Lines Matching +full:max77650 +full:- +full:charger
1 # SPDX-License-Identifier: GPL-2.0-only
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
65 charger.
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
197 tristate "X-Powers AC100"
201 If you say Y here you get support for the X-Powers AC100 audio codec
212 tristate "X-Powers AXP series PMICs with I2C"
217 If you say Y here you get support for the X-Powers AXP series power
229 tristate "X-Powers AXP series PMICs with RSB"
233 If you say Y here you get support for the X-Powers AXP series power
249 called cgbc-core.
258 sub-devices. This driver will instantiate additional drivers such
262 called cros-ec-dev.
368 usually found on PXA processors-based platforms. This includes
371 LEDs and battery-charger under the corresponding menus.
440 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
446 This adds support for the DA9150 integrated charger and fuel-gauge
456 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
457 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
467 This adds support for the power-off functionality and access to
492 such as push-button monitor, multiple ADC's for voltage and
526 tristate "Monolithic Power Systems MP2629 ADC and Battery charger"
532 battery charger. This provides ADC, thermal and battery charger power
542 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
546 mxs-lradc-adc for ADC readings
547 mxs-lradc-ts for touchscreen support
550 called mxs-lradc.
567 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
572 We communicate with the Hi6421 via memory-mapped I/O.
582 multi-functions, such as regulators, RTC, codec, Coulomb counter,
610 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
642 thermal, charger and related power management functions
647 causes the designware-i2c driver to be builtin for the same reason.
657 thermal, charger and related power management functions
674 causes the designware-i2c driver to be builtin for the same reason.
691 needs the designware-i2c driver to be builtin for the same reason.
715 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
724 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
737 multi-function device that exposes IPC, General Control
738 Register and P-unit access. In addition this creates devices
758 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
759 options must be selected to enable device-specific functions.
765 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
769 This is the core driver for the Janz CMOD-IO PCI MODULbus
784 will be called kempld-core.
796 battery-charger under the corresponding menus.
819 battery-charger under the corresponding menus.
834 tristate "Maxim Semiconductor MAX14577/77836 MUIC + Charger Support"
842 MAX77836 Micro-USB ICs with battery charger.
876 tristate "Maxim MAX77650/77651 PMIC Support"
883 Say Y here to add support for Maxim Semiconductor MAX77650 and
886 'max77650'. Additional drivers can be enabled in order to use
888 charger, LED, onkey.
913 This is a companion Power Management IC with Flash, Haptic, Charger,
928 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
941 This is companion Power Management IC with LEDs, Haptic, Charger,
1003 PMU part includes Charger, Flashlight, RGB LED
1004 PMIC part includes 2-channel BUCKs and 2-channel LDOs
1005 LDO part includes 4-channel LDOs
1015 It consists of a single cell battery charger with ADC monitoring, RGB
1017 voltage supply, one general purpose LDO, and the USB Type-C & PD
1018 controller complies with the latest USB Type-C and PD standards.
1040 The device supports multiple sub-devices like LED, HWMON and WDT.
1065 called ocelot-soc.
1110 certain e-book readers designed by the original design manufacturer
1114 tristate "Nokia Retu and Tahvo multi-function device"
1119 Retu and Tahvo are a multi-function devices found on Nokia
1130 so that function-specific drivers can bind to them.
1154 built-in PM8xxx PMIC chips.
1160 module. This will build a module called "pm8xxx-core".
1189 series as a module. The module will be called "qcom-spmi-pmic".
1198 To enable support for building sub-devices as modules,
1202 tristate "RDC R-321x southbridge"
1206 Say yes here if you want to have support for the RDC R-321x SoC
1230 sub-devices like charger, fuel gauge, flash LED, current source,
1254 through i2c interface. The device supports multiple sub-devices
1274 through I2C interface. The device supports multiple sub-devices
1288 through an SPI interface. The device supports multiple sub-devices
1289 including interrupts, LDO & DCDC regulators, and power on-key.
1320 module will be called sec-core.
1332 radio. This MFD driver connects the radio-si476x V4L2 module
1336 module will be called si476x-core.
1345 to be shared by all sub-devices.
1348 sub-devices represented by child nodes in Device Tree will be
1361 * SMARC-sAL28
1416 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1422 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1433 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1446 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1476 GPIO: stmpe-gpio
1477 Keypad: stmpe-keypad
1478 Touchscreen: stmpe-ts
1479 ADC: stmpe-adc
1550 TI LP8788 PMU supports regulators, battery charger, RTC,
1593 high-power "white LED driver". This boost converter is
1662 charger, wled and other features that are often used in portable
1793 will be called tps6594-i2c.
1806 will be called tps6594-spi.
1818 so that function-specific drivers can bind to them.
1820 These multi-function chips are found on many OMAP2 and OMAP3
1834 This driver uses board-specific data to initialize the resources
1864 regulators, Dual slot memory card transceivers, real-time clock
1875 driver connects the radio-wl1273 V4L2 module and the wl1273
1889 backlight or ambient-light-sensor functionality of the device.
1900 for in-vehicle infontainment, called Russellville.
1915 tristate "TQ-Systems IO controller TQMX86"
1919 TQ-Systems IO controller and watchdog device, found on their
2056 The WM8994 is a highly integrated hi-fi CODEC designed for
2070 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2084 in various ST Microelectronics and ST-Ericsson embedded
2109 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2110 management ICs mainly for battery-powered portable devices.
2113 also a single-cell linear charger, a Coulomb counter, a real-time
2126 designed to be used to power R-Car series processors.
2142 tristate "Support for STM32 Low-Power Timer"
2148 Select this option to enable STM32 Low-Power Timer driver
2153 module will be called stm32-lptimer.
2183 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2189 Support for the STMicroelectronics Multi-Function eXpander.
2239 power-on options, power-off control and system FAN control on recent
2312 called "cs40l50-i2c".
2324 called "cs40l50-spi".
2350 This option enables basic support for the SGI IOC3-based