Lines Matching +full:ocelot +full:- +full:sgpio

1 # SPDX-License-Identifier: GPL-2.0-only
66 	  will be called pinctrl-apple-gpio.
69 	bool "Axis ARTPEC-6 pin controller driver"
74 	  This is the driver for the Axis ARTPEC-6 pin controller. This driver
77 	  found in Documentation/devicetree/bindings/pinctrl/axis,artpec6-pinctrl.txt
86 	  functionality. This driver supports the pinmux, push-pull and
117 	tristate "X-Powers AXP209 PMIC pinctrl and GPIO Support"
141 	  The Awinic AW9523/AW9523B is a multi-function I2C GPIO
168 	  called pinctrl-cy8c95x0.
171 	tristate "TI DA850/OMAP-L138/AM18XX pull-up and pull-down groups"
176 	  Driver for TI DA850/OMAP-L138/AM18XX pinconf. Used to control
177 	  pull-up and pull-down pin groups.
236 	  is pin-dependent. Pin config is about bias & drive strength.
268 	  Add support for the Canaan Kendryte K210 RISC-V SOC Field
280 	  Add support for the Canaan Kendryte K230 RISC-V SOC pin controller.
296 	  It provides pin config functions such as pull-up, pull-down,
299 	  called as pinctrl-keembay.
313 	tristate "Pinctrl driver for the Loongson-2 SoC"
318 	 This selects pin control driver for the Loongson-2 SoC. It
319 	 provides pin config functions multiplexing.  GPIO pin pull-up,
320 	 pull-down functions are not supported. Say yes to enable
321 	 pinctrl for Loongson-2 SoC.
345 	  function in alternate mode. This driver also configure push-pull,
368 	  corresponding interrupt-controller.
390 	  pinctrl-microchip-sgpio.
393 	tristate "Pinctrl driver for the Microsemi Ocelot and Jaguar2 SoCs"
404 	  Support for the internal GPIO interfaces on Microsemi Ocelot and
407 	  If conpiled as a module, the module name will be pinctrl-ocelot.
416 	  functionality. This driver supports the pinmux, push-pull and
433 	  module will be called pinctrl-pef2256.
498 	tristate "One-register-per-pin type device tree based pinctrl driver"
522 	  Driver for STMicroelectronics Multi-Function eXpander (STMFX)
525 	  and configuring push-pull, open-drain, and can also be used as
526 	  interrupt-controller.
538 	  Say Y here to provide support for Semtech SX150x-series I2C
541 	  - 8 bits:  sx1508q, sx1502q
542 	  - 16 bits: sx1509q, sx1506q
563 	  called tps6594-pinctrl.
566 	tristate "Pinctrl driver for the T-Head TH1520 SoC"
574 	  T-Head TH1520 SoC.
576 	  This driver is needed for RISC-V development boards like
599 	  such as pull-up, slew rate, etc.
601 	  will be called pinctrl-zynqmp.
604 	tristate "NVIDIA BlueField-3 SoC Pinctrl driver"
610 	  Say Y to select the pinctrl driver for BlueField-3 SoCs.
613 	  pinctrl-mlxbf3.