1 // SPDX-License-Identifier: GPL-2.0-only
2 /*
3 *
4 * Copyright © 2012 John Crispin <john@phrozen.org>
5 * Copyright © 2016 Hauke Mehrtens <hauke@hauke-m.de>
6 */
7
8 #include <linux/mtd/rawnand.h>
9 #include <linux/of.h>
10 #include <linux/platform_device.h>
11
12 #include <lantiq_soc.h>
13
14 /* nand registers */
15 #define EBU_ADDSEL1 0x24
16 #define EBU_NAND_CON 0xB0
17 #define EBU_NAND_WAIT 0xB4
18 #define NAND_WAIT_RD BIT(0) /* NAND flash status output */
19 #define NAND_WAIT_WR_C BIT(3) /* NAND Write/Read complete */
20 #define EBU_NAND_ECC0 0xB8
21 #define EBU_NAND_ECC_AC 0xBC
22
23 /*
24 * nand commands
25 * The pins of the NAND chip are selected based on the address bits of the
26 * "register" read and write. There are no special registers, but an
27 * address range and the lower address bits are used to activate the
28 * correct line. For example when the bit (1 << 2) is set in the address
29 * the ALE pin will be activated.
30 */
31 #define NAND_CMD_ALE BIT(2) /* address latch enable */
32 #define NAND_CMD_CLE BIT(3) /* command latch enable */
33 #define NAND_CMD_CS BIT(4) /* chip select */
34 #define NAND_CMD_SE BIT(5) /* spare area access latch */
35 #define NAND_CMD_WP BIT(6) /* write protect */
36 #define NAND_WRITE_CMD (NAND_CMD_CS | NAND_CMD_CLE)
37 #define NAND_WRITE_ADDR (NAND_CMD_CS | NAND_CMD_ALE)
38 #define NAND_WRITE_DATA (NAND_CMD_CS)
39 #define NAND_READ_DATA (NAND_CMD_CS)
40
41 /* we need to tel the ebu which addr we mapped the nand to */
42 #define ADDSEL1_MASK(x) (x << 4)
43 #define ADDSEL1_REGEN 1
44
45 /* we need to tell the EBU that we have nand attached and set it up properly */
46 #define BUSCON1_SETUP (1 << 22)
47 #define BUSCON1_BCGEN_RES (0x3 << 12)
48 #define BUSCON1_WAITWRC2 (2 << 8)
49 #define BUSCON1_WAITRDC2 (2 << 6)
50 #define BUSCON1_HOLDC1 (1 << 4)
51 #define BUSCON1_RECOVC1 (1 << 2)
52 #define BUSCON1_CMULT4 1
53
54 #define NAND_CON_CE (1 << 20)
55 #define NAND_CON_OUT_CS1 (1 << 10)
56 #define NAND_CON_IN_CS1 (1 << 8)
57 #define NAND_CON_PRE_P (1 << 7)
58 #define NAND_CON_WP_P (1 << 6)
59 #define NAND_CON_SE_P (1 << 5)
60 #define NAND_CON_CS_P (1 << 4)
61 #define NAND_CON_CSMUX (1 << 1)
62 #define NAND_CON_NANDM 1
63
64 struct xway_nand_data {
65 struct nand_controller controller;
66 struct nand_chip chip;
67 unsigned long csflags;
68 void __iomem *nandaddr;
69 };
70
xway_readb(struct mtd_info * mtd,int op)71 static u8 xway_readb(struct mtd_info *mtd, int op)
72 {
73 struct nand_chip *chip = mtd_to_nand(mtd);
74 struct xway_nand_data *data = nand_get_controller_data(chip);
75
76 return readb(data->nandaddr + op);
77 }
78
