1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 Copyright (C) 2004 - 2009 Ivo van Doorn <IvDoorn@gmail.com>
4 <http://rt2x00.serialmonkey.com>
5
6 */
7
8 /*
9 Module: rt2x00lib
10 Abstract: rt2x00 generic configuration routines.
11 */
12
13 #include <linux/kernel.h>
14 #include <linux/module.h>
15
16 #include "rt2x00.h"
17 #include "rt2x00lib.h"
18
rt2x00lib_config_intf(struct rt2x00_dev * rt2x00dev,struct rt2x00_intf * intf,enum nl80211_iftype type,const u8 * mac,const u8 * bssid)19 void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev,
20 struct rt2x00_intf *intf,
21 enum nl80211_iftype type,
22 const u8 *mac, const u8 *bssid)
23 {
24 struct rt2x00intf_conf conf;
25 unsigned int flags = 0;
26
27 conf.type = type;
28
29 switch (type) {
30 case NL80211_IFTYPE_ADHOC:
31 conf.sync = TSF_SYNC_ADHOC;
32 break;
33 case NL80211_IFTYPE_AP:
34 case NL80211_IFTYPE_MESH_POINT:
35 conf.sync = TSF_SYNC_AP_NONE;
36 break;
37 case NL80211_IFTYPE_STATION:
38 conf.sync = TSF_SYNC_INFRA;
39 break;
40 default:
41 conf.sync = TSF_SYNC_NONE;
42 break;
43 }
44
45 /*
46 * Note that when NULL is passed as address we will send
47 * 00:00:00:00:00 to the device to clear the address.
48 * This will prevent the device being confused when it wants
49 * to ACK frames or considers itself associated.
50 */
51 memset(conf.mac, 0, sizeof(conf.mac));
52 if (mac)
53 memcpy(conf.mac, mac, ETH_ALEN);
54
55 memset(conf.bssid, 0, sizeof(conf.bssid));
56 if (bssid)
57 memcpy(conf.bssid, bssid, ETH_ALEN);
58
59 flags |= CONFIG_UPDATE_TYPE;
60 if (mac || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
61 flags |= CONFIG_UPDATE_MAC;
62 if (bssid || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count))
63 flags |= CONFIG_UPDATE_BSSID;
64
65 rt2x00dev->ops->lib->config_intf(rt2x00dev, intf, &conf, flags);
66 }
67
rt2x00lib_config_erp(struct rt2x00_dev * rt2x00dev,struct rt2x00_intf * intf,struct ieee80211_bss_conf * bss_conf,u32 changed)68 void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev,
69 struct rt2x00_intf *intf,
70 struct ieee80211_bss_conf *bss_conf,
71 u32 changed)
72 {
73 struct ieee80211_vif *vif = container_of(bss_conf, struct ieee80211_vif,
74 bss_conf);
75 struct rt2x00lib_erp erp;
76
77 memset(&erp, 0, sizeof(erp));
78
79 erp.short_preamble = bss_conf->use_short_preamble;
80 erp.cts_protection = bss_conf->use_cts_prot;
81
82 erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME;
83 erp.sifs = SIFS;
84 erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS;
85 erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS;
86 erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS;
87
88 erp.basic_rates = bss_conf->basic_rates;
89 erp.beacon_int = bss_conf->beacon_int;
90
91 /* Update the AID, this is needed for dynamic PS support */
92 rt2x00dev->aid = vif->cfg.assoc ? vif->cfg.aid : 0;
93 rt2x00dev->last_beacon = bss_conf->sync_tsf;
94
95 /* Update global beacon interval time, this is needed for PS support */
96 rt2x00dev->beacon_int = bss_conf->beacon_int;
97
98 if (changed & BSS_CHANGED_HT)
99 erp.ht_opmode = bss_conf->ht_operation_mode;
100
101 rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp, changed);
102 }
103
rt2x00lib_config_antenna(struct rt2x00_dev * rt2x00dev,struct antenna_setup config)104 void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
105 struct antenna_setup config)
106 {
107 struct link_ant *ant = &rt2x00dev->link.ant;
108 struct antenna_setup *def = &rt2x00dev->default_ant;
109 struct antenna_setup *active = &rt2x00dev->link.ant.active;
110
111 /*
112 * When the caller tries to send the SW diversity,
113 * we must update the ANTENNA_RX_DIVERSITY flag to
114 * enable the antenna diversity in the link tuner.
115 *
116 * Secondly, we must guarentee we never send the
117 * software antenna diversity command to the driver.
118 */
119 if (!(ant->flags & ANTENNA_RX_DIVERSITY)) {
120 if (config.rx == ANTENNA_SW_DIVERSITY) {
121 ant->flags |= ANTENNA_RX_DIVERSITY;
122
123 if (def->rx == ANTENNA_SW_DIVERSITY)
124 config.rx = ANTENNA_B;
125 else
126 config.rx = def->rx;
127 }
128 } else if (config.rx == ANTENNA_SW_DIVERSITY)
129 config.rx = active->rx;
130
131 if (!(ant->flags & ANTENNA_TX_DIVERSITY)) {
132 if (config.tx == ANTENNA_SW_DIVERSITY) {
133 ant->flags |= ANTENNA_TX_DIVERSITY;
134
135 if (def->tx == ANTENNA_SW_DIVERSITY)
136 config.tx = ANTENNA_B;
137 else
138 config.tx = def->tx;
139 }
140 } else if (config.tx == ANTENNA_SW_DIVERSITY)
141 config.tx = active->tx;
142
143 /*
144 * Antenna setup changes require the RX to be disabled,
145 * else the changes will be ignored by the device.
