1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * Copyright (c) 2011-2016 Zhang, Keguang <keguang.zhang@gmail.com>
4 */
5
6 #include <linux/clk.h>
7 #include <linux/dma-mapping.h>
8 #include <linux/err.h>
9 #include <linux/mtd/partitions.h>
10 #include <linux/sizes.h>
11 #include <linux/phy.h>
12 #include <linux/serial_8250.h>
13 #include <linux/stmmac.h>
14 #include <linux/usb/ehci_pdriver.h>
15
16 #include <platform.h>
17 #include <loongson1.h>
18
19 /* 8250/16550 compatible UART */
20 #define LS1X_UART(_id) \
21 { \
22 .mapbase = LS1X_UART ## _id ## _BASE, \
23 .irq = LS1X_UART ## _id ## _IRQ, \
24 .iotype = UPIO_MEM, \
25 .flags = UPF_IOREMAP | UPF_FIXED_TYPE, \
26 .type = PORT_16550A, \
27 }
28
29 static struct plat_serial8250_port ls1x_serial8250_pdata[] = {
30 LS1X_UART(0),
31 LS1X_UART(1),
32 LS1X_UART(2),
33 LS1X_UART(3),
34 {},
35 };
36
37 struct platform_device ls1x_uart_pdev = {
38 .name = "serial8250",
39 .id = PLAT8250_DEV_PLATFORM,
40 .dev = {
41 .platform_data = ls1x_serial8250_pdata,
42 },
43 };
44
ls1x_serial_set_uartclk(struct platform_device * pdev)45 void __init ls1x_serial_set_uartclk(struct platform_device *pdev)
46 {
47 struct clk *clk;
48 struct plat_serial8250_port *p;
49
50 clk = clk_get(&pdev->dev, pdev->name);
51 if (IS_ERR(clk)) {
52 pr_err("unable to get %s clock, err=%ld",
53 pdev->name, PTR_ERR(clk));
54 return;
55 }
56 clk_prepare_enable(clk);
57
58 for (p = pdev->dev.platform_data; p->flags != 0; ++p)
59 p->uartclk = clk_get_rate(clk);
60 }
61
62 /* Synopsys Ethernet GMAC */
63 static struct stmmac_mdio_bus_data ls1x_mdio_bus_data = {
64 .phy_mask = 0,
65 };
66
67 static struct stmmac_dma_cfg ls1x_eth_dma_cfg = {
68 .pbl = 1,
69 };
70
ls1x_eth_mux_init(struct platform_device * pdev,void * priv)71 int ls1x_eth_mux_init(struct platform_device *pdev, void *priv)
72 {
73 struct plat_stmmacenet_data *plat_dat = NULL;
74 u32 val;
75
76 val = __raw_readl(LS1X_MUX_CTRL1);
77
78 #if defined(CONFIG_LOONGSON1_LS1B)
79 plat_dat = dev_get_platdata(&pdev->dev);
80 if (plat_dat->bus_id) {
81 __raw_writel(__raw_readl(LS1X_MUX_CTRL0) | GMAC1_USE_UART1 |
82 GMAC1_USE_UART0, LS1X_MUX_CTRL0);
83 switch (plat_dat->phy_interface) {
84 case PHY_INTERFACE_MODE_RGMII:
85 val &= ~(GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
86 break;
87 case PHY_INTERFACE_MODE_MII:
88 val |= (GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
89 break;
90 default:
91 pr_err("unsupported mii mode %d\n",
92 plat_dat->phy_interface);
93 return -ENOTSUPP;
94 }
95 val &= ~GMAC1_SHUT;
96 } else {
97 switch (plat_dat->phy_interface) {
98 case PHY_INTERFACE_MODE_RGMII:
99 val &= ~(GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
100 break;
101 case PHY_INTERFACE_MODE_MII:
102 val |= (GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
103 break;
104 default:
105 pr_err("unsupported mii mode %d\n",
106 plat_dat->phy_interface);
107 return -ENOTSUPP;
108 }
109 val &= ~GMAC0_SHUT;
110 }
111 __raw_writel(val, LS1X_MUX_CTRL1);
112 #elif defined(CONFIG_LOONGSON1_LS1C)
113 plat_dat = dev_get_platdata(&pdev->dev);
114
115 val &= ~PHY_INTF_SELI;
116 if (plat_dat->phy_interface == PHY_INTERFACE_MODE_RMII)
117 val |= 0x4 << PHY_INTF_SELI_SHIFT;
118 __raw_writel(val, LS1X_MUX_CTRL1);
119
120 val = __raw_readl(LS1X_MUX_CTRL0);
121 __raw_writel(val & (~GMAC_SHUT), LS1X_MUX_CTRL0);
122 #endif
123
124 return 0;
125 }
126
127 static struct plat_stmmacenet_data ls1x_eth0_pdata = {
128 .bus_id = 0,
129 .phy_addr = -1,
130 #if defined(CONFIG_LOONGSON1_LS1B)
131 .phy_interface = PHY_INTERFACE_MODE_MII,
132 #elif defined(CONFIG_LOONGSON1_LS1C)
133 .phy_interface = PHY_INTERFACE_MODE_RMII,