xway_writeb(struct mtd_info * mtd,int op,u8 value)79 static void xway_writeb(struct mtd_info *mtd, int op, u8 value)
80 {
81 struct nand_chip *chip = mtd_to_nand(mtd);
82 struct xway_nand_data *data = nand_get_controller_data(chip);
83
84 writeb(value, data->nandaddr + op);
85 }
86
xway_select_chip(struct nand_chip * chip,int select)87 static void xway_select_chip(struct nand_chip *chip, int select)
88 {
89 struct xway_nand_data *data = nand_get_controller_data(chip);
90
91 switch (select) {
92 case -1:
93 ltq_ebu_w32_mask(NAND_CON_CE, 0, EBU_NAND_CON);
94 ltq_ebu_w32_mask(NAND_CON_NANDM, 0, EBU_NAND_CON);
95 spin_unlock_irqrestore(&ebu_lock, data->csflags);
96 break;
97 case 0:
98 spin_lock_irqsave(&ebu_lock, data->csflags);
99 ltq_ebu_w32_mask(0, NAND_CON_NANDM, EBU_NAND_CON);
100 ltq_ebu_w32_mask(0, NAND_CON_CE, EBU_NAND_CON);
101 break;
102 default:
103 BUG();
104 }
105 }
106
xway_cmd_ctrl(struct nand_chip * chip,int cmd,unsigned int ctrl)107 static void xway_cmd_ctrl(struct nand_chip *chip, int cmd, unsigned int ctrl)
108 {
109 struct mtd_info *mtd = nand_to_mtd(chip);
110
111 if (cmd == NAND_CMD_NONE)
112 return;
113
114 if (ctrl & NAND_CLE)
115 xway_writeb(mtd, NAND_WRITE_CMD, cmd);
116 else if (ctrl & NAND_ALE)
117 xway_writeb(mtd, NAND_WRITE_ADDR, cmd);
118
119 while ((ltq_ebu_r32(EBU_NAND_WAIT) & NAND_WAIT_WR_C) == 0)
120 ;
121 }
122
xway_dev_ready(struct nand_chip * chip)123 static int xway_dev_ready(struct nand_chip *chip)
124 {
125 return ltq_ebu_r32(EBU_NAND_WAIT) & NAND_WAIT_RD;
126 }
127
xway_read_byte(struct nand_chip * chip)128 static unsigned char xway_read_byte(struct nand_chip *chip)
129 {
130 return xway_readb(nand_to_mtd(chip), NAND_READ_DATA);
131 }
132
xway_read_buf(struct nand_chip * chip,u_char * buf,int len)133 static void xway_read_buf(struct nand_chip *chip, u_char *buf, int len)
134 {
135 int i;
136
137 for (i = 0; i < len; i++)
138 buf[i] = xway_readb(nand_to_mtd(chip), NAND_WRITE_DATA);
139 }
140
xway_write_buf(struct nand_chip * chip,const u_char * buf,int len)141 static void xway_write_buf(struct nand_chip *chip, const u_char *buf, int len)
142 {
143 int i;
144
145 for (i = 0; i < len; i++)
146 xway_writeb(nand_to_mtd(chip), NAND_WRITE_DATA, buf[i]);
147 }
148
xway_attach_chip(struct nand_chip * chip)149 static int xway_attach_chip(struct nand_chip *chip)
150 {
151 if (chip->ecc.engine_type == NAND_ECC_ENGINE_TYPE_SOFT &&
152 chip->ecc.algo == NAND_ECC_ALGO_UNKNOWN)
153 chip->ecc.algo = NAND_ECC_ALGO_HAMMING;
154
155 return 0;
156 }
157
158 static const struct nand_controller_ops xway_nand_ops = {
159 .attach_chip = xway_attach_chip,
160 };
161
162 /*
163 * Probe for the NAND device.
