Home
last modified time | relevance | path

Searched +full:65 +full:gbps (Results 1 – 16 of 16) sorted by relevance

/linux/Documentation/networking/
H A Ddctcp.rst19 switches is 20 packets (30KB) at 1Gbps, and 65 packets (~100KB) at 10Gbps,
/linux/Documentation/networking/device_drivers/ethernet/altera/
H A Daltera_tse.rst53 tested for 1Gbps. This support will be added in a future maintenance update.
255 between 65 and 127 octets in length inclusive.
/linux/net/ipv4/
H A DKconfig644 DCTCP on switches is 20 packets (30KB) at 1Gbps, and 65 packets
645 (~100KB) at 10Gbps, but might need further careful tweaking.
/linux/drivers/net/ethernet/intel/igc/
H A Digc_ethtool.c270 regs_buff[65] = adapter->stats.roc; in igc_ethtool_get_regs()
1961 * 1 Gbps and 2.5 Gbps link modes. in igc_ethtool_get_link_ksettings()
1963 * to differentiate between 1 Gbps and 2.5 Gbps. in igc_ethtool_get_link_ksettings()
/linux/drivers/net/vmxnet3/
H A Dvmxnet3_defs.h621 #define VMXNET3_EXT_MAX_INTRS 65
887 #define VMXNET3_LINK_UP (10000 << 16 | 1) /* 10 Gbps, up */
/linux/drivers/gpu/drm/amd/display/dmub/inc/
H A Ddmub_cmd.h1785 DMUB_CMD__MALL = 65,
3561 * Rate_1 (RBR) - 1.62 Gbps/Lane
3565 * Rate_2 - 2.16 Gbps/Lane
3569 * Rate_3 - 2.43 Gbps/Lane
3573 * Rate_4 (HBR) - 2.70 Gbps/Lane
3577 * Rate_5 (RBR2)- 3.24 Gbps/Lane
3581 * Rate_6 - 4.32 Gbps/Lane
3585 * Rate_7 (HBR2)- 5.40 Gbps/Lane
3589 * Rate_8 (HBR3)- 8.10 Gbps/Lane
3593 * UHBR10 - 10.0 Gbps/Lane
[all …]
/linux/drivers/scsi/bfa/
H A Dbfa_defs_svc.h267 u32 asn8g_attempts; /* SNSM HWSM at 8Gbps attempts */
1278 u64 frame_65_127; /* Frames 65-127 bytes */
/linux/drivers/infiniband/hw/ocrdma/
H A Docrdma_hw.c273 str = "40Gbps "; in port_speed_string()
275 str = "10Gbps "; in port_speed_string()
277 str = "1Gbps "; in port_speed_string()
3130 (eq[i].aic_obj.prev_eqd * 65)/100; in ocrdma_mbx_modify_eqd()
/linux/drivers/net/ethernet/sun/
H A Dcassini.h569 /* diagnostics access to any TX FIFO location. every access is 65
1321 * NOTE: on half-duplex 1Gbps, TX_CFG_CARRIER_EXTEND and
1408 for half-duplex at 1Gbps,
1453 to half-duplex 1Gbps */
/linux/drivers/net/usb/
H A Dlan78xx.c193 "RX 65 - 127 Byte Frames",
217 "TX 65 - 127 Byte Frames",
2387 * - At 1 Gbps: 1 quanta = 512 ns → max ~33.6 ms pause
2588 * Use fixed link configuration with 1 Gbps full duplex. This is used in special
/linux/drivers/net/ethernet/intel/e1000e/
H A Dphy.c26 44, 49, 53, 57, 61, 65, 68, 72, 75, 79, 82, 40, 45, 51, 56, 61,
3106 /* check if link is up and at 1Gbps */ in e1000_link_stall_workaround_hv()
/linux/drivers/net/ethernet/xilinx/
H A Dxilinx_axienet_main.c2451 { 65, 127 },
2648 "Speed other than 10, 100 or 1Gbps is not supported\n"); in axienet_mac_link_up()
/linux/drivers/gpu/drm/amd/include/
H A Datombios.h3778 #define ATOM_REFRESH_65 65
4208 UCHAR ucMaxLinkRate; //06h : 1.62Gbps per lane; 0Ah = 2.7Gbps per lane
4383 #define THERMAL_INT_OUTPUT_GPIO_PINID 65
4834 #define ATOM_ENCODER_CAP_RECORD_HDMI6Gbps_EN 0x04 // HDMI2.0 6Gbps enable or not.
/linux/drivers/gpu/drm/i915/display/
H A Dintel_cdclk.c1170 * the eDP1.4 2.16 and 4.32Gbps rates require it, but eDP1.4 is not in skl_set_cdclk()
1324 { .refclk = 19200, .cdclk = 624000, .ratio = 65 },
/linux/drivers/message/fusion/
H A Dmptbase.c3623 reply_sz, (u16 *)preply, 65 /*seconds*/, sleepFlag); in mpt_do_upload()
7457 " Rate 1.5 Gbps",PhyNumber); in mpt_display_event_info()
7462 " Rate 3.0 Gbps", PhyNumber); in mpt_display_event_info()
7467 " Rate 6.0 Gbps", PhyNumber); in mpt_display_event_info()
/linux/drivers/gpu/drm/radeon/
H A Datombios.h3301 #define ATOM_REFRESH_65 65
3727 UCHAR ucMaxLinkRate; //06h : 1.62Gbps per lane; 0Ah = 2.7Gbps per lane