Lines Matching +full:touch +full:- +full:overlay

1 # SPDX-License-Identifier: GPL-2.0
27 	  support for PCI-X and the foundations for PCI Express support.
46 	bool "Message Signaled Interrupts (MSI and MSI-X)"
82 	bool "Enable PCI resource re-allocation detection"
86 	  re-allocation needs to be enabled. You can always use pci=realloc=on
88 	  re-allocate PCI resources if SR-IOV BARs have not been allocated by
106 	  require SR-IOV support, while at the same time the PF (Physical
190 	bool "PCI peer-to-peer transfer support"
200 	  Enables drivers to do PCI peer-to-peer transactions to and from
202 	  the hierarchy where peer-to-peer DMA is guaranteed by the PCI
211 	  regions. For example - on a 46 bit system, the entropy goes down
223 	tristate "Hyper-V PCI Frontend"
237 	  PCI devices. Thus, the driver of this kind can load and overlay
250 	  support hotplug and peer-to-peer DMA.
253 	  at compile-time.  The choices are the same as those offered for
254 	  the kernel command-line parameter 'pci', i.e.,
258 	  This is a compile-time setting and can be overridden by the above
259 	  command-line parameters.  If unsure, choose PCIE_BUS_DEFAULT.
265 	  Use the BIOS defaults; don't touch MPS at all.  This is the same
278 	  Use largest MPS that boot-time devices support.  If you have a
299 	  hot-added devices or peer-to-peer DMA to fail.  Set MPS to the
300 	  smallest possible value (128B) system-wide to avoid these issues.
312 	  hard-decoded addresses as they did on ISA. When multiple PCI devices