Searched +full:0 +full:x002c0000 (Results 1 – 15 of 15) sorted by relevance
/linux/arch/powerpc/boot/dts/ |
H A D | o2i.dts | 16 flash@0,0 { 19 reg = <0x00060000 0x00260000>; 25 reg = <0x002c0000 0x00d40000>;
|
H A D | o2mnt.dts | 16 flash@0,0 { 19 reg = <0x00060000 0x00260000>; 25 reg = <0x002c0000 0x00d40000>;
|
H A D | o2dnt2.dts | 15 memory@0 { 16 reg = <0x00000000 0x08000000>; // 128MB 20 ranges = <0 0 0xfc000000 0x02000000 21 3 0 0xe3000000 0x00100000>; 23 flash@0,0 { 25 reg = <0 0 0x02000000>; 33 reg = <0x00060000 0x00260000>; 40 reg = <0x002c0000 0x01d40000>;
|
H A D | o2d.dts | 15 memory@0 { 16 reg = <0x00000000 0x08000000>; // 128MB 20 ranges = <0 0 0xfc000000 0x02000000 21 3 0 0xe3000000 0x00100000>; 23 flash@0,0 { 25 reg = <0 0 0x02000000>; 33 reg = <0x00060000 0x00260000>; 39 reg = <0x002c0000 0x01d40000>;
|
H A D | o3dnt.dts | 15 memory@0 { 16 reg = <0x00000000 0x04000000>; // 64MB 20 ranges = <0 0 0xfc000000 0x01000000 21 3 0 0xe3000000 0x00100000>; 23 flash@0,0 { 25 reg = <0 0 0x01000000>; 33 reg = <0x00060000 0x00260000>; 40 reg = <0x002c0000 0x00d40000>;
|
/linux/Documentation/devicetree/bindings/mtd/ |
H A D | ti,gpmc-onenand.yaml | 19 pattern: "^onenand@[0-9],[0,9]$" 38 "@[0-9a-f]+$": 56 reg = <0x6e000000 0x02d0>; 65 ranges = <0 0 0x01000000 0x01000000>, /* 16 MB for OneNAND */ 66 <1 0 0x02000000 0x01000000>; /* 16 MB for smc91c96 */ 68 onenand@0,0 { 70 reg = <0 0 0x20000>; /* CS0, offset 0, IO size 128K */ 74 partition@0 { 76 reg = <0x00000000 0x00100000>; 81 reg = <0x00100000 0x002c0000>;
|
/linux/arch/arm64/boot/dts/broadcom/northstar2/ |
H A D | ns2-xmc.dts | 47 bootargs = "earlycon=uart8250,mmio32,0x66130000"; 52 reg = <0x00000000 0x80000000 0x00000001 0x00000000>; 71 reg = <0x10>; 77 nandcs@0 { 79 reg = <0>; 88 partition@0 { 90 reg = <0x00000000 0x00280000>; /* 2.5MB */ 96 reg = <0x00280000 0x00040000>; /* 0.25MB */ 102 reg = <0x002c0000 0x00040000>; /* 0.25MB */ 108 reg = <0x00300000 0x03d00000>; /* 61MB */ [all …]
|
/linux/arch/mips/alchemy/ |
H A D | board-mtx1.c | 41 __asm__ __volatile__("jr\t%0" : : "r"(0xbfc00000)); in mtx1_reset() 57 alchemy_gpio_direction_output(204, 0); in board_setup() 64 alchemy_wrsys(~0, AU1000_SYS_TRIOUTCLR); in board_setup() 65 alchemy_gpio_direction_output(0, 0); /* Disable M66EN (PCI 66MHz) */ in board_setup() 68 alchemy_gpio_direction_output(5, 0); /* Disable eth PHY TX_ER */ in board_setup() 72 alchemy_gpio_direction_output(212, 0); /* red off */ in board_setup() 105 .dev_id = "mtx1-wdt.0", 115 .id = 0, 144 .size = 0x01C00000, 145 .offset = 0, [all …]
|
/linux/arch/arm/boot/dts/ti/omap/ |
H A D | omap3-n950-n9.dtsi | 12 cpu@0 { 19 reg = <0x80000000 0x40000000>; /* 1 GB */ 47 pinctrl-0 = <&debug_leds>; 54 #clock-cells = <0>; 62 OMAP3_CORE1_IOPAD(0x21da, PIN_INPUT | MUX_MODE4) /* mcspi2_somi.gpio_180 -> LIS302 INT1 */ 63 OMAP3_CORE1_IOPAD(0x21dc, PIN_INPUT | MUX_MODE4) /* mcspi2_cs0.gpio_181 -> LIS302 INT2 */ 69 OMAP3_CORE1_IOPAD(0x2108, PIN_OUTPUT | MUX_MODE4) /* dss_data22.gpio_92 */ 75 OMAP3_CORE1_IOPAD(0x2158, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_clk */ 76 OMAP3_CORE1_IOPAD(0x215a, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_cmd */ 77 OMAP3_CORE1_IOPAD(0x215c, PIN_INPUT_PULLUP | MUX_MODE0) /* sdmmc2_dat0 */ [all …]
