| /linux/Documentation/devicetree/bindings/dma/ |
| H A D | socionext,uniphier-mio-dmac.yaml | 52 // In the example below, "interrupts = <0 68 4>, <0 68 4>, ..." is not a 55 dmac: dma-controller@5a000000 { 58 interrupts = <0 68 4>, <0 68 4>, <0 69 4>, <0 70 4>, 59 <0 71 4>, <0 72 4>, <0 73 4>, <0 74 4>;
|
| /linux/arch/arm/boot/dts/arm/ |
| H A D | integrator.dtsi | 68 bank-width = <4>; 108 interrupts = <4>; 111 syscon@1a000000 { 119 led@4,0 { 128 led@4,1 { 136 led@4,2 { 144 led@4,3 {
|
| /linux/Documentation/devicetree/bindings/display/ |
| H A D | st,stm32-dsi.yaml | 91 dsi: dsi@5a000000 { 125 reset-gpios = <&gpioe 4 GPIO_ACTIVE_LOW>;
|
| /linux/arch/mips/boot/dts/loongson/ |
| H A D | loongson64v_4core_virtio.dts | 7 compatible = "loongson,loongson64v-4core-virtio"; 68 pci@1a000000 {
|
| H A D | loongson64-2k1000.dtsi | 115 pci@1a000000 { 174 ehci@4,1 { 185 ohci@4,2 { 294 interrupts = <4 IRQ_TYPE_LEVEL_HIGH>; 297 interrupt-map = <0 0 0 0 &liointc1 4 IRQ_TYPE_LEVEL_HIGH>;
|
| /linux/Documentation/devicetree/bindings/net/ |
| H A D | intel,dwmac-plat.yaml | 71 snps,blen = <0 0 0 0 16 8 4>; 106 gmac0: ethernet@3a000000 {
|
| H A D | qca,ar71xx.yaml | 79 interrupts = <4>; 88 eth1: ethernet@1a000000 { 154 switch_port4: port@4 { 187 phy_port4: ethernet-phy@4 {
|
| /linux/Documentation/devicetree/bindings/mmc/ |
| H A D | cdns,sdhci.yaml | 148 emmc: mmc@5a000000 { 151 interrupts = <0 78 4>; 152 clocks = <&clk 4>;
|
| /linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8-ss-dma.dtsi | 18 dma_subsys: bus@5a000000 { 24 lpspi0: spi@5a000000 { 73 dmas = <&edma2 5 0 0>, <&edma2 4 0 FSL_EDMA_RX>; 409 /* SLSlice[4] */ 430 /* SLSlice[4] */ 451 /* SLSlice[4] */
|
| /linux/arch/powerpc/boot/dts/fsl/ |
| H A D | mpc8536ds.dtsi | 106 partition@1a000000 { 135 adt7461@4c {
|
| H A D | p2041rdb.dts | 137 adt7461@4c { 177 phy_sgmii_4: ethernet-phy@4 { 277 partition@1a000000 {
|
| H A D | p2020ds.dtsi | 99 kernel@1a000000 { 118 nand@4,0 { 235 // IDSEL 0x11 func 4 - PCI slot 1 293 interrupts = <4 1 0 0>;
|
| H A D | p3041ds.dts | 162 adt7461@4c { 202 phy_xgmii_1: ethernet-phy@4 { 261 partition@1a000000 {
|
| H A D | p5020ds.dts | 162 adt7461@4c { 202 phy_xgmii_1: ethernet-phy@4 { 261 partition@1a000000 {
|
| H A D | p5040ds.dts | 171 adt7461@4c { 268 partition@1a000000 { 422 reg = <4>; 431 phy_xgmii_slot_2: ethernet-phy@4 {
|
| H A D | mpc8572ds.dtsi | 112 partition@1a000000 { 128 nand@4,0 { 273 /* IDSEL 0x11 func 4 - PCI slot 1 */ 321 /* IDSEL 0x12 func 4 - PCI slot 2 */
|
| /linux/arch/riscv/boot/dts/starfive/ |
| H A D | jh7100-common.dtsi | 55 linux,dma@107a000000 { 370 bus-width = <4>; 380 bus-width = <4>;
|
| /linux/arch/arm64/boot/dts/marvell/mmp/ |
| H A D | pxa1908-samsung-coreprimevelte.dts | 25 reg = <0 0x17177000 0 (480 * 800 * 4)>; 28 stride = <(480 * 4)>; 58 cm3@a000000 { 329 bus-width = <4>;
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap4.dtsi | 128 l4_wkup: interconnect@4a300000 { 131 l4_cfg: interconnect@4a000000 { 157 reg = <0x50000000 4>, 158 <0x50000010 4>, 159 <0x50000014 4>; 179 dmas = <&sdma 4>; 182 gpmc,num-waitpins = <4>; 286 target-module@4e000000 { 305 target-module@4c000000 { 317 compatible = "ti,emif-4d"; [all …]
|
| /linux/Documentation/devicetree/bindings/pci/ |
| H A D | mediatek-pcie.txt | 76 hifsys: syscon@1a000000 { 174 <0 0 0 4 &pcie_intc1 3>; 206 <0 0 0 4 &pcie_intc0 3>; 245 <0 0 0 4 &pcie_intc0 3>; 283 <0 0 0 4 &pcie_intc1 3>;
|
| /linux/arch/arm/boot/dts/gemini/ |
| H A D | gemini-dlink-dir-685.dts | 231 ethernet-port@4 { 232 reg = <4>; 275 phy4: ethernet-phy@4 { 276 reg = <4>; 430 gpio0: gpio@4d000000 { 435 gpio1: gpio@4e000000 { 474 display-controller@6a000000 {
|
| H A D | gemini.dtsi | 231 power-controller@4b000000 { 239 gpio0: gpio@4d000000 { 251 gpio1: gpio@4e000000 { 263 gpio2: gpio@4f000000 { 298 <0x4800 0 0 4 &pci_intc 3>, 302 <0x5000 0 0 4 &pci_intc 0>, 306 <0x5800 0 0 4 &pci_intc 1>, 310 <0x6000 0 0 4 &pci_intc 2>; 388 interrupts = <4 IRQ_TYPE_EDGE_RISING>; 428 display-controller@6a000000 {
|
| /linux/arch/arm/boot/dts/socionext/ |
| H A D | uniphier-ld4.dtsi | 148 clocks = <&peri_clk 4>; 149 resets = <&peri_rst 4>; 242 dmac: dma-controller@5a000000 { 269 dmas = <&dmac 4>; 270 bus-width = <4>; 286 resets = <&mio_rst 1>, <&mio_rst 4>, <&mio_rst 6>;
|
| H A D | uniphier-sld8.dtsi | 152 clocks = <&peri_clk 4>; 153 resets = <&peri_rst 4>; 246 dmac: dma-controller@5a000000 { 273 dmas = <&dmac 4>; 274 bus-width = <4>; 291 resets = <&mio_rst 1>, <&mio_rst 4>, <&mio_rst 6>;
|
| /linux/arch/arm/boot/dts/mediatek/ |
| H A D | mt7629.dtsi | 68 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>, 69 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>, 70 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>, 71 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_HIGH)>; 263 clock-div = <4>; 300 ssusbsys: syscon@1a000000 { 405 <0 0 0 4 &pcie_intc1 3>;
|