/linux/drivers/net/ethernet/mellanox/mlxsw/ |
H A D | Kconfig | 55 tristate "Mellanox Technologies Spectrum family support" 71 Spectrum/Spectrum-2/Spectrum-3/Spectrum-4 Ethernet Switch ASICs.
|
H A D | spectrum_acl_bloom_filter.c | 10 #include "spectrum.h" 20 * blocks, eRP ID and region ID. In Spectrum-2 and above, region key is combined 31 /* Spectrum-2 and Spectrum-3 chunks */ 57 * Spectrum-{2-3}. It is computed, Msbit first, for the Bloom filter 96 /* Spectrum-4 chunks */ 99 /* In Spectrum-4, there is no padding. Each chunk size is 20 bytes. 122 /* For Spectrum-4, two hash functions are used, CRC-10 and CRC-6 based. 129 * Spectrum-4. It is computed, Msbit first, for the Bloom filter 168 * Spectrum-4. It is computed, Msbit first, for the Bloom filter 208 * key. The original keys layout is same for Spectrum-{2,3,4}. [all …]
|
H A D | spectrum_nve.h | 10 #include "spectrum.h" 33 u16 ul_rif_index; /* Reserved for Spectrum */
|
H A D | cmd.h | 353 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1 366 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1 724 * Reserved when Spectrum-1/2/3, supported from Spectrum-4 and above. 725 * For Spectrum-4, firmware sets 128 for values between 1-128 and 256 for values 790 * Supported only by Spectrum-2+. 876 * Supported from Spectrum-2 and above. 883 * Valid for Spectrum only 890 * Valid for Spectrum only 899 * Valid for Spectrum only 938 * Reserved when SwitchX/-2, Switch-IB/2 and Spectrum-1. [all …]
|
H A D | spectrum_mr_tcam.h | 7 #include "spectrum.h"
|
H A D | spectrum_acl_flex_actions.h | 7 #include "spectrum.h"
|
H A D | spectrum_cnt.h | 8 #include "spectrum.h"
|
/linux/Documentation/devicetree/bindings/clock/ti/ |
H A D | dpll.txt | 43 "ssc-deltam" - DPLL supports spread spectrum clocking (SSC), contains 45 "ssc-modfreq" - DPLL supports spread spectrum clocking (SSC), contains 59 - ti,ssc-deltam : DPLL supports spread spectrum clocking, frequency 61 - ti,ssc-modfreq-hz : DPLL supports spread spectrum clocking, spread 62 spectrum modulation frequency 63 - ti,ssc-downspread : DPLL supports spread spectrum clocking, boolean
|
/linux/Documentation/devicetree/bindings/clock/ |
H A D | ti,cdce925.yaml | 58 spectrum clocking parameters for a board 63 spread-spectrum: 67 spread-spectrum-center: 99 spread-spectrum = <4>; 100 spread-spectrum-center;
|
H A D | mediatek,mt8186-fhctl.yaml | 7 title: MediaTek frequency hopping and spread spectrum clocking control 15 Spread spectrum clocking (SSC) is another function provided by this hardware. 35 description: The percentage of spread spectrum clocking for one PLL.
|
/linux/drivers/media/dvb-frontends/ |
H A D | cxd2820r.h | 35 * @spec_inv: Input spectrum inverted. 60 * @spec_inv: Spectrum inversion. Default: 0. Values: 0, 1. 89 /* Spectrum inversion.
|
H A D | m88ds3103.h | 54 * @spec_inv: Input spectrum inversion. 99 * @spec_inv: Spectrum inversion. Default: 0.
|
/linux/Documentation/ABI/testing/ |
H A D | sysfs-platform-dptf | 134 (RO) Presents SSC (spread spectrum clock) information for EMI 140 [7:0] Sets clock spectrum spread percentage: 147 spectrum clock 153 (Spread spectrum clock) range
|
/linux/tools/testing/selftests/drivers/net/mlxsw/spectrum/ |
H A D | q_in_vni_veto.sh | 48 check_fail $? "802.1ad bridge with VxLAN in Spectrum-1 not rejected" 52 check_err $? "802.1ad bridge with VxLAN in Spectrum-1 rejected without extack"
|
/linux/tools/testing/selftests/drivers/net/mlxsw/ |
H A D | mlxsw_lib.sh | 21 echo "Couldn't determine Spectrum chip revision." \ 45 log_test_xfail $src:$caller "(Spectrum-$rev only)"
|
/linux/Documentation/virt/hyperv/ |
H A D | coco.rst | 49 points on a spectrum spanning the degree of guest enlightenment needed to run 50 as a CoCo VM. Fully-enlightened mode is one end of the spectrum. A full 51 implementation of paravisor mode is the other end of the spectrum, where all 55 does not go this far, and is somewhere in the middle of the spectrum. Some 67 guest enlightenments required" end of the spectrum.