146 */
147 if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
148 rt2x00queue_stop_queue(rt2x00dev->rx);
149
150 /*
151 * Write new antenna setup to device and reset the link tuner.
152 * The latter is required since we need to recalibrate the
153 * noise-sensitivity ratio for the new setup.
154 */
155 rt2x00dev->ops->lib->config_ant(rt2x00dev, &config);
156
157 rt2x00link_reset_tuner(rt2x00dev, true);
158
159 memcpy(active, &config, sizeof(config));
160
161 if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
162 rt2x00queue_start_queue(rt2x00dev->rx);
163 }
164
rt2x00ht_center_channel(struct rt2x00_dev * rt2x00dev,struct ieee80211_conf * conf)165 static u16 rt2x00ht_center_channel(struct rt2x00_dev *rt2x00dev,
166 struct ieee80211_conf *conf)
167 {
168 struct hw_mode_spec *spec = &rt2x00dev->spec;
169 int center_channel;
170 u16 i;
171
172 /*
173 * Initialize center channel to current channel.
174 */
175 center_channel = spec->channels[conf->chandef.chan->hw_value].channel;
176
177 /*
178 * Adjust center channel to HT40+ and HT40- operation.
179 */
180 if (conf_is_ht40_plus(conf))
181 center_channel += 2;
182 else if (conf_is_ht40_minus(conf))
183 center_channel -= (center_channel == 14) ? 1 : 2;
184
185 for (i = 0; i < spec->num_channels; i++)
186 if (spec->channels[i].channel == center_channel)
187 return i;
188
189 WARN_ON(1);
190 return conf->chandef.chan->hw_value;
191 }
192
rt2x00lib_config(struct rt2x00_dev * rt2x00dev,struct ieee80211_conf * conf,unsigned int ieee80211_flags)193 void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
194 struct ieee80211_conf *conf,
195 unsigned int ieee80211_flags)
196 {
197 struct rt2x00lib_conf libconf;
198 u16 hw_value;
199 u16 autowake_timeout;
200 u16 beacon_int;
201 u16 beacon_diff;
202
203 memset(&libconf, 0, sizeof(libconf));
204
205 libconf.conf = conf;
206
207 if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) {
208 if (!conf_is_ht(conf))
209 set_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
210 else
211 clear_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags);
212
213 if (conf_is_ht40(conf)) {
214 set_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
215 hw_value = rt2x00ht_center_channel(rt2x00dev, conf);
216 } else {
217 clear_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags);
218 hw_value = conf->chandef.chan->hw_value;
219 }
220
221 memcpy(&libconf.rf,
222 &rt2x00dev->spec.channels[hw_value],
223 sizeof(libconf.rf));
224
225 memcpy(&libconf.channel,
226 &rt2x00dev->spec.channels_info[hw_value],
227 sizeof(libconf.channel));
228
229 /* Used for VCO periodic calibration */
230 rt2x00dev->rf_channel = libconf.rf.channel;
231 }
232
233 if (rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
234 (ieee80211_flags & IEEE80211_CONF_CHANGE_PS))
235 cancel_delayed_work_sync(&rt2x00dev->autowakeup_work);
236
237 /*
238 * Start configuration.
239 */
240 rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags);
241
242 if (conf->flags & IEEE80211_CONF_PS)
243 set_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
244 else
245 clear_bit(CONFIG_POWERSAVING, &rt2x00dev->flags);
246
247 if (conf->flags & IEEE80211_CONF_MONITOR)
248 set_bit(CONFIG_MONITORING, &rt2x00dev->flags);
249 else
250 clear_bit(CONFIG_MONITORING, &rt2x00dev->flags);
251
252 rt2x00dev->curr_band = conf->chandef.chan->band;
253 rt2x00dev->curr_freq = conf->chandef.chan->center_freq;
254 rt2x00dev->tx_power = conf->power_level;
255 rt2x00dev->short_retry = conf->short_frame_max_tx_count;
256 rt2x00dev->long_retry = conf->long_frame_max_tx_count;
257
258 /*
259 * Some configuration changes affect the link quality
260 * which means we need to reset the link tuner.
261 */
262 if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL)
263 rt2x00link_reset_tuner(rt2x00dev, false);
264
265 if (test_bit(DEVICE_STATE_PRESENT, &rt2x00dev->flags) &&
266 rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) &&
267 (ieee80211_flags & IEEE80211_CONF_CHANGE_PS) &&
268 (conf->flags & IEEE80211_CONF_PS)) {
269 beacon_diff = (long)jiffies - (long)rt2x00dev->last_beacon;
270 beacon_int = msecs_to_jiffies(rt2x00dev->beacon_int);
271
272 if (beacon_diff > beacon_int)
273 beacon_diff = 0;
274
275 autowake_timeout = (conf->ps_dtim_period * beacon_int) - beacon_diff;
276 queue_delayed_work(rt2x00dev->workqueue,
277 &rt2x00dev->autowakeup_work,
278 autowake_timeout - 15);
279 }
280 }
281