| /linux/drivers/soc/qcom/ |
| H A D | smem.c | 144 * @host0: first processor/host with access to this partition
153 __le16 host0; member
180 * @host0: first processor/host with access to this partition
191 __le16 host0; member
456 le16_to_cpu(phdr->host0), le16_to_cpu(phdr->host1)); in qcom_smem_alloc_private()
667 le16_to_cpu(phdr->host0), le16_to_cpu(phdr->host1)); in qcom_smem_get_private()
909 struct smem_ptable_entry *entry, u16 host0, u16 host1) in qcom_smem_partition_header() argument
926 if (host0 != le16_to_cpu(header->host0)) { in qcom_smem_partition_header()
927 dev_err(smem->dev, "bad host0 (%hu != %hu)\n", in qcom_smem_partition_header()
928 host0, le16_to_cpu(header->host0)); in qcom_smem_partition_header()
[all …]
|
| H A D | smsm.c | 35 * entry0: [host0 ... hostN]
38 * entryM: [host0 ... hostN]
|
| /linux/arch/arm/boot/dts/aspeed/ |
| H A D | aspeed-bmc-ampere-mtjade.dts | 775 /*A0-A7*/ "","","","host0-special-boot","","","","",
783 /*G0-G7*/ "host0-ready","host0-shd-req-n","host0-shd-ack-n",
789 "host0-reboot-ack-n","","","","",
791 /*L0-L7*/ "","","","host0-sysreset-n","s0-spi-auth-fail-n","","","",
|
| H A D | aspeed-bmc-ampere-mtmitchell.dts | 989 /*B0-B7*/ "","","","","host0-sysreset-n","host0-pmin-n","","",
1015 "s1-ddr-save","spi-nor-access","host0-ready","presence-cpu1",
1019 "host0-reboot-ack-n","s0-fw-boot-ok","host0-shd-req-n",
1020 "host0-shd-ack-n","s0-overtemp-n",
1026 /*Y0-Y7*/ "","","","","","","","host0-special-boot",
|
| H A D | aspeed-bmc-ufispace-ncplite.dts | 343 /*F0-F7*/ "CPU_PWRGD","","","power-button","host0-ready","","presence-ps0","presence-ps1",
|
| H A D | aspeed-bmc-facebook-minerva.dts | 616 /*S0-S7*/ "","","","","","","","host0-ready",
|
| H A D | aspeed-bmc-facebook-harma.dts | 655 "host0-ready","reset-control-smb-e1s-0",
|
| /linux/arch/arm/boot/dts/rockchip/ |
| H A D | rk3288-phycore-rdk.dts | 38 vcc_host0_5v: usb-host0-regulator {
207 host0_vbus_drv: host0-vbus-drv {
|
| H A D | rk3288-evb.dtsi | 131 /* This turns on USB vbus for both host0 (ehci) and host1 (dwc2) */
|
| /linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3588-tiger-haikou.dts | 287 /* host0 on Q7_USB_P2, upper usb3 port */
292 /* host0 on Q7_USB_P2, upper usb3 port */
|
| H A D | rk3399-nanopc-t4.dts | 27 vcc5v0_host0: vcc5v0-host0 {
|
| H A D | rk3399-roc-pc-plus.dts | 15 * 3. vcc5v0_host is actually 2 regulators (host0, 1) controlled by the same gpio.
|
| H A D | rk3588-jaguar.dts | 848 /* host0 on P10 USB-A */
853 /* host0 on P10 USB-A */
|
| H A D | rk3399-roc-pc.dtsi | 177 /* Actually 3 regulators (host0, 1, 2) controlled by the same gpio */
|
| H A D | rk3399-khadas-edge.dtsi | 68 /* Actually 3 regulators (host0, 1, 2) controlled by the same gpio */
|
| H A D | rk3566-pinetab2.dtsi | 191 vcc5v0_usb_host0: vcc5v0-usb-host0-regulator {
|
| H A D | rk3588-friendlyelec-cm3588-nas.dts | 678 /* CM3588 USB Controller Config Table: USB20 HOST0 */
|
| H A D | rk3399-firefly.dts | 213 /* Actually 3 regulators (host0, 1, 2) controlled by the same gpio */
|
| /linux/Documentation/devicetree/bindings/phy/ |
| H A D | marvell,armada-cp110-utmi-phy.yaml | 18 0.H----- USB HOST0
|
| /linux/drivers/gpu/drm/nouveau/nvkm/engine/fifo/ |
| H A D | gm107.c | 75 { 0x07, "HOST0" },
|
| H A D | gp100.c | 61 { 0x06, "HOST0" },
|
| H A D | tu102.c | 106 { 0x20, "HOST0" },
|
| H A D | gv100.c | 414 { 0x20, "HOST0" },
|
| /linux/tools/usb/usbip/ |
| H A D | README | 234 /sys/class/scsi_host/host0/device
|
| /linux/Documentation/devicetree/bindings/usb/ |
| H A D | mediatek,mtu3.yaml | 289 host0: usb@11270000 {
|