|
/linux/Documentation/driver-api/thermal/ |
H A D | intel_dptf.rst | 244 which is compensated by adjusting Spread spectrum percent. This helps 271 Set the FIVR spread spectrum clocking percentage 274 Enable/disable of the FIVR spread spectrum clocking feature 339 Sets DLVR spread spectrum percent value. 342 Specifies how frequencies are spread using spread spectrum.
|
/linux/Documentation/misc-devices/ |
H A D | apds990x.rst | 26 might vary quite much depending the spectrum of the light source. 69 on the light spectrum etc.
|
/linux/Documentation/devicetree/bindings/ata/ |
H A D | imx-sata.yaml | 60 fsl,no-spread-spectrum: 62 description: if present, disable spread-spectrum clocking on the SATA link.
|
/linux/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
H A D | smu11_driver_if_sienna_cichlid.h | 906 // SECTION: Clock Spread Spectrum 908 // GFXCLK PLL Spread Spectrum 913 // GFXCLK DFLL Spread Spectrum 918 // UCLK Spread Spectrum 922 // FCLK Spread Spectrum 949 // UCLK Spread Spectrum 1267 // SECTION: Clock Spread Spectrum 1269 // GFXCLK PLL Spread Spectrum 1274 // GFXCLK DFLL Spread Spectrum 1279 // UCLK Spread Spectrum [all …]
|
/linux/sound/soc/codecs/ |
H A D | tda7419.c | 451 SOC_ENUM("Spectrum Analyzer Q Factor", soc_enum_sa_q_factor), 452 SOC_ENUM("Spectrum Analyzer Reset Mode", soc_enum_reset_mode), 453 SOC_ENUM("Spectrum Analyzer Source", soc_enum_sa_src), 454 SOC_SINGLE("Spectrum Analyzer Run Switch", TDA7419_SA_CLK_AC_REG, 456 SOC_SINGLE("Spectrum Analyzer Reset Switch", TDA7419_SA_CLK_AC_REG,
|
/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dce120/ |
H A D | dce120_clk_mgr.c | 48 * dce121_clock_patch_xgmi_ss_info() - Save XGMI spread spectrum info 51 * Reads from VBIOS the XGMI spread spectrum info and saves it within
|
/linux/drivers/phy/rockchip/ |
H A D | phy-rockchip-naneng-combphy.c | 448 /* Set SSC downward spread spectrum */ in rk3528_combphy_cfg() 594 /* Set SSC downward spread spectrum */ in rk3562_combphy_cfg() 604 /* Set SSC downward spread spectrum */ in rk3562_combphy_cfg() 745 /* Set SSC downward spread spectrum. */ in rk3568_combphy_cfg() 757 /* Set SSC downward spread spectrum. */ in rk3568_combphy_cfg() 871 /* downward spread spectrum +500ppm */ in rk3568_combphy_cfg() 962 /* Set SSC downward spread spectrum */ in rk3576_combphy_cfg() 973 /* Set SSC downward spread spectrum */ in rk3576_combphy_cfg() 1100 /* downward spread spectrum +500ppm */ in rk3576_combphy_cfg() 1245 /* Set SSC downward spread spectrum */ in rk3588_combphy_cfg() [all …]
|
/linux/drivers/phy/starfive/ |
H A D | phy-jh7110-pcie.c | 65 /* Configuare spread-spectrum mode: down-spread-spectrum */ in phy_usb3_mode_set()
|
/linux/drivers/clk/ |
H A D | clk-renesas-pcie.c | 230 /* Output clock spread spectrum */ in rs9_get_common_config() 231 ret = of_property_read_u32(np, "renesas,out-spread-spectrum", &ssc); in rs9_get_common_config() 241 "Invalid renesas,out-spread-spectrum value\n"); in rs9_get_common_config()
|