134 #endif
135 .mdio_bus_data = &ls1x_mdio_bus_data,
136 .dma_cfg = &ls1x_eth_dma_cfg,
137 .has_gmac = 1,
138 .tx_coe = 1,
139 .rx_queues_to_use = 1,
140 .tx_queues_to_use = 1,
141 .init = ls1x_eth_mux_init,
142 };
143
144 static struct resource ls1x_eth0_resources[] = {
145 [0] = {
146 .start = LS1X_GMAC0_BASE,
147 .end = LS1X_GMAC0_BASE + SZ_64K - 1,
148 .flags = IORESOURCE_MEM,
149 },
150 [1] = {
151 .name = "macirq",
152 .start = LS1X_GMAC0_IRQ,
153 .flags = IORESOURCE_IRQ,
154 },
155 };
156
157 struct platform_device ls1x_eth0_pdev = {
158 .name = "stmmaceth",
159 .id = 0,
160 .num_resources = ARRAY_SIZE(ls1x_eth0_resources),
161 .resource = ls1x_eth0_resources,
162 .dev = {
163 .platform_data = &ls1x_eth0_pdata,
164 },
165 };
166
167 #ifdef CONFIG_LOONGSON1_LS1B
168 static struct plat_stmmacenet_data ls1x_eth1_pdata = {
169 .bus_id = 1,
170 .phy_addr = -1,
171 .phy_interface = PHY_INTERFACE_MODE_MII,
172 .mdio_bus_data = &ls1x_mdio_bus_data,
173 .dma_cfg = &ls1x_eth_dma_cfg,
174 .has_gmac = 1,
175 .tx_coe = 1,
176 .rx_queues_to_use = 1,
177 .tx_queues_to_use = 1,
178 .init = ls1x_eth_mux_init,
179 };
180
181 static struct resource ls1x_eth1_resources[] = {
182 [0] = {
183 .start = LS1X_GMAC1_BASE,
184 .end = LS1X_GMAC1_BASE + SZ_64K - 1,
185 .flags = IORESOURCE_MEM,
186 },
187 [1] = {
188 .name = "macirq",
189 .start = LS1X_GMAC1_IRQ,
190 .flags = IORESOURCE_IRQ,
191 },
192 };
193
194 struct platform_device ls1x_eth1_pdev = {
195 .name = "stmmaceth",
196 .id = 1,
197 .num_resources = ARRAY_SIZE(ls1x_eth1_resources),
198 .resource = ls1x_eth1_resources,
199 .dev = {
200 .platform_data = &ls1x_eth1_pdata,
201 },
202 };
203 #endif /* CONFIG_LOONGSON1_LS1B */
204
205 /* GPIO */
206 static struct resource ls1x_gpio0_resources[] = {
207 [0] = {
208 .start = LS1X_GPIO0_BASE,
209 .end = LS1X_GPIO0_BASE + SZ_4 - 1,
210 .flags = IORESOURCE_MEM,
211 },
212 };
213
214 struct platform_device ls1x_gpio0_pdev = {
215 .name = "ls1x-gpio",
216 .id = 0,
217 .num_resources = ARRAY_SIZE(ls1x_gpio0_resources),
218 .resource = ls1x_gpio0_resources,
219 };
220
221 static struct resource ls1x_gpio1_resources[] = {
222 [0] = {
223 .start = LS1X_GPIO1_BASE,
224 .end = LS1X_GPIO1_BASE + SZ_4 - 1,
225 .flags = IORESOURCE_MEM,
226 },
227 };
228
229 struct platform_device ls1x_gpio1_pdev = {
230 .name = "ls1x-gpio",
231 .id = 1,
232 .num_resources = ARRAY_SIZE(ls1x_gpio1_resources),
233 .resource = ls1x_gpio1_resources,
234 };
235
236 /* USB EHCI */
237 static u64 ls1x_ehci_dmamask = DMA_BIT_MASK(32);
238
239 static struct resource ls1x_ehci_resources[] = {
240 [0] = {
241 .start = LS1X_EHCI_BASE,
242 .end = LS1X_EHCI_BASE + SZ_32K - 1,
243 .flags = IORESOURCE_MEM,
244 },
245 [1] = {
246 .start = LS1X_EHCI_IRQ,
247 .flags = IORESOURCE_IRQ,
248 },
249 };
250
251 static struct usb_ehci_pdata ls1x_ehci_pdata = {
252 };
253
254 struct platform_device ls1x_ehci_pdev = {
255 .name = "ehci-platform",
256 .id = -1,
257 .num_resources = ARRAY_SIZE(ls1x_ehci_resources),
258 .resource = ls1x_ehci_resources,
259 .dev = {
260 .dma_mask = &ls1x_ehci_dmamask,
261 .platform_data = &ls1x_ehci_pdata,
262 },
263 };
264
265 /* Real Time Clock */
266 struct platform_device ls1x_rtc_pdev = {
267 .name = "ls1x-rtc",
268 .id = -1,
269 };
270
271 /* Watchdog */
272 static struct resource ls1x_wdt_resources[] = {
273 {
274 .start = LS1X_WDT_BASE,
275 .end = LS1X_WDT_BASE + SZ_16 - 1,
276 .flags = IORESOURCE_MEM,
277 },
278 };
279
280 struct platform_device ls1x_wdt_pdev = {
281 .name = "ls1x-wdt",
282 .id = -1,
283 .num_resources = ARRAY_SIZE(ls1x_wdt_resources),
284 .resource = ls1x_wdt_resources,
285 };
286