Lines Matching defs:configuration

707  * configuration or interface alt setting is selected.
829  * Device (USB_DT_DEVICE) and configuration descriptors (USB_DT_CONFIG)
883  * Strings may be referenced in device, configuration, interface, or other
1565  * Within any given configuration, each interface may have several
1577  * allocate bandwidth early, when a configuration is chosen.
1735  * @dev: the device whose configuration is being reset
1738  * the current configuration.  The effect is to reset most USB-related
1749  * configuration would affect other drivers' interfaces.
1777 	/* Disable LPM, and re-enable it once the configuration is reset, so
2018  * @dev: the device whose configuration is being updated
2019  * @configuration: the configuration being chosen.
2025  * configuration.
2027  * @configuration is the value of the configuration to be installed.
2028  * According to the USB spec (e.g. section 9.1.1.5), configuration values
2031  * configuration values.  To help manage such devices, this routine will
2032  * accept @configuration = -1 as indicating the device should be put in
2037  * the default configuration is limited to using 100mA of bus power,
2040  * non-default device configuration.  Other device modes may also be
2041  * reflected as configuration options, such as whether two ISDN
2058  * in the original device configuration has been destroyed, and each one
2059  * in the new configuration has been probed by all relevant usb device
2062 int usb_set_configuration(struct usb_device *dev, int configuration)
2070 	if (dev->authorized == 0 || configuration == -1)
2071 		configuration = 0;
2075 					configuration) {
2081 	if ((!cp && configuration != 0))
2084 	/* The USB spec says configuration 0 means unconfigured.
2085 	 * But if a device includes a configuration numbered 0,
2089 	if (cp && configuration == 0)
2118 					configuration, -i);
2136 	 * configuration.  Remove endpoints from the schedule if we're dropping
2137 	 * this configuration to set configuration 0.  After this point, the
2142 	/* Disable LPM, and re-enable it once the new configuration is
2197 					configuration, ifnum);
2210 				dev->devpath, configuration, ifnum);
2216 				   configuration, 0, NULL, 0,
2271 			dev_name(&intf->dev), configuration,
2317 /* Cancel pending Set-Config requests for a device whose configuration
2334  * @udev: the device whose configuration is being updated
2335  * @config: the configuration being chosen.