Lines Matching +full:i2c +full:- +full:fast +full:- +full:mode
1 # SPDX-License-Identifier: GPL-2.0
13 Technologies USS-720 chip. These cables are plugged into your USB
17 The chip has two modes: automatic mode and manual mode. In automatic
18 mode, it looks to the computer like a standard USB printer. Only
19 printers may be connected to the USS-720 in this mode. The generic
21 that mode, and you can say N here if you want to use the chip only
22 in this mode.
24 Manual mode is not limited to printers, any parallel port
25 device should work. This driver utilizes manual mode.
30 Say Y here if you own an USS-720 USB->Parport cable and intend to
72 tristate "USB 7-Segment LED Display"
74 Say Y here if you have a USB 7-Segment Display by Delcom
107 driver supports the pre-programmed devices (incl. firmware)
108 by AK Modul-Bus Computer GmbH.
110 Please see: https://www.ak-modul-bus.de/stat/mikrocontroller.html
155 which reports VBUS attach/detach events and has USB-based
160 tristate "Fast charge control for iOS devices"
164 fast charge from the USB interface, as implemented in "MFi"
174 This adds support for Intel La Jolla Cove USB-I2C/SPI/GPIO
180 will be called usb-ljca.
237 See <http://www.linux-usb.org/usbtest/> for more information,
244 used for the USB-IF Embedded Host High-Speed Electrical Test procedure.
247 VID/PID pairs. This driver then initiates a corresponding test mode on
259 http://linux-uvc.berlios.de
269 USB port. The YUREX is a leg-shakes sensor. See
271 This driver supports read/write of leg-shakes counter and
285 depends on I2C
294 depends on I2C
301 depends on I2C
341 but need some non-trivial form of initialization, such as
353 depends on (USB_ONBOARD_DEV && I2C=y) || (USB_ONBOARD_DEV=m && I2C=m)
358 This options enables usb5744 i2c default initialization sequence
359 during hub start-up configuration stage. It is must to enable this
361 connected to USB-SD converter which mounts the root filesystem.