Searched full:lfps (Results 1 – 10 of 10) sorted by relevance
62 description: A phandle to the tx lfps swing trim data provided by71 This adjusts the signal amplitude for normal operation and beacon LFPS.82 This adjusts the signal amplitude for normal operation and beacon LFPS.
47 * PORT_ALPM_LFPS_CTL[ LFPS Cycle Count ] = 1048 * LFPS Period chosen is the mid-point of the min:max values from the table49 * FLOOR( LFPS Period in Symbol clocks /50 * (2 * PORT_ALPM_LFPS_CTL[ LFPS Cycle Count ]) )
913 * time required for decoding the received LFPS as an LFPS.U1_Exit.918 * phytxelecidle deassertion when LFPS.U1_Exit931 /* LFPS_GEN_PING value This parameter configures the LFPS.Ping generation */
2949 * Driver needs to modify LFPS minimal U1 Exit time for DEV_VER_TI_V1 in cdns3_gadget_config()
1110 * @u2exit_lfps_quirk: set if we enable u2exit lfps quirk1115 * @lfps_filter_quirk: set if we enable LFPS filter quirk1116 * @rx_detect_poll_quirk: set if we enable rx_detect to polling lfps quirk
1521 /* LFPS RX VIH shmoo hole */1605 /* Gen2 U1 exit LFPS duration : 900ns ~ 1.2us */
1392 * detecting LFPS timeout may be controlled by an in xhci_hub_control()1396 * compliance mode the next time LFPS timeout is in xhci_hub_control()
1161 * USB 3 devices resend U3 LFPS wake after a 100ms delay if in xhci_resume()
270 * First, the device sends an LFPS to transition the link between the in usb_set_lpm_pel()280 * When the hub starts to receive the LFPS, there is a slight delay for in usb_set_lpm_pel()281 * it to figure out that one of the ports is sending an LFPS. Then it in usb_set_lpm_pel()282 * will forward the LFPS to its upstream link. The exit latency is the in usb_set_lpm_pel()
2269 * AB errata. Errata 11. Workaround for Default Duration of LFPS in usb_reinit_338x()