|
H A D | am437x-gp-evm.dts | 57 pwms = <&ecap0 0 50000 PWM_POLARITY_INVERTED>; 58 brightness-levels = <0 51 53 56 62 75 101 152 255>; 68 pinctrl-0 = <&matrix_keypad_default>; 80 linux,keymap = <0x00000201 /* P1 */ 81 0x00010202 /* P2 */ 82 0x01000067 /* UP */ 83 0x0101006a /* RIGHT */ 84 0x02000069 /* LEFT */ 85 0x0201006c>; /* DOWN */ 103 #clock-cells = <0>; [all …]
|
H A D | omap3-n900.dts | 46 cpu@0 { 58 pinctrl-0 = <&debug_leds>; 64 reg = <0x80000000 0x10000000>; /* 256 MB */ 117 gpios = <&gpio6 0 GPIO_ACTIVE_LOW>; /* 160 */ 156 io-channels = <&twl_madc 0>, <&twl_madc 4>, <&twl_madc 12>; 164 ti,clock-source = <0x00>; /* timer_sys_ck */ 169 pwms = <&pwm9 0 26316 0>; /* 38000 Hz */ 181 #clock-cells = <0>; 190 pinctrl-0 = <&camera_pins>; 200 data-lanes = <0>; [all …]
|
/linux/drivers/video/fbdev/matrox/ |
H A D | matroxfb_Ti3026.c | 92 #define TVP3026_INDEX 0x00 93 #define TVP3026_PALWRADD 0x00 94 #define TVP3026_PALDATA 0x01 95 #define TVP3026_PIXRDMSK 0x02 96 #define TVP3026_PALRDADD 0x03 97 #define TVP3026_CURCOLWRADD 0x04 98 #define TVP3026_CLOVERSCAN 0x00 99 #define TVP3026_CLCOLOR0 0x01 100 #define TVP3026_CLCOLOR1 0x02 101 #define TVP3026_CLCOLOR2 0x03 [all …]
|
/linux/drivers/net/wan/ |
H A D | wanxlfw.S | 2 .psize 0 14 0x000 - 0x050 TX#0 0x050 - 0x140 RX#0 15 0x140 - 0x190 TX#1 0x190 - 0x280 RX#1 16 0x280 - 0x2D0 TX#2 0x2D0 - 0x3C0 RX#2 17 0x3C0 - 0x410 TX#3 0x410 - 0x500 RX#3 43 PCI9060_VECTOR = 0x0000006C 44 CPM_IRQ_BASE = 0x40 46 SCC1_VECTOR = (CPM_IRQ_BASE + 0x1E) * 4 47 SCC2_VECTOR = (CPM_IRQ_BASE + 0x1D) * 4 48 SCC3_VECTOR = (CPM_IRQ_BASE + 0x1C) * 4 [all …]
|
/linux/crypto/ |
H A D | aes_generic.c | 67 0xa56363c6, 0x847c7cf8, 0x997777ee, 0x8d7b7bf6, 68 0x0df2f2ff, 0xbd6b6bd6, 0xb16f6fde, 0x54c5c591, 69 0x50303060, 0x03010102, 0xa96767ce, 0x7d2b2b56, 70 0x19fefee7, 0x62d7d7b5, 0xe6abab4d, 0x9a7676ec, 71 0x45caca8f, 0x9d82821f, 0x40c9c989, 0x877d7dfa, 72 0x15fafaef, 0xeb5959b2, 0xc947478e, 0x0bf0f0fb, 73 0xecadad41, 0x67d4d4b3, 0xfda2a25f, 0xeaafaf45, 74 0xbf9c9c23, 0xf7a4a453, 0x967272e4, 0x5bc0c09b, 75 0xc2b7b775, 0x1cfdfde1, 0xae93933d, 0x6a26264c, 76 0x5a36366c, 0x413f3f7e, 0x02f7f7f5, 0x4fcccc83, [all …]
|
/linux/drivers/crypto/ |
H A D | hifn_795x.c | 34 #define ACRYPTO_OP_DECRYPT 0 39 #define ACRYPTO_MODE_ECB 0 44 #define ACRYPTO_TYPE_AES_128 0 50 #define PCI_VENDOR_ID_HIFN 0x13A3 51 #define PCI_DEVICE_ID_HIFN_7955 0x0020 52 #define PCI_DEVICE_ID_HIFN_7956 0x001d 56 #define HIFN_BAR0_SIZE 0x1000 57 #define HIFN_BAR1_SIZE 0x2000 58 #define HIFN_BAR2_SIZE 0x8000 62 #define HIFN_DMA_CRA 0x0C /* DMA Command Ring Address */ [all …]
|