Lines Matching +full:sub +full:- +full:led
1 # SPDX-License-Identifier: GPL-2.0-only
58 tristate "Active-semi ACT8945A"
63 Support for the ACT8945A PMIC from Active-semi. This device
64 features three step-down DC/DC converters and four low-dropout
80 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
83 called sun4i-gpadc.
114 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
146 over at91-usart-serial driver and usart-spi-driver. Only one function
162 tristate "Atmel HLCDC (High-end LCD Controller)"
199 tristate "X-Powers AC100"
203 If you say Y here you get support for the X-Powers AC100 audio codec
214 tristate "X-Powers AXP series PMICs with I2C"
219 If you say Y here you get support for the X-Powers AXP series power
231 tristate "X-Powers AXP series PMICs with RSB"
235 If you say Y here you get support for the X-Powers AXP series power
251 called cgbc-core.
260 sub-devices. This driver will instantiate additional drivers such
264 called cros-ec-dev.
282 called "cs40l50-i2c".
294 called "cs40l50-spi".
341 which is also used for other co-processors. The SMC protocol then
344 exposes it to the sub-devices.
417 CPLD. It consists of reset and GPIO drivers. CPLD provides GPIOS-s
427 usually found on PXA processors-based platforms. This includes
430 LEDs and battery-charger under the corresponding menus.
499 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
505 This adds support for the DA9150 integrated charger and fuel-gauge
515 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
516 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
526 This adds support for the power-off functionality and access to
528 Embedded Controller. To use the LED functionality LEDS_ARIEL must
551 such as push-button monitor, multiple ADC's for voltage and
601 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
605 mxs-lradc-adc for ADC readings
606 mxs-lradc-ts for touchscreen support
609 called mxs-lradc.
642 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
647 We communicate with the Hi6421 via memory-mapped I/O.
657 multi-functions, such as regulators, RTC, codec, Coulomb counter,
685 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
722 causes the designware-i2c driver to be builtin for the same reason.
749 causes the designware-i2c driver to be builtin for the same reason.
766 needs the designware-i2c driver to be builtin for the same reason.
790 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
799 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
812 multi-function device that exposes IPC, General Control
813 Register and P-unit access. In addition this creates devices
833 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
834 options must be selected to enable device-specific functions.
840 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
844 This is the core driver for the Janz CMOD-IO PCI MODULbus
859 will be called kempld-core.
871 battery-charger under the corresponding menus.
894 battery-charger under the corresponding menus.
927 MAX77836 Micro-USB ICs with battery charger.
973 charger, LED, onkey.
1026 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
1041 This is a companion Power Management IC for USB Type-C applications
1042 with Battery Charger, Fuel Gauge, temperature sensors, USB Type-C
1121 PMU part includes Charger, Flashlight, RGB LED
1122 PMIC part includes 2-channel BUCKs and 2-channel LDOs
1123 LDO part includes 4-channel LDOs
1135 voltage supply, one general purpose LDO, and the USB Type-C & PD
1136 controller complies with the latest USB Type-C and PD standards.
1158 The device supports multiple sub-devices like LED, HWMON and WDT.
1198 called ocelot-soc.
1236 certain e-book readers designed by the original design manufacturer
1240 tristate "Nokia Retu and Tahvo multi-function device"
1245 Retu and Tahvo are a multi-function devices found on Nokia
1256 built-in PM8xxx PMIC chips.
1262 module. This will build a module called "pm8xxx-core".
1285 This option supports the I2C-based SpacemiT P1 PMIC, which
1287 This option is selected when any of the supported sub-devices
1304 series as a module. The module will be called "qcom-spmi-pmic".
1313 To enable support for building sub-devices as modules,
1317 tristate "RDC R-321x southbridge"
1321 Say yes here if you want to have support for the RDC R-321x SoC
1345 sub-devices like charger, fuel gauge, flash LED, current source,
1369 through i2c interface. The device supports multiple sub-devices
1389 through I2C interface. The device supports multiple sub-devices
1403 through an SPI interface. The device supports multiple sub-devices
1404 including interrupts, LDO & DCDC regulators, and power on-key.
1440 called sec-acpm.
1456 module will be called sec-i2c.
1468 radio. This MFD driver connects the radio-si476x V4L2 module
1472 module will be called si476x-core.
1481 to be shared by all sub-devices.
1484 sub-devices represented by child nodes in Device Tree will be
1497 * SMARC-sAL28
1552 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1558 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1569 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1582 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1610 of the device. Currently available sub drivers are:
1612 GPIO: stmpe-gpio
1613 Keypad: stmpe-keypad
1614 Touchscreen: stmpe-ts
1615 ADC: stmpe-adc
1670 With these functionalities, it can be used for LED string control or
1691 LM36274. It consists of backlight, LED and regulator driver.
1734 high-power "white LED driver". This boost converter is
1794 tristate "TI TPS65217 Power Management / White LED chips"
1801 Power Management / White LED chips.
1934 will be called tps6594-i2c.
1947 will be called tps6594-spi.
1959 so that function-specific drivers can bind to them.
1961 These multi-function chips are found on many OMAP2 and OMAP3
1975 This driver uses board-specific data to initialize the resources
2005 regulators, Dual slot memory card transceivers, real-time clock
2019 additional drivers must be enabled in order to use the LED,
2020 backlight or ambient-light-sensor functionality of the device.
2031 for in-vehicle infotainment, called Russellville.
2046 tristate "TQ-Systems IO controller TQMX86"
2050 TQ-Systems IO controller and watchdog device, found on their
2179 The WM8994 is a highly integrated hi-fi CODEC designed for
2193 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2207 in various ST Microelectronics and ST-Ericsson embedded
2239 These are single-chip Power Management ICs (PMIC), mainly for
2240 battery-powered portable devices.
2244 All the above ICs provide a single-cell linear charger, and a Coulomb
2248 Real-Time Clock (RTC), GPIOs and a 32.768 kHz clock gate.
2260 designed to be used to power R-Car series processors.
2276 tristate "Support for STM32 Low-Power Timer"
2282 Select this option to enable STM32 Low-Power Timer driver
2287 module will be called stm32-lptimer.
2317 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2323 Support for the STMicroelectronics Multi-Function eXpander.
2373 power-on options, power-off control and system FAN control on recent
2454 This option enables basic support for the SGI IOC3-based
2505 bool "Loongson-2K Board Management Controller Support"
2509 Say yes here to add support for the Loongson-2K BMC which is a Board
2511 multiple sub-devices like display and IPMI. This driver provides common
2525 and LED control.
2565 LED controller.
2568 called upboard-fpga.