Home
last modified time | relevance | path

Searched +full:0 +full:x1d00000 (Results 1 – 15 of 15) sorted by relevance

/linux/Documentation/devicetree/bindings/pci/
H A Dqcom,pcie-sc8280xp.yaml107 reg = <0x0 0x01c20000 0x0 0x3000>,
108 <0x0 0x3c000000 0x0 0xf1d>,
109 <0x0 0x3c000f20 0x0 0xa8>,
110 <0x0 0x3c001000 0x0 0x1000>,
111 <0x0 0x3c100000 0x0 0x100000>,
112 <0x0 0x01c23000 0x0 0x1000>;
114 ranges = <0x01000000 0x0 0x00000000 0x0 0x3c200000 0x0 0x100000>,
115 <0x02000000 0x0 0x3c300000 0x0 0x3c300000 0x0 0x1d00000>;
117 bus-range = <0x00 0xff>;
152 interrupt-map-mask = <0 0 0 0x7>;
[all …]
/linux/arch/arm/boot/dts/marvell/
H A Darmada-370-dlink-dns327l.dts9 * There's still some unknown device on i2c address 0x13
28 memory@0 {
30 reg = <0x00000000 0x20000000>; /* 512 MiB */
34 ranges = <MBUS_ID(0xf0, 0x01) 0 0xd0000000 0x100000
35 MBUS_ID(0x01, 0xe0) 0 0xfff00000 0x100000
36 MBUS_ID(0x09, 0x01) 0 0xf1100000 0x10000>;
52 pinctrl-0 = <
73 gpios = <&gpio2 0 GPIO_ACTIVE_LOW>;
79 pinctrl-0 = <
110 pinctrl-0 = <&xhci_pwr_pin>;
[all …]
/linux/arch/arm64/boot/dts/qcom/
H A Dsa8540p.dtsi184 linux,pci-domain = <0>;
201 reg = <0x0 0x01c10000 0x0 0x3000>,
202 <0x0 0x40000000 0x0 0xf1d>,
203 <0x0 0x40000f20 0x0 0xa8>,
204 <0x0 0x40001000 0x0 0x1000>,
205 <0x0 0x40100000 0x0 0x100000>;
208 ranges = <0x01000000 0x0 0x40200000 0x0 0x40200000 0x0 0x100000>,
209 <0x02000000 0x0 0x40300000 0x0 0x40300000 0x0 0x1d00000>;
216 interrupt-map = <0 0 0 1 &intc 0 0 GIC_SPI 541 IRQ_TYPE_LEVEL_HIGH>,
217 <0 0 0 2 &intc 0 0 GIC_SPI 542 IRQ_TYPE_LEVEL_HIGH>,
[all …]
H A Dsa8540p-ride.dts34 regulators-0 {
163 pinctrl-0 = <&ethernet0_default>;
170 #size-cells = <0>;
174 compatible = "ethernet-phy-id0141.0dd4";
175 reg = <0x8>;
189 /* Set MODE[2:0] to RGMII_SGMII */
190 <0x12 0x14 0xfff8 0x4>,
191 /* Soft reset required after changing MODE[2:0] */
192 <0x12 0x14 0x7fff 0x8000>;
202 snps,map-to-dma-channel = <0x0>;
[all …]
H A Dx1e80100.dtsi36 #clock-cells = <0>;
42 #clock-cells = <0>;
47 #clock-cells = <0>;
56 #clock-cells = <0>;
66 #size-cells = <0>;
68 cpu0: cpu@0 {
71 reg = <0x0 0x0>;
88 reg = <0x0 0x100>;
99 reg = <0x0 0x200>;
110 reg = <0x0 0x300>;
[all …]
H A Dmsm8996.dtsi29 #clock-cells = <0>;
36 #clock-cells = <0>;
44 #size-cells = <0>;
46 cpu0: cpu@0 {
49 reg = <0x0 0x0>;
53 clocks = <&kryocc 0>;
68 reg = <0x0 0x1>;
72 clocks = <&kryocc 0>;
82 reg = <0x0 0x100>;
101 reg = <0x0 0x101>;
[all …]
H A Dsm8250.dtsi80 #clock-cells = <0>;
88 #clock-cells = <0>;
94 #size-cells = <0>;
96 cpu0: cpu@0 {
99 reg = <0x0 0x0>;
100 clocks = <&cpufreq_hw 0>;
107 qcom,freq-domain = <&cpufreq_hw 0>;
109 interconnects = <&gem_noc MASTER_AMPSS_M0 0 &mc_virt SLAVE_EBI_CH0 0>,
115 cache-size = <0x20000>;
121 cache-size = <0x400000>;
[all …]
/linux/arch/arm64/boot/dts/marvell/
H A Darmada-37xx.dtsi35 reg = <0 0x4000000 0 0x200000>;
40 reg = <0 0x4400000 0 0x1000000>;
47 #size-cells = <0>;
48 cpu0: cpu@0 {
51 reg = <0>;
85 /* 32M internal register @ 0xd000_0000 */
86 ranges = <0x0 0x0 0xd0000000 0x2000000>;
90 reg = <0x8300 0x40>;
98 reg = <0xd000 0x1000>;
104 #size-cells = <0>;
[all …]
/linux/drivers/net/ethernet/qlogic/qed/
H A Dqed_init_ops.c26 0,
27 0,
28 0x1c02, /* win 2: addr=0x1c02000, size=4096 bytes */
29 0x1c80, /* win 3: addr=0x1c80000, size=4096 bytes */
30 0x1d00, /* win 4: addr=0x1d00000, size=4096 bytes */
