/linux/drivers/pci/pcie/ |
H A D | dpc.c | 9 #define dev_fmt(fmt) "DPC: " fmt 96 * pci_dpc_recovered - whether DPC triggered and has recovered successfully 99 * Return true if DPC was triggered for @pdev and has recovered successfully. 101 * driver to recognize and ignore Link Down/Up events caused by DPC. 111 * Synchronization between hotplug and DPC is not supported in pci_dpc_recovered() 112 * if DPC is owned by firmware and EDR is not enabled. in pci_dpc_recovered() 119 * Need a timeout in case DPC never completes due to failure of in pci_dpc_recovered() 121 * but reports indicate that DPC completes within 4 seconds. in pci_dpc_recovered() 156 * DPC disables the Link automatically in hardware, so it has in dpc_reset_link() 162 * Wait until the Link is inactive, then clear DPC Trigger Status in dpc_reset_link() [all …]
|
H A D | portdrv.c | 53 * Fill in *pme, *aer, *dpc with the relevant Interrupt Message Numbers if 58 u32 *pme, u32 *aer, u32 *dpc) in pcie_message_numbers() argument 96 *dpc = FIELD_GET(PCI_EXP_DPC_IRQ, reg16); in pcie_message_numbers() 97 nvec = max(nvec, *dpc + 1); in pcie_message_numbers() 116 u32 pme = 0, aer = 0, dpc = 0; in pcie_port_enable_irq_vec() local 125 nvec = pcie_message_numbers(dev, mask, &pme, &aer, &dpc); in pcie_port_enable_irq_vec() 164 irqs[PCIE_PORT_SERVICE_DPC_SHIFT] = pci_irq_vector(dev, dpc); in pcie_port_enable_irq_vec() 260 * With dpc-native, allow Linux to use DPC even if it doesn't have in get_port_device_capability() 614 * If the user specified "pcie_ports=dpc-native", use the Linux DPC PCIe 625 else if (!strncmp(str, "dpc-native", 10)) in pcie_port_setup()
|
/linux/drivers/staging/media/deprecated/atmel/ |
H A D | atmel-isc-regs.h | 94 /* ISC DPC Control Register */ 101 /* ISC DPC Config Register */ 122 /* ISC DPC Threshold Median Register */ 125 /* ISC DPC Threshold Closest Register */ 128 /* ISC DPC Threshold Average Register */ 131 /* ISC DPC STatus Register */
|
H A D | atmel-isc.h | 238 * specific DPC module
|
/linux/drivers/media/platform/microchip/ |
H A D | microchip-isc-regs.h | 94 /* ISC DPC Control Register */ 101 /* ISC DPC Config Register */ 122 /* ISC DPC Threshold Median Register */ 125 /* ISC DPC Threshold Closest Register */ 128 /* ISC DPC Threshold Average Register */ 131 /* ISC DPC STatus Register */
|
H A D | microchip-sama7g5-isc.c | 9 * Sensor-->PFE-->DPC-->WB-->CFA-->CC-->GAM-->VHXS-->CSC-->CBHS-->SUB-->RLP-->DMA-->HIS 13 * DPC: Defective Pixel Correction with black offset correction, green disparity
|
H A D | microchip-isc.h | 249 * specific DPC module
|
/linux/Documentation/devicetree/bindings/iio/dac/ |
H A D | adi,ad5758.yaml | 26 Dynamic Power Control (DPC) 40 * 1: DPC current mode 41 * 2: DPC voltage mode
|
/linux/drivers/gpu/drm/i915/display/ |
H A D | intel_gmbus.c | 82 [GMBUS_PIN_DPC] = { "dpc", GPIOD }, 89 [GMBUS_PIN_DPC] = { "dpc", GPIOD }, 95 [GMBUS_PIN_DPC] = { "dpc", GPIOD }, 102 [GMBUS_PIN_2_BXT] = { "dpc", GPIOC }, 108 [GMBUS_PIN_2_BXT] = { "dpc", GPIOC }, 116 [GMBUS_PIN_3_BXT] = { "dpc", GPIOD }, 128 [GMBUS_PIN_3_BXT] = { "dpc", GPIOD }, 135 [GMBUS_PIN_3_BXT] = { "dpc", GPIOD }, 143 [GMBUS_PIN_3_BXT] = { "dpc", GPIOD },
|
/linux/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ |
H A D | mac80211_if.h | 80 struct tasklet_struct tasklet; /* dpc tasklet */ 81 bool resched; /* dpc needs to be and is rescheduled */
|
/linux/drivers/scsi/aacraid/ |
H A D | dpcsup.c | 16 * Abstract: All DPC processing routines for the cyclone board occur here. 33 * This DPC routine will be run when the adapter interrupts us to let us 152 * This DPC routine will be queued when the adapter interrupts us to 266 * This DPC routine will be run when the adapter interrupts us to let us
|
/linux/Documentation/fb/ |
H A D | pxafb.rst | 70 dpc:DPC
|
/linux/drivers/usb/storage/ |
H A D | Kconfig | 129 tristate "Olympus MAUSB-10/Fuji DPC-R1 support" 132 and Fujifilm DPC-R1 USB Card reader/writer devices.
