Lines Matching +full:rate +full:- +full:active +full:- +full:ms

1 /* SPDX-License-Identifier: (GPL-2.0-only OR BSD-3-Clause) */
43 /* mclk keep active */
45 /* bclk keep active */
47 /* fs keep active */
61 /* SSP Configuration Request - SOF_IPC_DAI_SSP_CONFIG */
88 	uint32_t bclk_delay;	/* guaranteed time (ms) for which BCLK
93 /* HDA Configuration Request - SOF_IPC_DAI_HDA_CONFIG */
97 	uint32_t rate;  member
101 /* ALH Configuration Request - SOF_IPC_DAI_ALH_CONFIG */
105 	uint32_t rate;  member
112 /* DMIC Configuration Request - SOF_IPC_DAI_DMIC_CONFIG */
155  * range 1.0 - 3.2 MHz is usually supported microphones. Some microphones are
156  * multi-mode capable and there may be denied mic clock frequencies between
158  * avoid the driver to set clock to an illegal rate.
160  * The duty cycle could be set to 48-52% if not known. Generally these
164  * The microphone clock needs to be usually about 50-80 times the used audio
165  * sample rate. With highest sample rates above 48 kHz this can relaxed
172  * will keep the clock active after capture stop if this time is not yet
173  * met. The unit for both is microseconds (us). Exceed of 100 ms will be
183 	uint32_t fifo_fs;	/**< FIFO sample rate in Hz (8000..96000) */
191 	uint32_t num_pdm_active; /**< Number of active pdm controllers. */
196 	uint32_t unmute_ramp_time;  /**< Length of logarithmic gain ramp (ms) */