31 0x1d01, /* win 5: addr=0x1d01000, size=4096 bytes */
32 0x1d02, /* win 6: addr=0x1d02000, size=4096 bytes */
33 0x1d80, /* win 7: addr=0x1d80000, size=4096 bytes */
34 0x1d81, /* win 8: addr=0x1d81000, size=4096 bytes */
35 0x1d82, /* win 9: addr=0x1d82000, size=4096 bytes */
[all …]
/linux/arch/arm/boot/dts/nuvoton/
H A Dnuvoton-npcm750-runbmc-olympus.dts47 reg = <0 0x40000000>;
52 io-channels = <&adc 0>, <&adc 1>, <&adc 2>, <&adc 3>,
75 gpios = <&gpio0 19 0>; /* gpio19 */
76 regbase = <0xf0010000 0x1000>;
81 gpios = <&gpio0 18 0>; /* gpio18 */
82 regbase = <0xf0010000 0x1000>;
87 gpios = <&gpio0 17 0>; /* gpio17 */
88 regbase = <0xf0010000 0x1000>;
92 gpios = <&gpio0 16 0>; /* gpio16 */
93 regbase = <0xf0010000 0x1000>;
[all …]
/linux/include/linux/qed/
H A Dcommon_hsi.h16 #define PTR_LO(x) ((u32)(((uintptr_t)(x)) & 0xffffffff))
23 } while (0)
47 #define ISCSI_CDU_TASK_SEG_TYPE 0
48 #define FCOE_CDU_TASK_SEG_TYPE 0
59 #define YSTORM_QZONE_SIZE 0
60 #define PSTORM_QZONE_SIZE 0
97 #define FW_ENGINEERING_VERSION 0
158 #define CDU_SEG_TYPE_OFFSET_REG_OFFSET_MASK (0x1ffff)
161 #define CDU_VF_FL_SEG_TYPE_OFFSET_REG_OFFSET_MASK (0xfff)
163 #define CDU_CONTEXT_VALIDATION_CFG_ENABLE_SHIFT (0)
[all …]
/linux/drivers/net/ethernet/qlogic/qlcnic/
H A Dqlcnic_hw.c15 #define OCM_WIN_P3P(addr) (addr & 0xffc0000)
19 #define CRB_BLK(off) ((off >> 20) & 0x3f)
20 #define CRB_SUBBLK(off) ((off >> 16) & 0xf)
21 #define CRB_WINDOW_2M (0x130060)
22 #define CRB_HI(off) ((crb_hub_agt[CRB_BLK(off)] << 20) | ((off) & 0xf0000))
23 #define CRB_INDIRECT_2M (0x1e0000UL)
52 {{{0, 0, 0, 0} } }, /* 0: PCI */
53 {{{1, 0x0100000, 0x0102000, 0x120000}, /* 1: PCIE */
54 {1, 0x0110000, 0x0120000, 0x130000},
55 {1, 0x0120000, 0x0122000, 0x124000},
[all …]
/linux/drivers/net/ethernet/qlogic/netxen/
H A Dnetxen_nic_hw.c16 #define MN_WIN(addr) (((addr & 0x1fc0000) >> 1) | ((addr >> 25) & 0x3ff))
17 #define OCM_WIN(addr) (((addr & 0x1ff0000) >> 1) | ((addr >> 25) & 0x3ff))
18 #define MS_WIN(addr) (addr & 0x0ffc0000)
22 #define CRB_BLK(off) ((off >> 20) & 0x3f)
23 #define CRB_SUBBLK(off) ((off >> 16) & 0xf)
24 #define CRB_WINDOW_2M (0x130060)
25 #define CRB_HI(off) ((crb_hub_agt[CRB_BLK(off)] << 20) | ((off) & 0xf0000))
26 #define CRB_INDIRECT_2M (0x1e0000UL)
57 {{{0, 0, 0, 0} } }, /* 0: PCI */
58 {{{1, 0x0100000, 0x0102000, 0x120000}, /* 1: PCIE */
[all …]
/linux/drivers/scsi/qla2xxx/
H A Dqla_nx.c15 #define MN_WIN(addr) (((addr & 0x1fc0000) >> 1) | \
16 ((addr >> 25) & 0x3ff))
17 #define OCM_WIN(addr) (((addr & 0x1ff0000) >> 1) | \
18 ((addr >> 25) & 0x3ff))
19 #define MS_WIN(addr) (addr & 0x0ffc0000)
20 #define QLA82XX_PCI_MN_2M (0)
21 #define QLA82XX_PCI_MS_2M (0x80000)
22 #define QLA82XX_PCI_OCM0_2M (0xc0000)
23 #define VALID_OCM_ADDR(addr) (((addr) & 0x3f800) != 0x3f800)
25 #define BLOCK_PROTECT_BITS 0x0F
[all …]
/linux/drivers/scsi/qla4xxx/
H A Dql4_nx.c18 #define MN_WIN(addr) (((addr & 0x1fc0000) >> 1) | ((addr >> 25) & 0x3ff))
19 #define OCM_WIN(addr) (((addr & 0x1ff0000) >> 1) | ((addr >> 25) & 0x3ff))
20 #define MS_WIN(addr) (addr & 0x0ffc0000)
21 #define QLA82XX_PCI_MN_2M (0)
22 #define QLA82XX_PCI_MS_2M (0x80000)
23 #define QLA82XX_PCI_OCM0_2M (0xc0000)
24 #define VALID_OCM_ADDR(addr) (((addr) & 0x3f800) != 0x3f800)
28 #define CRB_BLK(off) ((off >> 20) & 0x3f)
29 #define CRB_SUBBLK(off) ((off >> 16) & 0xf)
30 #define CRB_WINDOW_2M (0x130060)
[all …]