/linux/arch/arm64/boot/dts/ti/ |
H A D | k3-j7200-evm-quad-port-eth-exp.dtso | 19 ethernet1 = "/bus@100000/ethernet@c000000/ethernet-ports/port@1"; 20 ethernet2 = "/bus@100000/ethernet@c000000/ethernet-ports/port@2"; 21 ethernet3 = "/bus@100000/ethernet@c000000/ethernet-ports/port@3"; 22 ethernet4 = "/bus@100000/ethernet@c000000/ethernet-ports/port@4"; 97 J721E_IOPAD(0x00a8, PIN_OUTPUT, 5) /* (W19) UART8_TXD.MDIO0_MDC */ 98 J721E_IOPAD(0x00a4, PIN_INPUT, 5) /* (W14) UART8_RXD.MDIO0_MDIO */
|
H A D | k3-j784s4-evm-quad-port-eth-exp1.dtso | 26 ethernet1 = "/bus@100000/ethernet@c000000/ethernet-ports/port@5"; 27 ethernet2 = "/bus@100000/ethernet@c000000/ethernet-ports/port@6"; 28 ethernet3 = "/bus@100000/ethernet@c000000/ethernet-ports/port@7"; 29 ethernet4 = "/bus@100000/ethernet@c000000/ethernet-ports/port@8"; 42 phys = <&cpsw0_phy_gmii_sel 5>, <&serdes2_qsgmii_link>;
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8-ss-ddr.dtsi | 7 ddr_subsys: bus@5c000000 { 13 ddr_pmu0: ddr-pmu@5c020000 {
|
H A D | fsl-ls1088a.dtsi | 262 <5 0 &gic GIC_SPI 5 IRQ_TYPE_LEVEL_HIGH>, 884 cluster1_core0_watchdog: watchdog@c000000 { 964 fsl_mc: fsl-mc@80c000000 { 1005 dpmac5: ethernet@5 { 1007 reg = <5>;
|
H A D | fsl-ls208xa.dtsi | 157 thermal-sensors = <&tmu 5>; 303 <5 0 &gic GIC_SPI 5 IRQ_TYPE_LEVEL_HIGH>, 392 cluster1_core0_watchdog: watchdog@c000000 { 757 fsl_mc: fsl-mc@80c000000 { 805 dpmac5: ethernet@5 { 940 spi-num-chipselects = <5>;
|
/linux/arch/arm/boot/dts/sunplus/ |
H A D | sunplus-sp7021-achip.dtsi | 77 soc@9c000000 { 80 interrupts = <GIC_SPI 5 IRQ_TYPE_LEVEL_HIGH>, /* EXT_INT0 */
|
/linux/arch/arm/boot/dts/aspeed/ |
H A D | aspeed-bmc-opp-vesnin.dts | 26 vga_memory: framebuffer@5f000000 { 30 flash_memory: region@5c000000 { 69 gpios = <&gpio ASPEED_GPIO(P, 5) GPIO_ACTIVE_LOW>;
|
H A D | aspeed-bmc-opp-palmetto.dts | 25 vga_memory: framebuffer@5f000000 { 30 coldfire_memory: codefire_memory@5ee00000 { 35 flash_memory: region@5c000000 { 49 gpios = <&gpio ASPEED_GPIO(R, 5) GPIO_ACTIVE_LOW>; 67 data-gpios = <&gpio ASPEED_GPIO(A, 5) GPIO_ACTIVE_HIGH>; 78 gpios = <&gpio ASPEED_GPIO(P, 5) GPIO_ACTIVE_LOW>; 79 linux,code = <ASPEED_GPIO(P, 5)>; 221 gpios = <ASPEED_GPIO(C, 5) GPIO_ACTIVE_HIGH>; 291 gpios = <ASPEED_GPIO(F, 5) GPIO_ACTIVE_HIGH>; 319 gpios = <ASPEED_GPIO(G, 5) GPIO_ACTIVE_HIGH>;
|
/linux/arch/arm/boot/dts/ti/omap/ |
H A D | am3517.dtsi | 55 target-module@5c040000 { 86 davinci_emac: ethernet@5c000000 { 103 davinci_mdio: mdio@5c030000 { 138 hecc: can@5c050000 { 182 /* Table Table 5-79 of the TRM shows 480ab000 is reserved */
|
/linux/arch/arm/boot/dts/arm/ |
