Lines Matching full:packets

170 	# are only tx_hi and rx_hi counters, which are used to count packets
173 	# On the ingress path, packets seem to get high priority status
178 	# it seems that the switch considers packets as high priority on the
180 	# egress path, the switch considers packets as high priority if
199 				       '.[0].stats64.rx.packets')
203 				       '.[0].stats64.tx.packets')
210 	# For the testis with ipv4 or ipv6, use icmp response packets,
235 				      '.[0].stats64.rx.packets')
239 				      '.[0].stats64.tx.packets')
251 	# Test if any packets were received on swp1, we will rx before and after
253 		echo "Not expected amount of received packets on ${swp1}"
258 	# Test if any packets were transmitted on swp2, we will tx before and after
260 		echo "Not expected amount of transmitted packets on ${swp2}"
275 			echo "Not expected amount of high priority packets received on ${swp1}"
281 			echo "Unexpected amount of high priority packets received on ${swp1}"
291 			echo "Not expected amount of high priority packets transmitted on ${swp2}"
297 			echo "Unexpected amount of high priority packets transmitted on ${swp2}"
411 	# No high priority packets should be received or transmitted.
421 	# Test with apptrust sources disabled, Packets should get port default
428 	# If PCP is enabled, packets should get PCP priority, which is not
430 	# priority packets should be received or transmitted.
436 	# If DSCP is enabled, packets should get DSCP priority which is set to 7
437 	# in this test. High priority packets should be received and transmitted.
444 	# so packets should get PCP priority. But in this test VLAN PCP is not
446 	# packets should be received and transmitted.
451 	# so packets should get VLAN PCP priority. Send packets with VLAN PCP
452 	# set to 0, DSCP set to 7. Packets should get VLAN PCP priority.
453 	# No high priority packets should be transmitted. Due to nature of the
454 	# switch, high priority packets will be received.
461 	# DSCP so packets should get VLAN PCP priority. Send packets with VLAN
462 	# PCP set to 7, DSCP set to 7. Packets should get VLAN PCP priority.
463 	# High priority packets should be received and transmitted.
469 	# priority is set to 0 and PCP priority is set to 7. Packets should get
470 	# PCP priority. High priority packets should be received and transmitted.
475 	# If both VLAN PCP and DSCP are set to 0, packets should get 0 priority.
476 	# No high priority packets should be received or transmitted.
629 			# Test if the DSCP priority is correctly applied to the packets