Home
last modified time | relevance | path

Searched +full:ddr +full:- +full:sel +full:- +full:low (Results 1 – 15 of 15) sorted by relevance

/linux/drivers/regulator/
H A Dbd9576-regulator.c1 // SPDX-License-Identifier: GPL-2.0
10 #include <linux/mfd/rohm-bd957x.h>
11 #include <linux/mfd/rohm-generic.h>
137 const struct regulator_desc *desc = rdev->desc; in bd957x_vout34_list_voltage()
138 int multiplier = selector & desc->vsel_mask & 0x7f; in bd957x_vout34_list_voltage()
145 return desc->fixed_uV - tune; in bd957x_vout34_list_voltage()
147 return desc->fixed_uV + tune; in bd957x_vout34_list_voltage()
153 const struct regulator_desc *desc = rdev->desc; in bd957x_list_voltage()
154 int index = selector & desc->vsel_mask & 0x7f; in bd957x_list_voltage()
157 index += desc->n_voltages/2; in bd957x_list_voltage()
[all …]
/linux/drivers/mtd/nand/raw/
H A Ddenali.c1 // SPDX-License-Identifier: GPL-2.0
4 * Copyright © 2009-2010, Intel Corporation and its suppliers.
6 * Copyright (c) 2017-2019 Socionext Inc.
12 #include <linux/dma-mapping.h>
23 #define DENALI_NAND_NAME "denali-nand"
31 #define DENALI_MAP10 (2 << 26) /* high-level control plane */
39 #define DENALI_BANK(denali) ((denali)->active_bank << 24)
41 #define DENALI_INVALID_BANK -1
50 return container_of(chip->controller, struct denali_controller, in to_denali_controller()
55 * Direct Addressing - the slave address forms the control information (command
[all …]
/linux/arch/arm64/boot/dts/rockchip/
H A Drk3399-gru.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
5 * Copyright 2016-2017 Google, Inc
8 #include <dt-bindings/input/input.h>
9 #include "rk3399-op1.dtsi"
18 stdout-path = "serial2:115200n8";
27 * - Rails that only connect to the EC (or devices that the EC talks to)
29 * - Rails _are_ included if the rails go to the AP even if the AP
38 * - The EC controls the enable and the EC always enables a rail as
40 * - The rails are actually connected to each other by a jumper and
45 ppvar_sys: regulator-ppvar-sys {
[all …]
/linux/drivers/media/i2c/
H A Dmt9m114.c1 // SPDX-License-Identifier: GPL-2.0-only
5 * Copyright (c) 2020-2023 Laurent Pinchart <laurent.pinchart@ideasonboard.com>
26 #include <media/v4l2-async.h>
27 #include <media/v4l2-cci.h>
28 #include <media/v4l2-ctrls.h>
29 #include <media/v4l2-device.h>
30 #include <media/v4l2-fwnode.h>
31 #include <media/v4l2-mediabus.h>
32 #include <media/v4l2-subdev.h>
75 /* Auto-Exposure Track registers */
[all …]
/linux/arch/arm/boot/dts/ti/omap/
H A Dam437x-gp-evm.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2013 Texas Instruments Incorporated - https://www.ti.com/
8 /dts-v1/;
11 #include <dt-bindings/pinctrl/am43xx.h>
12 #include <dt-bindings/pwm/pwm.h>
13 #include <dt-bindings/gpio/gpio.h>
17 compatible = "ti,am437x-gp-evm","ti,am4372","ti,am43";
24 stdout-path = &uart0;
27 evm_v3_3d: fixedregulator-v3_3d {
28 compatible = "regulator-fixed";
[all …]
/linux/drivers/gpu/drm/radeon/
H A Datombios.h2 * Copyright 2006-2007 Advanced Micro Devices, Inc.
