Lines Matching +full:built +full:- +full:in
1 # SPDX-License-Identifier: GPL-2.0-only
57 Say Y here to enable support for the battery charger in the Maxim
65 in the Wolfson Microelectronics WM831x PMICs.
100 This driver can be built as a module. If so, the module will be
104 tristate "Active-semi ACT8945A charger driver"
108 Active-semi ActivePath ACT8945A charger.
116 fuel gauge with custom firmware found in Pegatron Chagall based
119 This driver can also be built as a module. If so, the module will be
120 called chagall-battery.
136 battery fuel gauge (used in the Pinebook Pro & others)
138 This driver can also be built as a module. If so, the module will be
163 The battery monitor chip is used in many batteries/devices
170 tristate "DS2782/DS2786 standalone gas-gauge"
174 gas-gauge.
181 E Go, which is a sc8280xp-based 2-in-1 tablet.
184 called huawei-gaokun-battery.
227 These batteries are used in Samsung mobile phones.
230 tristate "Sharp SL-5500 (collie) battery"
234 SL-5500 (collie) models.
244 This driver can also be built as a module. If so, the module will be
245 called ingenic-battery.
264 Say Y to include support for SBS battery driver for SBS-compliant
285 This driver can also be built as a module. If so, the module will be
286 called sbs-manager.
315 Say Y here to enable devicetree monitored-battery config to update
319 general-purpose kernels, as this can cause misconfiguration of a
343 Integrated Charger & Fuel-Gauge IC.
345 This driver can also be built as a module. If so, the module will be
346 called da9150-charger.
352 Say Y here to enable support for the Fuel-Gauge unit of the DA9150
353 Integrated Charger & Fuel-Gauge IC
355 This driver can also be built as a module. If so, the module will be
356 called da9150-fg.
359 tristate "X-Powers AXP20X and AXP22X AC power supply driver"
364 Say Y here to enable support for X-Powers AXP20X and AXP22X PMICs' AC
367 This driver can also be built as a module. If so, the module will be
371 tristate "X-Powers AXP20X battery driver"
376 Say Y here to enable support for X-Powers AXP20X PMICs' battery power
379 This driver can also be built as a module. If so, the module will be
391 tristate "X-Powers AXP288 Charger"
394 Say yes here to have support X-Power AXP288 power management IC (PMIC)
398 tristate "X-Powers AXP288 Fuel Gauge"
401 Say yes here to have support for X-Power power management IC (PMIC)
411 Driver supports Maxim fuel-gauge systems for lithium-ion (Li+)
412 batteries used mainly in handheld and portable equipment.
417 voltage and configurable low-SOC wakeup interrupt.
426 MAX17042 is fuel-gauge systems for lithium-ion (Li+) batteries
427 in handheld and portable equipment. The MAX17042 is configured
429 multi-function devices that include fuel gauages that are compatible
441 MAX1720x is a family of fuel-gauge systems for lithium-ion (Li+)
442 batteries in handheld and portable equipment. MAX17201 are
449 tristate "MAX17211/MAX17215 standalone gas-gauge"
453 MAX1721x is fuel-gauge systems for lithium-ion (Li+) batteries
454 in handheld and portable equipment. MAX17211 used with single cell
459 battery gas-gauge.
475 tristate "Nokia RX-51 (N900) battery driver"
479 RX-51, also known as N900 tablet.
499 tristate "MAX8903 Battery DC-DC Charger for USB and Adapter Power"
501 Say Y to enable support for the MAX8903 DC-DC charger and sysfs.
502 The driver supports controlling charger-enable and current-limit
544 called gpio-charger.
551 Say Y to enable charger-manager support, which allows multiple
553 system. The charger-manager also can monitor charging status in
554 runtime and in suspend-to-RAM by waking up the system periodically
565 tristate "LTC4162-L charger"
570 LTC4162-L battery charger connected to I2C.
586 Revision 1.2 and can be found e.g. in Kindle 4/5th generation
613 The Maxim MAX77976 is a 19 Vin, 5.5A 1-Cell Li+ Battery Charger
617 This driver can also be built as a module. If so, the module will be
626 The MAX8971 is a compact, high-frequency, high-efficiency switch-mode
627 charger for a one-cell lithium-ion (Li+) battery. It delivers up to
632 This driver can also be built as a module. If so, the module will be
667 The device supports High-Accuracy Voltage/Current Regulation,
669 Over-Temperature Protection, DPDM Detection for BC1.2.
679 The device supports High-Accuracy Voltage/Current Regulation,
681 Over-Temperature Protection, DPDM Detection for BC1.2.
683 This driver can also be built as a module. If so, the module
684 will be called "mt6370-charger".
687 tristate "Qualcomm Switch-Mode Battery Charger and Boost"
693 Say Y to include support for the Switch-Mode Battery Charger and
694 Boost (SMBB) hardware found in Qualcomm PM8941 PMICs. The charger
695 is an integrated, single-cell lithium-ion battery charger. DT
701 tristate "Qualcomm PM8916 BMS-VM support"
704 Say Y to add support for Voltage Mode BMS block found in some
717 found in some Qualcomm PMICs such as PM8916. This hardware
731 RX-51/N900.
767 rail, ADC for battery and system monitoring, and push-button
794 BQ256XX family of devices are highly-integrated, switch-mode battery
796 cell Li-ion and Li-polymer batteries.
848 driver. Originated in the Android Studio Emulator (goldfish) it is
849 going to be used in other emulators.
856 This adds support for battery fuel gauge in Richtek RT5033 PMIC.
865 This adds support for battery charger in Richtek RT5033 PMIC.
866 The device supports pre-charge mode, fast charge mode and
885 RT9467 is a switch-mode single cell Li-Ion/Li-Polymer battery charger
887 power MOSFETs, input current sensing and regulation, high-accuracy
890 USB On-The-Go (OTG) support and integrates D+/D- pin for USB
893 This driver can also be built as a module. If so, the module
894 will be called "rt9467-charger".
904 highly-integrated switch mode battery charger which is system power
905 patch manageable device for single cell Li-Ion and Li-polymer battery.
909 This driver can also be built as a module. If so, the module will be
940 This driver can also be built as a module. If so, the module will be
941 called cros_charge-control.
992 information can be found in
993 Documentation/ABI/testing/sysfs-class-power-wilco
1002 This driver can also be built as a module. If so, the module will be
1012 tristate "Battery driver for 7th-generation Microsoft Surface devices"
1018 This driver provides battery-information and -status support for
1020 devices. On those models (7th-generation), battery-information is
1023 Say M or Y here to include battery status support for 7th-generation
1028 tristate "AC driver for 7th-generation Microsoft Surface devices"
1034 This driver provides AC-information and -status support for Surface
1036 On those models (7th-generation), AC-information is instead handled
1039 Say M or Y here to include AC status support for 7th-generation
1049 Note the uG3105 is not a full-featured autonomous fuel-gauge. Instead
1050 it is expected to be use in combination with some always on
1051 microcontroller reading its coulomb-counter before it can wrap
1054 Since Linux does not monitor coulomb-counter changes while the
1065 in PMI8998 and related PMICs.