H A D | vexpress-v2p-ca5s.dts | 96 scu@2c000000 { 193 smbclk: clock-controller-5 { 196 arm,vexpress-sysreg,func = <1 5>;
|
H A D | vexpress-v2p-ca9.dts | 80 vram: vram@4c000000 { 264 arm,vexpress-sysreg,func = <2 5>;
|
/linux/arch/arm/boot/dts/ti/keystone/ |
H A D | keystone-k2hk.dtsi | 60 msm_ram: sram@c000000 { 67 bm-sram@5f0000 { 83 0xa50 8 0xa50 8 0x850 8 (ASSERT_CLEAR | DEASSERT_SET | STATUS_CLEAR) /* 5: dsp5 */ 244 resets = <&pscrst 5>; 246 interrupts = <5 13>;
|
H A D | keystone-k2l.dtsi | 190 * GPIO_TIMIO_SEL[5]: 0-GPIO5, 1-TIMI3 246 * GPIO_EMIFA_SEL[5]: 0-EMIFA5, 1-GPIO37 258 msm_ram: sram@c000000 { 404 ti,davinci-spi-num-cs = <5>; 412 ti,davinci-spi-num-cs = <5>;
|
/linux/arch/arm64/boot/dts/qcom/ |
H A D | sm8250-xiaomi-pipa.dts | 43 framebuffer: framebuffer@9c000000 { 148 cont_splash_mem: cont-splash@9c000000 { 519 current-num-sinks = <5>;
|
H A D | sm6115p-lenovo-j606f.dts | 29 framebuffer0: framebuffer@5c000000 { 49 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm6125-xiaomi-laurel-sprout.dts | 29 framebuffer0: framebuffer@5c000000 { 77 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm8250-xiaomi-elish-common.dtsi | 38 framebuffer: framebuffer@9c000000 { 143 cont_splash_mem: cont-splash@9c000000 { 520 current-num-sinks = <5>;
|
H A D | sm6115-fxtec-pro1x.dts | 27 framebuffer0: framebuffer@5c000000 { 83 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm6125-sony-xperia-seine-pdx201.dts | 33 framebuffer0: framebuffer@5c000000 {
|
/linux/arch/arm64/boot/dts/mediatek/ |
H A D | mt6779.dtsi | 63 cpu5: cpu@5 { 120 gic: interrupt-controller@c000000 {
|
/linux/arch/arm/boot/dts/intel/pxa/ |
H A D | pxa3xx.dtsi | 33 (gpio <= 9) ? (0x028c + 4 * (gpio - 5)) : \ 44 (gpio <= 5) ? (0x284 + 4 * gpio) : \ 56 #define MFP_AF5 (5 << 0) 216 usb0: usb@4c000000 {
|
/linux/arch/riscv/boot/dts/sifive/ |
H A D | fu540-c000.dtsi | 181 plic0: interrupt-controller@c000000 { 222 interrupts = <5>;
|
H A D | fu740-c000.dtsi | 182 plic0: interrupt-controller@c000000 { 359 pwren-gpios = <&gpio 5 0>;
|
/linux/arch/arm64/boot/dts/hisilicon/ |
H A D | hip07.dtsi | 959 p0_its_peri_a: msi-controller@4c000000 { 966 p0_its_peri_b: msi-controller@6c000000 { 987 p1_its_peri_a: msi-controller@4004c000000 { 994 p1_its_peri_b: msi-controller@4006c000000 { 1028 port-idx-in-ae = <5>; 1511 port@5 { 1512 reg = <5>; 1515 port-rst-offset = <5>; 1572 "hns-roce-comp-5",
|
/linux/arch/riscv/boot/dts/canaan/ |
H A D | k210.dtsi | 117 plic0: interrupt-controller@c000000 { 162 snps,priority = <0 1 2 3 4 5>; 163 snps,data-width = <5>; 267 interrupts = <5>;
|