214 UCHAR uaFirmWareSignature[4]; /*Signature to distinguish between Atombios and non-atombios,
397 …ONG ulPointerReturnFlag:1; // BYTE_3[7]=1 - Return the pointer to the right Data Block; BYTE_…
403 …ONG ulPointerReturnFlag:1; // BYTE_3[7]=1 - Return the pointer to the right Data Block; BYTE_…
410 …ULONG ulClock; //When returen, it's the re-calculated clock based on given Fb_div Post_Di…
504 …UCHAR ucInputFlag; //Input Flags. ucInputFlag[0] - Strobe(1)/Performance(0)…
536 #define ATOM_PLL_INPUT_FLAG_PLL_STROBE_MODE_EN 1 // 1-StrobeMode, 0-PerformanceMode
544 …bDiv; //Output:UPPER_WORD=FB_DIV_INTEGER, LOWER_WORD=FB_DIV_FRAC shl (16-FB_FRACTION_BITS)
549 … //Input : ATOM_PLL_INPUT_FLAG_PLL_STROBE_MODE_EN: 1-StrobeMode, 0-PerformanceMode
698 // [3] Transmitter Sel
[all …]
/linux/drivers/gpu/drm/amd/include/
H A Datombios.h2 * Copyright 2006-2007 Advanced Micro Devices, Inc.
107 #define ATOM_SCALER_DISABLE 0 //For Fudo, it's bypass and auto-cengter & no replication
108 #define ATOM_SCALER_CENTER 1 //For Fudo, it's bypass and auto-center & auto replication
110 #define ATOM_SCALER_MULTI_EX 3 //For Fudo only, it's multi-tap mode only used to drive TV or CV,…
222 UCHAR uaFirmWareSignature[4]; //Signature to distinguish between Atombios and non-atombios,
245 UCHAR uaFirmWareSignature[4]; //Signature to distinguish between Atombios and non-atombios,
427 …ONG ulPointerReturnFlag:1; // BYTE_3[7]=1 - Return the pointer to the right Data Block; BYTE_…
433 …ONG ulPointerReturnFlag:1; // BYTE_3[7]=1 - Return the pointer to the right Data Block; BYTE_…
440 …ULONG ulClock; //When returen, it's the re-calculated clock based on given Fb_div Post_Di…
538 …UCHAR ucInputFlag; //Input Flags. ucInputFlag[0] - Strobe(1)/Performance(0)…
[all …]
/linux/drivers/memory/tegra/
H A Dtegra124-emc.c1 // SPDX-License-Identifier: GPL-2.0-only
9 #include <linux/clk-provider.h>
15 #include <linux/interconnect-provider.h>
512 /* protect shared rate-change code path */
521 writel(value, emc->regs + EMC_CCFIFO_DATA); in emc_ccfifo_writel()
522 writel(offset, emc->regs + EMC_CCFIFO_ADDR); in emc_ccfifo_writel()
530 writel(1, emc->regs + EMC_TIMING_CONTROL); in emc_seq_update_timing()
533 value = readl(emc->regs + EMC_STATUS); in emc_seq_update_timing()
539 dev_err(emc->dev, "timing update timed out\n"); in emc_seq_update_timing()
547 writel(0, emc->regs + EMC_AUTO_CAL_INTERVAL); in emc_seq_disable_auto_cal()
[all …]
/linux/arch/arm/boot/dts/nvidia/
H A Dtegra30-apalis-v1.1.dtsi1 // SPDX-License-Identifier: GPL-2.0 OR MIT
16 avdd-pexa-supply = <&vdd2_reg>;
17 avdd-pexb-supply = <&vdd2_reg>;
18 avdd-pex-pll-supply = <&vdd2_reg>;
19 avdd-plle-supply = <&ldo6_reg>;
20 hvdd-pex-supply = <&reg_module_3v3>;
21 vddio-pex-ctl-supply = <&reg_module_3v3>;
22 vdd-pexa-supply = <&vdd2_reg>;
23 vdd-pexb-supply = <&vdd2_reg>;
27 nvidia,num-lanes = <4>;
[all …]
H A Dtegra30-apalis.dtsi1 // SPDX-License-Identifier: GPL-2.0
15 avdd-pexa-supply = <&vdd2_reg>;
16 avdd-pexb-supply = <&vdd2_reg>;
17 avdd-pex-pll-supply = <&vdd2_reg>;
18 avdd-plle-supply = <&ldo6_reg>;
