Lines Matching +full:frame +full:- +full:number
1 /* SPDX-License-Identifier: BSD-3-Clause-Clear */
3 * Copyright (c) 2018-2021 The Linux Foundation. All rights reserved.
4 * Copyright (c) 2021-2025 Qualcomm Innovation Center, Inc. All rights reserved.
208 * The id of the reo exit ring where the msdu frame shall push
229 * Filter pass Unicast data frame (matching rxpcu_filter_pass
233 * Filter pass Multicast data frame (matching rxpcu_filter_pass
237 * Filter pass BAR frame (matching rxpcu_filter_pass
241 * Field only valid when for the received frame type the corresponding
245 * Field only valid when for the received frame type the corresponding
257 * field in address search failure cache-only entry should
261 * If set, intra-BSS routing detection is enabled
279 * buffer management for WiFi-to-PPE routing.
282 * by a different subsystem, completely disabling WiFi-to-PPE
306 * The PN number.
337 * When set, the BSSID of the incoming frame matched one of
341 * This number indicates which one out of the 8 BSSID register
342 * values matched the incoming frame
353 * Field indicates what the reason was that this mpdu frame
362 * When set, the received frame was an NDP frame, and thus
373 * Set when RXPCU detected a version error in the Frame control
377 * When set, AST based lookup for this frame has found a valid
432 * AND Fragment_flag is set. The fragment number from the 802.11 header
437 * received frame
442 * Set if the from DS bit is set in the frame control.
447 * Set if the to DS bit is set in the frame control.
452 * Protected bit from the frame control.
456 * Retry bit from the frame control. Only valid when first_msdu is set
461 * The sequence number from the 802.11 header.
490 * The number of delimiters before this MPDU. Note that this
491 * number is cleared at PPDU start. If this MPDU is the first
492 * received MPDU in the PPDU and this MPDU gets filtered-in,
493 * this field will indicate the number of delimiters located
497 * an PPDU, this field will indicate the number of delimiters
501 * Received frame was part of an A-MPDU.
504 * Received frame is a BAR frame
515 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
516 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
539 * Set if packet is not a non-QoS data frame. Only set when
543 * Set if frame type indicates either null data or QoS null
555 * Set if more bit in frame control is set. Only set when
567 * Set if the order bit in the frame control is set. Only
571 * U-APSD trigger frame
574 * Indicates that this data type frame is not encrypted even if
587 * Frame control field in header. Only valid when the field is marked valid.
593 * MAC addresses in the received frame. Only valid when corresponding
602 * RXOLE uses this to determine intra-BSS routing.
605 * Opaque service code between PPE and Wi-Fi
621 * data frames to multi-link addresses during decapsulation to eth/nwifi
624 * Multi-link receiver address1,2. Only valid when corresponding
628 * If not set, RXDMA shall perform error-routing for WDS packets
629 * as the sender is not authorized and might misuse WDS frame
896 * Field indicates what the reason was that this mpdu frame
915 * A-MPDU delimiter or the preamble length field for non-A-MPDU
922 * Classification failed due to truncated frame.
946 * of a dynamic A-MSDU when DA is compressed.
950 * of a dynamic A-MSDU when SA is compressed.
953 * The 16-bit type value indicating the type of L3 later
958 * TCP sequence number.
961 * TCP acknowledge number.
986 * Set if the to DS bit is set in the frame control.
1002 * Number of bytes padded to make sure that the L3 header will
1006 * Indicates the first MSDU of A-MSDU. If both first_msdu and
1007 * last_msdu are set in the MSDU then this is a non-aggregated MSDU
1008 * frame: normal MPDU. Interior MSDU in an A-MSDU shall have both
1012 * Indicates the last MSDU of the A-MSDU. MPDU end status is only
1016 * Set if the from DS bit is set in the frame control.
1038 * The id of the reo exit ring where the msdu frame shall push
1054 * Set by RXOLE if it stripped 4-bytes of C-VLAN Tag from the
1058 * Set by RXOLE if it stripped 4-bytes of S-VLAN Tag from the
1062 * Indicates that this is an 802.11 fragment frame. This is
1063 * set when either the more_frag bit is set in the frame control
1064 * or the fragment number is not zero. Only set when first_msdu
1079 * Number of MSDU's aggregated so far
1112 * A-MSDU could not be properly de-agregated.
1122 * Opaque service code between PPE and Wi-Fi
1128 * This packet needs intra-BSS routing by SW as the 'vdev_id'
1134 * to support intra-BSS routing with multi-chip multi-link
1162 * This field is still valid for MPDU frames without A-MSDU.
1191 * Indicates the MSDU number within a MPDU. This value is
1192 * reset to zero at the start of each MPDU. If the number of
1193 * MSDU exceeds 255 this number will wrap using modulo 256.
1215 * number is non-zero. If set indicates that this is a fragmented
1227 * 0 - Toeplitz hash of 2-tuple (IP source address, IP
1229 * 1 - Toeplitz hash of 4-tuple (IP source address,
1232 * 2 - Toeplitz of flow_id
1233 * 3 - Zero is used
1236 * Fixed 20-byte IPv4 header or 40-byte IPv6 header parsed
1245 * Fixed 20-byte TCP (excluding TCP options) or 8-byte UDP
1259 * 2 bytes of C-VLAN Tag Control Information from WHO_L2_LLC
1262 * 2 bytes of S-VLAN Tag Control Information from WHO_L2_LLC
1300 * 0 - spatial stream not used for this reception
1301 * 1 - spatial stream used for this reception
1307 * are all valid. This bit is in the last 64-bit of the descriptor
1311 * Toeplitz hash of 5-tuple
1313 * destination port, L4 protocol} in case of non-IPSec.
1315 * In case of IPSec - Toeplitz hash of 4-tuple
1334 * IPv4/IPv6 - Either, Toeplitz hash computed over 2-tuple
1336 * hash computed over 4-tuple IPv4 or IPv6 src/dest addresses
1339 * is the one used for hash-based REO routing (see use_flow_id_toeplitz_clfy
1348 * A-MPDU frame but a stand alone MPDU. Interior MPDU in an
1349 * A-MPDU shall have both first_mpdu and last_mpdu bits set to
1372 * Set if packet is not a non-QoS data frame. Only set when
1376 * Set if frame type indicates either null data or QoS null
1388 * Set if more bit in frame control is set. Only set when
1396 * Set if number of MSDUs in A-MSDU is above a threshold or if the
1401 * Set if the order bit in the frame control is set. Only
1405 * Indicates that the WiFi frame has one of the following errors
1418 * with the actually received number of bytes in the MPDU.
1437 * Indicates that an A-MSDU with 'from DS = 0' had an SA mismatching
1438 * TA or an A-MDU with 'to DS = 0' had a DA mismatching RA
1445 * Indicates that this data type frame is not encrypted even if
1461 * Indicates that the MPDU was pre-maturely terminated
1486 * Frame is received, but RXPCU could not update the receive bitmap