|
H A D | unusual_alauda.h | 11 "DPC-R1 (Alauda)",
|
/linux/include/uapi/linux/media/raspberrypi/ |
H A D | pisp_be_config.h | 120 * struct pisp_be_dpc_config - PiSP Back End DPC config 127 * @flags: DPC configuration flags 729 * @dpc: Defective Pixel Correction configuration 790 struct pisp_be_dpc_config dpc; member
|
/linux/drivers/usb/typec/tipd/ |
H A D | trace.h | 195 { TPS25750_POWER_STATUS_CHARGER_DET_STATUS_DIV_3_DCP, "divider 3 dpc"}, \ 196 { TPS25750_POWER_STATUS_CHARGER_DET_STATUS_1_2V_DCP, "1.2V dpc"})
|
/linux/drivers/net/ethernet/aquantia/atlantic/hw_atl/ |
H A D | hw_atl_utils.c | 641 pmbox->stats.dpc = atomic_read(&self->dpc); in hw_atl_utils_mpi_read_stats() 643 pmbox->stats.dpc = hw_atl_rpb_rx_dma_drop_pkt_cnt_get(self); in hw_atl_utils_mpi_read_stats() 902 AQ_SDELTA(dpc); in hw_atl_utils_update_stats()
|
/linux/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
H A D | sdio.h | 149 * @BRCMF_SDIOD_DOWN: Device can be accessed, no DPC. 150 * @BRCMF_SDIOD_DATA: Ready for data transfers, DPC enabled.
|
/linux/drivers/media/i2c/ |
H A D | ov2680.c | 243 * DPC CTRL0 0x14 -> 0x3e, set enable_tail, enable_3x3_cluster 248 /* DPC MORE CONNECTION CASE THRE 0x0c (12) -> 0x02 (2) */ 251 /* DPC GAIN LIST1 0x0f (15) -> 0x08 (8) */ 254 /* DPC GAIN LIST2 0x3f (63) -> 0x0c (12) */ 257 /* DPC THRE RATIO 0x04 (4) -> 0x00 (0) */
|
/linux/drivers/char/mwave/ |
H A D | mwavedd.h | 137 …unsigned long ulIPCSource_DPC; /* IPC source bits for recently processed intr, set during DPC proc…
|
/linux/include/uapi/linux/ |
H A D | pci_regs.h | 1059 #define PCI_EXP_DPC_CAP 0x04 /* DPC Capability */ 1067 #define PCI_EXP_DPC_CTL 0x06 /* DPC control */ 1070 #define PCI_EXP_DPC_CTL_INT_EN 0x0008 /* DPC Interrupt Enable */ 1072 #define PCI_EXP_DPC_STATUS 0x08 /* DPC Status */ 1083 #define PCI_EXP_DPC_STATUS_TRIGGER_RSN_SW_TRIGGER 0x0020 /* DPC SW Trigger bit */ 1086 #define PCI_EXP_DPC_SOURCE_ID 0x0A /* DPC Source Identifier */
|
/linux/drivers/staging/media/atomisp/pci/runtime/binary/src/ |
H A D | binary.c | 195 Currently, when DPC&BNR is processed between bayer scaling and in ia_css_binary_compute_shading_table_bayer_origin() 196 shading correction, DPC&BNR moves each color plane to in ia_css_binary_compute_shading_table_bayer_origin() 1213 if (!candidate->enable.dpc && need_dpc) { in ia_css_binary_find() 1215 __LINE__, candidate->enable.dpc, descr->enable_dpc); in ia_css_binary_find()
|
/linux/drivers/staging/media/ipu3/ |
H A D | ipu3-abi.h | 778 /*'effective-stripes' - after input cropping used dpc, bds */ 1296 u8 dpc[240832] __aligned(32); member 1648 struct imgu_abi_binary_dpc_info dpc_bnr; /* DPC related binary info */ 1718 u8 dpc; member
|
/linux/drivers/gpu/drm/xe/ |
H A D | xe_irq.c | 442 * We might be in irq handler just when PCIe DPC is initiated in dg1_irq_handler() 448 "Ignore this IRQ as device might be in DPC containment.\n"); in dg1_irq_handler()
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | fsl-ls1088a-ten64.dts | 327 label = "dpc";
|