19 hvdd-pex-supply = <&reg_module_3v3>;
20 vddio-pex-ctl-supply = <&reg_module_3v3>;
21 vdd-pexa-supply = <&vdd2_reg>;
22 vdd-pexb-supply = <&vdd2_reg>;
26 nvidia,num-lanes = <4>;
[all …]
H A Dtegra30-lg-x3.dtsi1 // SPDX-License-Identifier: GPL-2.0
3 #include <dt-bindings/input/gpio-keys.h>
4 #include <dt-bindings/input/input.h>
5 #include <dt-bindings/leds/common.h>
6 #include <dt-bindings/mfd/max77620.h>
7 #include <dt-bindings/thermal/thermal.h>
10 #include "tegra30-cpu-opp.dtsi"
11 #include "tegra30-cpu-opp-microvolt.dtsi"
14 chassis-type = "handset";
30 * pre-existing /chosen node to be available to insert the
[all …]
H A Dtegra114-dalmore.dts1 // SPDX-License-Identifier: GPL-2.0
7 /dts-v1/;
9 #include <dt-bindings/input/input.h>
23 stdout-path = "serial0:115200n8";
34 hdmi-supply = <&vdd_5v0_hdmi>;
35 vdd-supply = <&vdd_hdmi_reg>;
36 pll-supply = <&palmas_smps3_reg>;
38 nvidia,ddc-i2c-bus = <&hdmi_ddc>;
39 nvidia,hpd-gpio =
46 avdd-dsi-csi-supply = <&avdd_1v2_reg>;
[all …]
/linux/drivers/gpu/drm/i915/display/
H A Dintel_psr.c52 * Since Haswell Display controller supports Panel Self-Refresh on display
56 * request to DDR memory completely as long as the frame buffer for that
66 * The implementation uses the hardware-based PSR support which automatically
67 * enters/exits self-refresh mode. The hardware takes care of sending the
70 * changes to know when to exit self-refresh mode again. Unfortunately that
75 * issues the self-refresh re-enable code is done from a work queue, which
83 * entry/exit allows the HW to enter a low-power state even when page flipping
99 * EDP_PSR_DEBUG[16]/EDP_PSR_DEBUG_MASK_DISP_REG_WRITE (hsw-skl):
163 * In standby mode (as opposed to link-off) this makes no difference
177 * The rest of the bits are more self-explanatory and/or
[all …]
/linux/arch/arm64/boot/dts/qcom/
H A Dx1e80100.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
6 #include <dt-bindings/clock/qcom,rpmh.h>
7 #include <dt-bindings/clock/qcom,sc8280xp-lpasscc.h>
8 #include <dt-bindings/clock/qcom,x1e80100-dispcc.h>
9 #include <dt-bindings/clock/qcom,x1e80100-gcc.h>
10 #include <dt-bindings/clock/qcom,x1e80100-gpucc.h>
11 #include <dt-bindings/clock/qcom,x1e80100-tcsr.h>
12 #include <dt-bindings/dma/qcom-gpi.h>
13 #include <dt-bindings/interconnect/qcom,icc.h>
14 #include <dt-bindings/interconnect/qcom,x1e80100-rpmh.h>
[all …]
/linux/drivers/mmc/host/
H A Dmtk-sd.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (c) 2014-2015, 2022 MediaTek Inc.
11 #include <linux/dma-mapping.h>
33 #include <linux/mmc/slot-gpio.h>
41 /*--------------------------------------------------------------------------*/
43 /*--------------------------------------------------------------------------*/
50 /*--------------------------------------------------------------------------*/
52 /*--------------------------------------------------------------------------*/
90 /*--------------------------------------------------------------------------*/
92 /*--------------------------------------------------------------------------*/
[all …]