Home
last modified time | relevance | path

Searched full:configures (Results 1 – 25 of 357) sorted by relevance

12345678910>>...15

/freebsd/sys/contrib/device-tree/Bindings/misc/
H A Dxlnx,sd-fec.txt29 configures the DIN_WORDS to be block based, while a value of 2 configures the
31 - xlnx,sdfec-din-width : Configures the DIN AXI stream where a value of 1
32 configures a width of "1x128b", 2 a width of "2x128b" and 4 configures a width
36 configures the DOUT_WORDS to be block based, while a value of 2 configures the
38 - xlnx,sdfec-dout-width : Configures the DOUT AXI stream where a value of 1
39 configures a width of "1x128b", 2 a width of "2x128b" and 4 configures a width
H A Dxlnx,sd-fec.yaml77 Configures the DIN AXI stream where a value of 1
78 configures a width of "1x128b", 2 a width of "2x128b" and 4 configures a width
87 configures the DIN_WORDS to be block based, while a value of 2 configures the
94 Configures the DOUT AXI stream where a value of 1 configures a width of "1x128b",
95 2 a width of "2x128b" and 4 configures a width of "4x128b".
103 configures the DOUT_WORDS to be block based, while a value of 2 configures the
/freebsd/sys/contrib/device-tree/Bindings/sound/
H A Dcs35l36.txt13 - cirrus,boost-ctl-millivolt : Boost Voltage Value. Configures the boost
19 Configures the peak current by monitoring the current through the boost FET.
74 Configures the signal threshold at which the PWM output stage enters
78 Configures the threshold at which the overtemperature warning condition occurs.
102 - cirrus,vpbr-en : VBST brownout prevention enable. Configures whether the
110 - cirrus,vpbr-thld : Initial VPBR threshold. Configures the VP brownout
113 - cirrus,cirrus,vpbr-atk-rate : Attenuation attack step rate. Configures the
117 - cirrus,vpbr-atk-vol : VP brownout prevention step size. Configures the VP
124 - cirrus,vpbr-wait : Configures the delay time between a brownout condition
128 - cirrus,vpbr-rel-rate : Attenuation release step rate. Configures th
[all...]
H A Drealtek,rt5677.yaml57 Array of six 8bit elements that configures GPIO.
74 description: Configures GPIO Mic Jack detection 1.
83 description: Configures GPIO Mic Jack detection 2.
92 description: Configures GPIO Mic Jack detection 3.
H A Drt5677.txt32 Array of six 8bit elements that configures GPIO.
38 Configures GPIO Mic Jack detection 1.
43 Configures GPIO Mic Jack detection 2 and 3.
H A Dcirrus,cs35l41.yaml45 Configures the peak current by monitoring the current through the boost FET.
83 Configures the type of Boost being used.
117 Configures the function of the GPIO1 pin.
142 Configures the function of the GPIO2 pin.
H A Ddavinci-mcasp-audio.yaml82 configures WFIFO threshold
89 configures RFIFO threshold
/freebsd/crypto/openssl/doc/man3/
H A DSSL_CTX_set_domain_flags.pod41 Specifying this flag configures the Single-Threaded Concurrency Model (SCM).
45 Speciyfing this flag configures the Contentive Concurrency Model (CCM) (unless
53 Specifying this flag configures the Thread-Assisted Concurrency Model (TACM).
/freebsd/sys/contrib/dev/iwlwifi/fw/
H A Dfile.h612 * struct iwl_fw_dbg_mem_seg_tlv - configures the debug data memory segments
627 * struct iwl_fw_dbg_dest_tlv_v1 - configures the destination of the debug data
766 * struct iwl_fw_dbg_trigger_missed_bcon - configures trigger for missed beacons
784 * struct iwl_fw_dbg_trigger_cmd - configures trigger for messages from FW.
795 * struct iwl_fw_dbg_trigger_stats - configures trigger for statistics
817 * struct iwl_fw_dbg_trigger_mlme - configures trigger for mlme events
856 * struct iwl_fw_dbg_trigger_txq_timer - configures the Tx queue's timer
879 * struct iwl_fw_dbg_trigger_time_event - configures a time event trigger
895 * struct iwl_fw_dbg_trigger_ba - configures BlockAck related trigger
