1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Copyright (c) 2011 Samsung Electronics Co., Ltd 4 * http://www.samsung.com 5 */ 6 7 #ifndef __LINUX_MFD_SEC_CORE_H 8 #define __LINUX_MFD_SEC_CORE_H 9 10 /* Macros to represent minimum voltages for LDO/BUCK */ 11 #define MIN_3000_MV 3000000 12 #define MIN_2500_MV 2500000 13 #define MIN_2000_MV 2000000 14 #define MIN_1800_MV 1800000 15 #define MIN_1500_MV 1500000 16 #define MIN_1400_MV 1400000 17 #define MIN_1000_MV 1000000 18 19 #define MIN_900_MV 900000 20 #define MIN_850_MV 850000 21 #define MIN_800_MV 800000 22 #define MIN_750_MV 750000 23 #define MIN_650_MV 650000 24 #define MIN_600_MV 600000 25 #define MIN_500_MV 500000 26 27 /* Ramp delay in uV/us */ 28 #define RAMP_DELAY_12_MVUS 12000 29 30 /* Macros to represent steps for LDO/BUCK */ 31 #define STEP_50_MV 50000 32 #define STEP_25_MV 25000 33 #define STEP_12_5_MV 12500 34 #define STEP_6_25_MV 6250 35 36 struct gpio_desc; 37 38 enum sec_device_type { 39 S5M8767X, 40 S2DOS05, 41 S2MPA01, 42 S2MPS11X, 43 S2MPS13X, 44 S2MPS14X, 45 S2MPS15X, 46 S2MPU02, 47 }; 48 49 /** 50 * struct sec_pmic_dev - s2m/s5m master device for sub-drivers 51 * @dev: Master device of the chip 52 * @pdata: Platform data populated with data from DTS 53 * or board files 54 * @regmap_pmic: Regmap associated with PMIC's I2C address 55 * @i2c: I2C client of the main driver 56 * @device_type: Type of device, matches enum sec_device_type 57 * @irq_base: Base IRQ number for device, required for IRQs 58 * @irq: Generic IRQ number for device 59 * @irq_data: Runtime data structure for IRQ controller 60 * @wakeup: Whether or not this is a wakeup device 61 */ 62 struct sec_pmic_dev { 63 struct device *dev; 64 struct sec_platform_data *pdata; 65 struct regmap *regmap_pmic; 66 struct i2c_client *i2c; 67 68 unsigned long device_type; 69 int irq; 70 struct regmap_irq_chip_data *irq_data; 71 }; 72 73 int sec_irq_init(struct sec_pmic_dev *sec_pmic); 74 void sec_irq_exit(struct sec_pmic_dev *sec_pmic); 75 int sec_irq_resume(struct sec_pmic_dev *sec_pmic); 76 77 struct sec_platform_data { 78 struct sec_regulator_data *regulators; 79 struct sec_opmode_data *opmode; 80 int num_regulators; 81 82 int buck_gpios[3]; 83 int buck_ds[3]; 84 unsigned int buck2_voltage[8]; 85 bool buck2_gpiodvs; 86 unsigned int buck3_voltage[8]; 87 bool buck3_gpiodvs; 88 unsigned int buck4_voltage[8]; 89 bool buck4_gpiodvs; 90 91 int buck_default_idx; 92 int buck_ramp_delay; 93 94 bool buck2_ramp_enable; 95 bool buck3_ramp_enable; 96 bool buck4_ramp_enable; 97 98 int buck2_init; 99 int buck3_init; 100 int buck4_init; 101 /* Whether or not manually set PWRHOLD to low during shutdown. */ 102 bool manual_poweroff; 103 /* Disable the WRSTBI (buck voltage warm reset) when probing? */ 104 bool disable_wrstbi; 105 }; 106 107 /** 108 * sec_regulator_data - regulator data 109 * @id: regulator id 110 * @initdata: regulator init data (contraints, supplies, ...) 111 */ 112 struct sec_regulator_data { 113 int id; 114 struct regulator_init_data *initdata; 115 struct device_node *reg_node; 116 struct gpio_desc *ext_control_gpiod; 117 }; 118 119 /* 120 * sec_opmode_data - regulator operation mode data 121 * @id: regulator id 122 * @mode: regulator operation mode 123 */ 124 struct sec_opmode_data { 125 int id; 126 unsigned int mode; 127 }; 128 129 /* 130 * samsung regulator operation mode 131 * SEC_OPMODE_OFF Regulator always OFF 132 * SEC_OPMODE_ON Regulator always ON 133 * SEC_OPMODE_LOWPOWER Regulator is on in low-power mode 134 * SEC_OPMODE_SUSPEND Regulator is changed by PWREN pin 135 * If PWREN is high, regulator is on 136 * If PWREN is low, regulator is off 137 */ 138 139 enum sec_opmode { 140 SEC_OPMODE_OFF, 141 SEC_OPMODE_ON, 142 SEC_OPMODE_LOWPOWER, 143 SEC_OPMODE_SUSPEND, 144 }; 145 146 #endif /* __LINUX_MFD_SEC_CORE_H */ 147