1 // SPDX-License-Identifier: GPL-2.0-only
2 /* Copyright (c) 2015-2016, The Linux Foundation. All rights reserved.
3 */
4
5 /* Qualcomm Technologies, Inc. QDF2432 EMAC SGMII Controller driver.
6 */
7
8 #include <linux/iopoll.h>
9 #include "emac.h"
10
11 /* EMAC_SGMII register offsets */
12 #define EMAC_SGMII_PHY_TX_PWR_CTRL 0x000C
13 #define EMAC_SGMII_PHY_LANE_CTRL1 0x0018
14 #define EMAC_SGMII_PHY_CDR_CTRL0 0x0058
15 #define EMAC_SGMII_PHY_POW_DWN_CTRL0 0x0080
16 #define EMAC_SGMII_PHY_RESET_CTRL 0x00a8
17 #define EMAC_SGMII_PHY_INTERRUPT_MASK 0x00b4
18
19 /* SGMII digital lane registers */
20 #define EMAC_SGMII_LN_DRVR_CTRL0 0x000C
21 #define EMAC_SGMII_LN_DRVR_TAP_EN 0x0018
22 #define EMAC_SGMII_LN_TX_MARGINING 0x001C
23 #define EMAC_SGMII_LN_TX_PRE 0x0020
24 #define EMAC_SGMII_LN_TX_POST 0x0024
25 #define EMAC_SGMII_LN_TX_BAND_MODE 0x0060
26 #define EMAC_SGMII_LN_LANE_MODE 0x0064
27 #define EMAC_SGMII_LN_PARALLEL_RATE 0x0078
28 #define EMAC_SGMII_LN_CML_CTRL_MODE0 0x00B8
29 #define EMAC_SGMII_LN_MIXER_CTRL_MODE0 0x00D0
30 #define EMAC_SGMII_LN_VGA_INITVAL 0x0134
31 #define EMAC_SGMII_LN_UCDR_FO_GAIN_MODE0 0x017C
32 #define EMAC_SGMII_LN_UCDR_SO_GAIN_MODE0 0x0188
33 #define EMAC_SGMII_LN_UCDR_SO_CONFIG 0x0194
34 #define EMAC_SGMII_LN_RX_BAND 0x019C
35 #define EMAC_SGMII_LN_RX_RCVR_PATH1_MODE0 0x01B8
36 #define EMAC_SGMII_LN_RSM_CONFIG 0x01F0
37 #define EMAC_SGMII_LN_SIGDET_ENABLES 0x0224
38 #define EMAC_SGMII_LN_SIGDET_CNTRL 0x0228
39 #define EMAC_SGMII_LN_SIGDET_DEGLITCH_CNTRL 0x022C
40 #define EMAC_SGMII_LN_RX_EN_SIGNAL 0x02A0
41 #define EMAC_SGMII_LN_RX_MISC_CNTRL0 0x02AC
42 #define EMAC_SGMII_LN_DRVR_LOGIC_CLKDIV 0x02BC
43
44 /* SGMII digital lane register values */
45 #define UCDR_STEP_BY_TWO_MODE0 BIT(7)
46 #define UCDR_xO_GAIN_MODE(x) ((x) & 0x7f)
47 #define UCDR_ENABLE BIT(6)
48 #define UCDR_SO_SATURATION(x) ((x) & 0x3f)
49
50 #define SIGDET_LP_BYP_PS4 BIT(7)
51 #define SIGDET_EN_PS0_TO_PS2 BIT(6)
52
53 #define TXVAL_VALID_INIT BIT(4)
54 #define KR_PCIGEN3_MODE BIT(0)
55
56 #define MAIN_EN BIT(0)
57
58 #define TX_MARGINING_MUX BIT(6)
59 #define TX_MARGINING(x) ((x) & 0x3f)
60
61 #define TX_PRE_MUX BIT(6)
62
63 #define TX_POST_MUX BIT(6)
64
65 #define CML_GEAR_MODE(x) (((x) & 7) << 3)