922 * struct iwl_fw_dbg_trigger_tdls - configures trigge
[all...]
/freebsd/sys/contrib/device-tree/Bindings/hwmon/
H A Dadt7475.yaml76 Configures bypassing the individual voltage input attenuator. If
85 Configures the function for pin 5 on the adi,adt7473 and adi,adt7475. Or
94 Configures the function for pin 9 on the adi,adt7473 and adi,adt7475. Or
/freebsd/secure/lib/libcrypto/man/man3/
H A DSSL_CTX_set_domain_flags.397 Specifying this flag configures the Single-Threaded Concurrency Model (SCM).
100 Speciyfing this flag configures the Contentive Concurrency Model (CCM) (unless
107 Specifying this flag configures the Thread-Assisted Concurrency Model (TACM).
/freebsd/share/man/man4/
H A Dmd.4106 This configures how much memory is mapped for the kernel during
114 This configures the number of kernel L2 page table pages to
121 This configures the amount of kernel virtual address (KVA) space to
/freebsd/contrib/llvm-project/lldb/bindings/interface/
H A DSBBreakpointExtensions.i50 …enabled = property(IsEnabled, SetEnabled, doc='''A read/write property that configures whether thi…
51 …one_shot = property(IsOneShot, SetOneShot, doc='''A read/write property that configures whether th…
/freebsd/sys/contrib/device-tree/Bindings/phy/
H A Dlantiq,vrx200-pcie-phy.yaml58 description: Configures the PDI (PHY) registers in big-endian mode
62 description: Configures the PDI (PHY) registers in big-endian mode
/freebsd/sys/contrib/device-tree/Bindings/mmc/
H A Dsocionext,uniphier-sd.yaml62 - description: phandle to syscon that configures UHS mode
65 A phandle to syscon with one argument that configures UHS mode.
/freebsd/sys/contrib/device-tree/Bindings/power/supply/
H A Dbq24257.txt27 - ti,ovp-voltage: Configures the over voltage protection voltage (in uV). If
29 - ti,in-dpm-voltage: Configures the threshold input voltage for the dynamic
H A Dbq24257.yaml64 Configures the over voltage protection voltage (in uV).
70 Configures the threshold input voltage for the dynamic power path management (in uV).
/freebsd/sys/contrib/device-tree/Bindings/net/
H A Dsocionext,uniphier-ave4.yaml60 - description: phandle to syscon that configures phy mode
63 A phandle to syscon with one argument that configures phy mode.
/freebsd/sys/contrib/device-tree/Bindings/pinctrl/
H A Dfsl,imx27-pinctrl.txt32 gpio_oconf configures the gpio submodule output signal. This does not
43 gpio_iconfa/b configures the gpio submodule input to functionblocks A and
H A Dnuvoton,wpcm450-pinctrl.yaml28 # 2. a pinmux node configures pin muxing for a group of pins (e.g. rmii2)
29 # 3. a pinconf node configures properties of a single pin
/freebsd/share/man/man4/man4.i386/
H A DCPU_ELAN.478 (lower-case ell) configures a
83 configures a
/freebsd/lib/libc/posix1e/
H A Dmac.conf.539 file configures the default label elements to be used by policy-agnostic
70 The following example configures user applications to operate with
/freebsd/lib/libgpio/
H A Dgpio.3124 configures a pin with the flags passed in by the
166 configures the interrupt report type and FIFO size for buffered
/freebsd/contrib/ldns/
H A DREADME-Travis.md138 …he scripts `contrib/android/install_openssl.sh`. The script downloads, configures and installs the…
150 Finally, once OpenSSL are built, then the Travis script configures and builds LDNS. The recipe look…
240 …ng the scripts `contrib/ios/install_openssl.sh`. The script downloads, configures and installs the…
252 Finally, once OpenSSL are built, then the Travis script configures and builds LDNS. The full recipe…
/freebsd/sys/contrib/device-tree/Bindings/gpio/
H A Dxlnx,gpio-xilinx.yaml109 description: This value configures the input or output mode
114 description: This value configures the input or output mode

12345678910>>...15