164 */
xway_nand_probe(struct platform_device * pdev)165 static int xway_nand_probe(struct platform_device *pdev)
166 {
167 struct xway_nand_data *data;
168 struct mtd_info *mtd;
169 int err;
170 u32 cs;
171 u32 cs_flag = 0;
172
173 /* Allocate memory for the device structure (and zero it) */
174 data = devm_kzalloc(&pdev->dev, sizeof(struct xway_nand_data),
175 GFP_KERNEL);
176 if (!data)
177 return -ENOMEM;
178
179 data->nandaddr = devm_platform_ioremap_resource(pdev, 0);
180 if (IS_ERR(data->nandaddr))
181 return PTR_ERR(data->nandaddr);
182
183 nand_set_flash_node(&data->chip, pdev->dev.of_node);
184 mtd = nand_to_mtd(&data->chip);
185 mtd->dev.parent = &pdev->dev;
186
187 data->chip.legacy.cmd_ctrl = xway_cmd_ctrl;
188 data->chip.legacy.dev_ready = xway_dev_ready;
189 data->chip.legacy.select_chip = xway_select_chip;
190 data->chip.legacy.write_buf = xway_write_buf;
191 data->chip.legacy.read_buf = xway_read_buf;
192 data->chip.legacy.read_byte = xway_read_byte;
193 data->chip.legacy.chip_delay = 30;
194
195 nand_controller_init(&data->controller);
196 data->controller.ops = &xway_nand_ops;
197 data->chip.controller = &data->controller;
198
199 platform_set_drvdata(pdev, data);
200 nand_set_controller_data(&data->chip, data);
201
202 /* load our CS from the DT. Either we find a valid 1 or default to 0 */
203 err = of_property_read_u32(pdev->dev.of_node, "lantiq,cs", &cs);
204 if (!err && cs == 1)
205 cs_flag = NAND_CON_IN_CS1 | NAND_CON_OUT_CS1;
206
207 /* setup the EBU to run in NAND mode on our base addr */
208 ltq_ebu_w32(CPHYSADDR(data->nandaddr)
209 | ADDSEL1_MASK(3) | ADDSEL1_REGEN, EBU_ADDSEL1);
210
211 ltq_ebu_w32(BUSCON1_SETUP | BUSCON1_BCGEN_RES | BUSCON1_WAITWRC2
212 | BUSCON1_WAITRDC2 | BUSCON1_HOLDC1 | BUSCON1_RECOVC1
213 | BUSCON1_CMULT4, LTQ_EBU_BUSCON1);
214
215 ltq_ebu_w32(NAND_CON_NANDM | NAND_CON_CSMUX | NAND_CON_CS_P
216 | NAND_CON_SE_P | NAND_CON_WP_P | NAND_CON_PRE_P
217 | cs_flag, EBU_NAND_CON);
218
219 /*
220 * This driver assumes that the default ECC engine should be TYPE_SOFT.
221 * Set ->engine_type before registering the NAND devices in order to
222 * provide a driver specific default value.
223 */
224 data->chip.ecc.engine_type = NAND_ECC_ENGINE_TYPE_SOFT;
225
226 /* Scan to find existence of the device */
227 err = nand_scan(&data->chip, 1);
228 if (err)
229 return err;
230
231 err = mtd_device_register(mtd, NULL, 0);
232 if (err)
233 nand_cleanup(&data->chip);
234
235 return err;
236 }
237
238 /*
239 * Remove a NAND device.
240 */
xway_nand_remove(struct platform_device * pdev)241 static void xway_nand_remove(struct platform_device *pdev)
242 {
243 struct xway_nand_data *data = platform_get_drvdata(pdev);
244 struct nand_chip *chip = &data->chip;
245 int ret;
246
247 ret = mtd_device_unregister(nand_to_mtd(chip));
248 WARN_ON(ret);
249 nand_cleanup(chip);
250 }
251
252 static const struct of_device_id xway_nand_match[] = {
253 { .compatible = "lantiq,nand-xway" },
254 {},
255 };
256
257 static struct platform_driver xway_nand_driver = {
258 .probe = xway_nand_probe,
259 .remove_new = xway_nand_remove,
260 .driver = {
261 .name = "lantiq,nand-xway",
262 .of_match_table = xway_nand_match,
263 },
264 };
265
266 builtin_platform_driver(xway_nand_driver);
267