| /linux/Documentation/devicetree/bindings/clock/ |
| H A D | imx1-clock.yaml | 38 clock-controller@21b000 {
|
| /linux/arch/arm/boot/dts/hisilicon/ |
| H A D | hi3620.dtsi | 187 interrupts = <0 21 4>; 294 gpio5: gpio@80b000 { 330 gpio-ranges = < &pmx0 0 19 1 &pmx0 1 20 1 &pmx0 2 21 1 531 gpio21: gpio@81b000 {
|
| /linux/Documentation/arch/powerpc/ |
| H A D | transactional_memory.rst | 213 Date: Wed Mar 21 21:32:01 2018 +1100 269 if (MSR 29:31 ¬ = 0b010 | SRR1 29:31 ¬ = 0b000) then
|
| /linux/arch/powerpc/boot/dts/ |
| H A D | mpc8379_rdb.dts | 371 sata@1b000 { 404 /* IRQ5 = 21 = 0x15, IRQ6 = 0x16, IRQ7 = 23 = 0x17 */ 410 0x7800 0x0 0x0 0x1 &ipic 21 0x8 416 0xE000 0x0 0x0 0x2 &ipic 21 0x8
|
| /linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap3-beagle-xm.dts | 48 gpios = <&gpio5 21 GPIO_ACTIVE_HIGH>; /* 149 -> D7 LED */ 154 etb@5401b000 {
|
| H A D | am33xx-l4.dtsi | 76 <0x0000f000 0x0020f000 0x001000>, /* ap 21 */ 167 <&am33xx_pinmux 21 73 1>, 213 target-module@b000 { /* 0x44e0b000, ap 18 48.0 */ 508 <0x0003e000 0x0003e000 0x001000>, /* ap 21 */ 631 target-module@3e000 { /* 0x47c3e000, ap 21 10.0 */ 902 interrupts = <20>, <21>, <22>, <23>, <24>, <25>, <26>, <27>; 1032 <0x0003e000 0x0003e000 0x001000>, /* ap 21 */
|
| H A D | am437x-l4.dtsi | 102 <0x0000f000 0x0020f000 0x001000>, /* ap 21 */ 202 target-module@b000 { /* 0x44e0b000, ap 18 48.0 */ 657 <0x00043000 0x00043000 0x001000>, /* ap 21 */
|
| /linux/arch/arm/boot/dts/arm/ |
| H A D | vexpress-v2m.dtsi | 53 <0 21 &gic GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>, 235 v2m_serial2: serial@b000 {
|
| /linux/Documentation/arch/arm/pxa/ |
| H A D | mfp.rst | 179 0b000 - fast 1mA 245 * bit 21..22 - Run Mode Pull State
|
| /linux/arch/arm/boot/dts/ti/davinci/ |
| H A D | da850.dtsi | 462 power-domains = <&psc1 21>; 524 interrupts = <21>, <22>; 564 mmc1: mmc@21b000 { 696 pll1: clock-controller@21a000 { 775 <&pmx_core 21 34 1>, 780 <&pmx_core 26 21 1>,
|
| /linux/arch/mips/boot/dts/brcm/ |
| H A D | bcm7435.dtsi | 287 brcm,gpio-bank-widths = <32 32 32 21>; 408 hif_l2_intc: interrupt-controller@41b000 {
|
| /linux/arch/powerpc/platforms/512x/ |
| H A D | clock-commonclk.c | 339 /* 0b000 is "times 36" */ in get_cpmf_mult_x2() 343 /* 0b000 is "bypass" */ in get_cpmf_mult_x2() 878 "mbx", "mbx-ug", &clkregs->sccr2, 21); in mpc512x_clk_setup_clock_tree()
|
| /linux/arch/arm/boot/dts/st/ |
| H A D | stm32f429.dtsi | 368 interrupts = <19>, <20>, <21>, <22>; 746 dma2d: dma2d@4002b000 {
|
| /linux/arch/arm64/boot/dts/nvidia/ |
| H A D | tegra132.dtsi | 406 dmas = <&apbdma 21>, <&apbdma 21>; 614 emc: external-memory-controller@7001b000 { 1043 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>; 1057 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
|
| /linux/arch/arm/boot/dts/nvidia/ |
| H A D | tegra124.dtsi | 540 dmas = <&apbdma 21>, <&apbdma 21>; 757 emc: external-memory-controller@7001b000 { 1215 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>; 1228 interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
|
| /linux/drivers/net/ethernet/sun/ |
| H A D | cassini.h | 2 /* $Id: cassini.h,v 1.16 2004/08/17 21:15:16 zaumen Exp $ 200 machine bits [21:0] */ 224 0b000: ARB_IDLE1 246 0b000: ARB_IDLE1 2004 * 0b000 normal operation, PROM address[3:0] selected 2183 #define S2_HTTP 21 2584 #define TX_DESC_CSUM_STUFF_SHIFT 21 2627 #define RX_COMP2_NEXT_INDEX_SHIFT 21
|
| /linux/drivers/usb/host/ |
| H A D | octeon-hcd.h | 200 * * 3'b000: 4 bits 1130 __BITFIELD_FIELD(u32 reserved_11_31 : 21, 1172 __BITFIELD_FIELD(u32 reserved_11_31 : 21, 1762 * [22:21] == 11: Rise and fall times are increased. 1763 * [22:21] == 10: Design default. 1764 * [22:21] == 01: Rise and fall times are decreased. 1765 * [22:21] == 00: Rise and fall times are decreased
|
| /linux/drivers/pinctrl/bcm/ |
| H A D | pinctrl-bcm281xx.c | 147 #define BCM281XX_PIN_GPEN13 21 1003 #define BCM21664_PIN_GPIO06 21 1808 * 0b000: No pull-up
|
| /linux/arch/arm64/include/asm/ |
| H A D | sysreg.h | 499 #define SYS_SPMEVCNTRn_EL0(n) sys_reg(2, 3, 14, __SPMEV_crm(0b000, n), __SPMEV_op2(n)) 827 #define SCTLR_ELx_IESB (BIT(21)) 927 #define CPACR_EL1_FPEN_EL0EN (BIT(21)) /* enable EL0 access, if EL1EN set */
|
| /linux/drivers/hid/ |
| H A D | hid-logitech-hidpp.c | 69 /* #define HIDPP_QUIRK_CONNECT_EVENTS BIT(21) disabled */ 3071 if (size < 21) in wtp_raw_event() 3178 * side 1 button (forward) press 11<xx>0a 3500b000... 3644 consumer_rdesc[21] = 0x10; in hidpp10_consumer_keys_report_fixup()
|
| /linux/arch/arm64/boot/dts/qcom/ |
| H A D | hamoa.dtsi | 7174 cti@1098b000 { 7743 reg = <21>; 8626 frame@1780b000 {
|