Home
last modified time | relevance | path

Searched full:drdy (Results 1 – 25 of 43) sorted by relevance

12

/freebsd/sys/contrib/device-tree/Bindings/iio/
H A Dst,st-sensors.yaml99 description: interrupt line(s) connected to the DRDY line(s) and/or the
101 three interrupts, and the DRDY must be the first one if it exists on
111 st,drdy-int-pin:
137 st,drdy-int-pin: false
144 # These have only DRDY
162 st,drdy-int-pin: false
180 st,drdy-int-pin = <1>;
194 st,drdy-int-pin = <2>;
H A Dst-sensors.txt16 - st,drdy-int-pin: the pin on the package that will be used to signal
/freebsd/sys/contrib/device-tree/Bindings/iio/accel/
H A Dadi,adxl355.yaml31 Type for DRDY should be IRQ_TYPE_EDGE_RISING.
40 - DRDY
73 interrupt-names = "DRDY";
89 interrupt-names = "DRDY";
/freebsd/sys/contrib/device-tree/src/arm/st/
H A Dste-href-tvk1281618-r2.dtsi89 st,drdy-int-pin = <1>;
99 * cannot set its DRDY line to open drain, so it cannot be
120 * cannot set its DRDY line to open drain, so it cannot be
132 st,drdy-int-pin = <1>;
157 * cannot set its DRDY line to open drain, so it cannot be
169 st,drdy-int-pin = <2>;
271 /* GPIO 32 used for DRDY, pull this down */
H A Dste-snowball.dts354 st,drdy-int-pin = <1>;
373 interrupts = <5 IRQ_TYPE_EDGE_RISING>; /* DRDY line */
378 st,drdy-int-pin = <2>;
385 interrupts = <6 IRQ_TYPE_EDGE_RISING>, /* DRDY line */
605 "GPIO166_A22", /* DRDY */
H A Dste-href-tvk1281618-r3.dtsi83 st,drdy-int-pin = <1>;
197 /* GPIO 32 used for DRDY, pull this down */
H A Dste-href-stuib.dtsi80 st,drdy-int-pin = <1>;
H A Dstm32f429-disco.dts185 st,drdy-int-pin = <2>;
/freebsd/sys/contrib/device-tree/Bindings/iio/magnetometer/
H A Dak8974.txt16 - interrupts: data ready (DRDY) and interrupt (INT1) lines
17 from the chip, the DRDY interrupt must be placed first.
H A Dasahi-kasei,ak8974.yaml25 Data ready (DRDY) and interrupt (INT1) lines from the chip. The DRDY
H A Dasahi-kasei,ak8975.yaml35 AK8975 has a "Data ready" pin (DRDY) which informs that data
41 description: interrupt for DRDY pin. Triggered on rising edge.
H A Dhmc5843.txt14 - gpios : should be device tree identifier of the magnetometer DRDY pin
H A Dpni,rm3100.txt10 - interrupts: data ready (DRDY) from the chip.
H A Dak8975.txt10 - gpios : should be device tree identifier of the magnetometer DRDY pin
/freebsd/sys/contrib/device-tree/src/arm64/allwinner/
H A Dsun50i-a64-pinephone-1.2.dts40 * Board revision 1.2 fixed routing of the interrupt to DRDY pin,
/freebsd/sys/contrib/device-tree/Bindings/iio/imu/
H A Dst_lsm6dsx.txt22 - st,drdy-int-pin: the pin on the package that will be used to signal
H A Dst,lsm6dsx.yaml68 st,drdy-int-pin:
/freebsd/sys/contrib/device-tree/src/arm/ti/omap/
H A Dam335x-sancloud-bbe.dts38 st,drdy-int-pin = <1>;
/freebsd/sys/contrib/device-tree/src/arm64/qcom/
H A Dmsm8916-samsung-gt5-common.dtsi89 st,drdy-int-pin = <1>;
/freebsd/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mm-venice-gw71xx.dtsi96 st,drdy-int-pin = <1>;
H A Dimx8mm-venice-gw72xx.dtsi125 st,drdy-int-pin = <1>;
H A Dimx8mm-venice-gw73xx.dtsi145 st,drdy-int-pin = <1>;
/freebsd/sys/dev/ic/
H A Dnec765.h82 #define NE7_ST3BITS "\020\010fault\007write_protect\006drdy\005tk0\004two_side\003side_sel\002"
/freebsd/usr.sbin/bhyve/amd64/
H A Dpci_gvt-d-opregion.h64 uint32_t drdy; ///< Offset 0x100 Driver Readiness member
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6qdl-gw5912.dtsi307 st,drdy-int-pin = <1>;

12