/testing/selftests/powerpc/eeh/
H A Deeh-functions.sh32 # A functioning PE should have the EEH_STATE_MMIO_ACTIVE and
/linux/Documentation/admin-guide/hw-vuln/
H A Dsrso.rst209 or not functioning properly, showing usually a lot smaller number of
/linux/drivers/power/supply/
H A Dsurface_charger.c203 /* Make sure the device is there and functioning properly. */ in spwr_ac_register()
/linux/Documentation/devicetree/bindings/opp/
H A Dopp-v2-base.yaml200 for the functioning of the current device at the current OPP (where
/linux/Documentation/driver-api/
H A Dpps.rst163 * mode: reports available PPS functioning modes;
/linux/drivers/platform/x86/intel/pmt/
H A Dtelemetry.c86 * Some devices may expose non-functioning entries that are in pmt_telem_header_decode()

1234