xref: /linux/include/linux/mfd/altera-a10sr.h (revision 75bf465f0bc33e9b776a46d6a1b9b990f5fb7c37)
1 /* SPDX-License-Identifier: GPL-2.0-only */
2 /*
3  * Copyright Intel Corporation (C) 2014-2016. All Rights Reserved
4  *
5  * Declarations for Altera Arria10 MAX5 System Resource Chip
6  *
7  * Adapted from DA9052
8  */
9 
10 #ifndef __MFD_ALTERA_A10SR_H
11 #define __MFD_ALTERA_A10SR_H
12 
13 #include <linux/completion.h>
14 #include <linux/list.h>
15 #include <linux/mfd/core.h>
16 #include <linux/regmap.h>
17 #include <linux/slab.h>
18 
19 /* Write registers are always on even addresses */
20 #define  WRITE_REG_MASK              0xFE
21 /* Odd registers are always on odd addresses */
22 #define  READ_REG_MASK               0x01
23 
24 #define ALTR_A10SR_BITS_PER_REGISTER  8
25 /*
26  * To find the correct register, we divide the input GPIO by
27  * the number of GPIO in each register. We then need to multiply
28  * by 2 because the reads are at odd addresses.
29  */
30 #define ALTR_A10SR_REG_OFFSET(X)     (((X) / ALTR_A10SR_BITS_PER_REGISTER) << 1)
31 #define ALTR_A10SR_REG_BIT(X)        ((X) % ALTR_A10SR_BITS_PER_REGISTER)
32 #define ALTR_A10SR_REG_BIT_CHG(X, Y) ((X) << ALTR_A10SR_REG_BIT(Y))
33 #define ALTR_A10SR_REG_BIT_MASK(X)   (1 << ALTR_A10SR_REG_BIT(X))
34 
35 /* Arria10 System Controller Register Defines */
36 #define ALTR_A10SR_NOP                0x00    /* No Change */
37 #define ALTR_A10SR_VERSION_READ       0x00    /* MAX5 Version Read */
38 
39 #define ALTR_A10SR_LED_REG            0x02    /* LED - Upper 4 bits */
40 /* LED register Bit Definitions */
41 #define ALTR_A10SR_LED_VALID_SHIFT        4       /* LED - Upper 4 bits valid */
42 #define ALTR_A10SR_OUT_VALID_RANGE_LO     ALTR_A10SR_LED_VALID_SHIFT
43 #define ALTR_A10SR_OUT_VALID_RANGE_HI     7
44 
45 #define ALTR_A10SR_PBDSW_REG          0x04    /* PB & DIP SW - Input only */
46 #define ALTR_A10SR_PBDSW_IRQ_REG      0x06    /* PB & DIP SW Flag Clear */
47 /* Pushbutton & DIP Switch Bit Definitions */
48 #define ALTR_A10SR_IN_VALID_RANGE_LO      8
49 #define ALTR_A10SR_IN_VALID_RANGE_HI      15
50 
51 #define ALTR_A10SR_PWR_GOOD1_REG      0x08    /* Power Good1 Read */
52 #define ALTR_A10SR_PWR_GOOD2_REG      0x0A    /* Power Good2 Read */
53 #define ALTR_A10SR_PWR_GOOD3_REG      0x0C    /* Power Good3 Read */
54 #define ALTR_A10SR_FMCAB_REG          0x0E    /* FMCA/B & PCIe Pwr Enable */
55 #define ALTR_A10SR_HPS_RST_REG        0x10    /* HPS Reset */
56 #define ALTR_A10SR_USB_QSPI_REG       0x12    /* USB, BQSPI, FILE Reset */
57 #define ALTR_A10SR_SFPA_REG           0x14    /* SFPA Control Reg */
58 #define ALTR_A10SR_SFPB_REG           0x16    /* SFPB Control Reg */
59 #define ALTR_A10SR_I2C_M_REG          0x18    /* I2C Master Select */
60 #define ALTR_A10SR_WARM_RST_REG       0x1A    /* HPS Warm Reset */
61 #define ALTR_A10SR_WR_KEY_REG         0x1C    /* HPS Warm Reset Key */
62 #define ALTR_A10SR_PMBUS_REG          0x1E    /* HPS PM Bus */
63 
64 /**
65  * struct altr_a10sr - Altera Max5 MFD device private data structure
66  * @dev:  : this device
67  * @regmap: the regmap assigned to the parent device.
68  */
69 struct altr_a10sr {
70 	struct device *dev;
71 	struct regmap *regmap;
72 };
73 
74 #endif /* __MFD_ALTERA_A10SR_H */
75