66 #define CML2CMOS_IBOOST_MODE(x) ((x) & 7)
67
68 #define MIXER_LOADB_MODE(x) (((x) & 0xf) << 2)
69 #define MIXER_DATARATE_MODE(x) ((x) & 3)
70
71 #define VGA_THRESH_DFE(x) ((x) & 0x3f)
72
73 #define SIGDET_LP_BYP_PS0_TO_PS2 BIT(5)
74 #define SIGDET_FLT_BYP BIT(0)
75
76 #define SIGDET_LVL(x) (((x) & 0xf) << 4)
77
78 #define SIGDET_DEGLITCH_CTRL(x) (((x) & 0xf) << 1)
79
80 #define DRVR_LOGIC_CLK_EN BIT(4)
81 #define DRVR_LOGIC_CLK_DIV(x) ((x) & 0xf)
82
83 #define PARALLEL_RATE_MODE0(x) ((x) & 0x3)
84
85 #define BAND_MODE0(x) ((x) & 0x3)
86
87 #define LANE_MODE(x) ((x) & 0x1f)
88
89 #define CDR_PD_SEL_MODE0(x) (((x) & 0x3) << 5)
90 #define BYPASS_RSM_SAMP_CAL BIT(1)
91 #define BYPASS_RSM_DLL_CAL BIT(0)
92
93 #define L0_RX_EQUALIZE_ENABLE BIT(6)
94
95 #define PWRDN_B BIT(0)
96
97 #define CDR_MAX_CNT(x) ((x) & 0xff)
98
99 #define SERDES_START_WAIT_TIMES 100
100
101 struct emac_reg_write {
102 unsigned int offset;
103 u32 val;
104 };
105
emac_reg_write_all(void __iomem * base,const struct emac_reg_write * itr,size_t size)106 static void emac_reg_write_all(void __iomem *base,
107 const struct emac_reg_write *itr, size_t size)
108 {
109 size_t i;
110
111 for (i = 0; i < size; ++itr, ++i)
112 writel(itr->val, base + itr->offset);
113 }
114
115 static const struct emac_reg_write sgmii_laned[] = {
116 /* CDR Settings */
117 {EMAC_SGMII_LN_UCDR_FO_GAIN_MODE0,
118 UCDR_STEP_BY_TWO_MODE0 | UCDR_xO_GAIN_MODE(10)},
119 {EMAC_SGMII_LN_UCDR_SO_GAIN_MODE0, UCDR_xO_GAIN_MODE(0)},
120 {EMAC_SGMII_LN_UCDR_SO_CONFIG, UCDR_ENABLE | UCDR_SO_SATURATION(12)},
121
122 /* TX/RX Settings */
123 {EMAC_SGMII_LN_RX_EN_SIGNAL, SIGDET_LP_BYP_PS4 | SIGDET_EN_PS0_TO_PS2},
124
125 {EMAC_SGMII_LN_DRVR_CTRL0, TXVAL_VALID_INIT | KR_PCIGEN3_MODE},
126 {EMAC_SGMII_LN_DRVR_TAP_EN, MAIN_EN},
127 {EMAC_SGMII_LN_TX_MARGINING, TX_MARGINING_MUX | TX_MARGINING(25)},
128 {EMAC_SGMII_LN_TX_PRE, TX_PRE_MUX},
129 {EMAC_SGMII_LN_TX_POST, TX_POST_MUX},
130
131 {EMAC_SGMII_LN_CML_CTRL_MODE0,
132 CML_GEAR_MODE(1) | CML2CMOS_IBOOST_MODE(1)},
133 {EMAC_SGMII_LN_MIXER_CTRL_MODE0,
134 MIXER_LOADB_MODE(12) | MIXER_DATARATE_MODE(1)},
135 {EMAC_SGMII_LN_VGA_INITVAL, VGA_THRESH_DFE(31)},
136 {EMAC_SGMII_LN_SIGDET_ENABLES,
137 SIGDET_LP_BYP_PS0_TO_PS2 | SIGDET_FLT_BYP},
