/linux/drivers/soc/tegra/fuse/ |
H A D | speedo-tegra30.c | 63 {295, 336, 358, 375, UINT_MAX}, 69 {295, 336, 358, 375, UINT_MAX}, 72 {295, 336, 358, 375, 391, UINT_MAX}, 73 {295, 336, 358, 375, 391, UINT_MAX},
|
/linux/drivers/media/tuners/ |
H A D | m88rs6000t.c | 495 298, 295, 283, 285, 285, 300, 300}; in m88rs6000t_get_rf_strength() 497 295, 285, 290, 295, 295, 310}; in m88rs6000t_get_rf_strength() 499 290, 285, 283, 260, 295, 290, 260}; in m88rs6000t_get_rf_strength()
|
/linux/Documentation/devicetree/bindings/phy/ |
H A D | starfive,jh7110-dphy-tx.yaml | 59 phy@295e0000 {
|
/linux/drivers/clocksource/ |
H A D | numachip.c | 22 .rating = 295,
|
/linux/Documentation/devicetree/bindings/clock/ |
H A D | starfive,jh7110-voutcrg.yaml | 74 voutcrg: clock-controller@295C0000 {
|
/linux/arch/arm64/boot/dts/ti/ |
H A D | k3-j721s2-mcu-wakeup.dtsi | 746 clocks = <&k3_clks 295 1>; 747 power-domains = <&k3_pds 295 TI_SCI_PD_EXCLUSIVE>; 748 assigned-clocks = <&k3_clks 295 1>; 749 assigned-clock-parents = <&k3_clks 295 5>;
|
H A D | k3-j721e-main.dtsi | 903 power-domains = <&k3_pds 295 TI_SCI_PD_EXCLUSIVE>; 904 clocks = <&k3_clks 295 5>, <&k3_clks 295 9>, <&cmn_refclk>; 906 assigned-clocks = <&k3_clks 295 9>, <&k3_clks 295 0>; 907 assigned-clock-parents = <&k3_clks 295 13>, <&k3_clks 295 4>; 913 clocks = <&k3_clks 295 9>, <&cmn_refclk>; 916 assigned-clock-parents = <&k3_clks 295 9>; 920 clocks = <&k3_clks 295 0>, <&cmn_refclk1>; 923 assigned-clock-parents = <&k3_clks 295 0>; 927 clocks = <&k3_clks 295 9>, <&k3_clks 295 0>, <&cmn_refclk>, <&cmn_refclk1>; 930 assigned-clock-parents = <&k3_clks 295 9>;
|
/linux/include/dt-bindings/clock/ |
H A D | exynos5250.h | 99 #define CLK_I2C1 295
|
H A D | tegra30-car.h | 260 /* 295 */
|
H A D | exynos4.h | 133 #define CLK_SATA_PHY 295 /* Exynos4210 only */
|
H A D | qcom,gcc-mdm9615.h | 305 #define USB_HS3_H_CLK 295
|
H A D | tegra194-clock.h | 290 #define TEGRA194_CLK_PVA0_CPU_AXI 295
|
H A D | qcom,gcc-msm8960.h | 303 #define USB_HS3_H_CLK 295
|
H A D | qcom,gcc-msm8974.h | 304 #define GCC_SPMI_CNOC_AHB_CLK_SLEEP_ENA 295
|
H A D | rk3568-cru.h | 359 #define SCLK_UART3 295 758 #define SRST_A_IEP 295
|
H A D | qcom,gcc-apq8084.h | 304 #define GCC_UFS_AXI_CLK 295
|
/linux/drivers/char/mwave/ |
H A D | tp3780i.h | 68 #define TP_CFG_IsaMemCmdWidth 3 /* 295 nsec (16-bit) */
|
/linux/Documentation/devicetree/bindings/i3c/ |
H A D | renesas,i3c.yaml | 155 <GIC_SPI 295 IRQ_TYPE_EDGE_RISING>,
|
/linux/Documentation/devicetree/bindings/net/ |
H A D | renesas,r8a779f0-ether-switch.yaml | 188 <GIC_SPI 295 IRQ_TYPE_LEVEL_HIGH>,
|
/linux/include/dt-bindings/reset/ |
H A D | qcom,ipq5424-gcc.h | 304 #define GCC_UNIPHY0_XPCS_ARES 295
|
/linux/drivers/pinctrl/uniphier/ |
H A D | pinctrl-uniphier-pro4.c | 900 UNIPHIER_PINCTRL_PIN(295, "AO2DMIX", UNIPHIER_PIN_IECTRL_NONE, 949 295, UNIPHIER_PIN_DRV_1BIT, 950 295, UNIPHIER_PIN_PULL_DOWN), 1115 292, 293, 294, 295, 296, 236, 237, 238, /* PORT27x */
|
/linux/drivers/media/i2c/cx25840/ |
H A D | cx25840-audio.c | 128 * 295 MHz pre-postdivide in cx25840_set_audclk_freq() 249 * 295 MHz pre-postdivide in cx25840_set_audclk_freq()
|
/linux/include/dt-bindings/gce/ |
H A D | mt8192-gce.h | 218 #define CMDQ_EVENT_MDP_TDSHP0_FRAME_DONE 295
|
/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8dxl-ss-adma.dtsi | 140 <GIC_SPI 295 IRQ_TYPE_LEVEL_HIGH>,
|
/linux/include/dt-bindings/arm/ |
H A D | qcom,ids.h | 146 #define QCOM_ID_APQ8037 295
|