138 {EMAC_SGMII_LN_SIGDET_CNTRL, SIGDET_LVL(8)},
139
140 {EMAC_SGMII_LN_SIGDET_DEGLITCH_CNTRL, SIGDET_DEGLITCH_CTRL(4)},
141 {EMAC_SGMII_LN_RX_MISC_CNTRL0, 0},
142 {EMAC_SGMII_LN_DRVR_LOGIC_CLKDIV,
143 DRVR_LOGIC_CLK_EN | DRVR_LOGIC_CLK_DIV(4)},
144
145 {EMAC_SGMII_LN_PARALLEL_RATE, PARALLEL_RATE_MODE0(1)},
146 {EMAC_SGMII_LN_TX_BAND_MODE, BAND_MODE0(2)},
147 {EMAC_SGMII_LN_RX_BAND, BAND_MODE0(3)},
148 {EMAC_SGMII_LN_LANE_MODE, LANE_MODE(26)},
149 {EMAC_SGMII_LN_RX_RCVR_PATH1_MODE0, CDR_PD_SEL_MODE0(3)},
150 {EMAC_SGMII_LN_RSM_CONFIG, BYPASS_RSM_SAMP_CAL | BYPASS_RSM_DLL_CAL},
151 };
152
153 static const struct emac_reg_write physical_coding_sublayer_programming[] = {
154 {EMAC_SGMII_PHY_POW_DWN_CTRL0, PWRDN_B},
155 {EMAC_SGMII_PHY_CDR_CTRL0, CDR_MAX_CNT(15)},
156 {EMAC_SGMII_PHY_TX_PWR_CTRL, 0},
157 {EMAC_SGMII_PHY_LANE_CTRL1, L0_RX_EQUALIZE_ENABLE},
158 };
159
emac_sgmii_init_qdf2432(struct emac_adapter * adpt)160 int emac_sgmii_init_qdf2432(struct emac_adapter *adpt)
161 {
162 struct emac_sgmii *phy = &adpt->phy;
163 void __iomem *phy_regs = phy->base;
164 void __iomem *laned = phy->digital;
165 unsigned int i;
166 u32 lnstatus;
167
168 /* PCS lane-x init */
169 emac_reg_write_all(phy->base, physical_coding_sublayer_programming,
170 ARRAY_SIZE(physical_coding_sublayer_programming));
171
172 /* SGMII lane-x init */
173 emac_reg_write_all(phy->digital, sgmii_laned, ARRAY_SIZE(sgmii_laned));
174
175 /* Power up PCS and start reset lane state machine */
176
177 writel(0, phy_regs + EMAC_SGMII_PHY_RESET_CTRL);
178 writel(1, laned + SGMII_LN_RSM_START);
179
180 /* Wait for c_ready assertion */
181 for (i = 0; i < SERDES_START_WAIT_TIMES; i++) {
182 lnstatus = readl(phy_regs + SGMII_PHY_LN_LANE_STATUS);
183 if (lnstatus & BIT(1))
184 break;
185 usleep_range(100, 200);
186 }
187
188 if (i == SERDES_START_WAIT_TIMES) {
189 netdev_err(adpt->netdev, "SGMII failed to start\n");
190 return -EIO;
191 }
192
193 /* Disable digital and SERDES loopback */
194 writel(0, phy_regs + SGMII_PHY_LN_BIST_GEN0);
195 writel(0, phy_regs + SGMII_PHY_LN_BIST_GEN2);
196 writel(0, phy_regs + SGMII_PHY_LN_CDR_CTRL1);
197
198 /* Mask out all the SGMII Interrupt */
199 writel(0, phy_regs + EMAC_SGMII_PHY_INTERRUPT_MASK);
200
201 return 0;
202 }
203