Lines Matching +full:gpio +full:- +full:charger
1 # SPDX-License-Identifier: GPL-2.0-only
21 necessary for using the board's GPIO and MFGPT functionality.
30 Say yes here to add support for the Analog Devices ADP5585 GPIO
33 the GPIO and PWM functions under the corresponding menus.
43 accessing the external gpio extender (LEDs & buttons) and
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
65 charger.
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
190 voltage regulator, voltage sampling units, GPIO block and
197 tristate "X-Powers AC100"
201 If you say Y here you get support for the X-Powers AC100 audio codec
212 tristate "X-Powers AXP series PMICs with I2C"
217 If you say Y here you get support for the X-Powers AXP series power
229 tristate "X-Powers AXP series PMICs with RSB"
233 If you say Y here you get support for the X-Powers AXP series power
246 I2C busses, and GPIO controller.
249 called cgbc-core.
258 sub-devices. This driver will instantiate additional drivers such
262 called cros-ec-dev.
368 usually found on PXA processors-based platforms. This includes
371 LEDs and battery-charger under the corresponding menus.
440 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
446 This adds support for the DA9150 integrated charger and fuel-gauge
456 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
457 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
467 This adds support for the power-off functionality and access to
492 such as push-button monitor, multiple ADC's for voltage and
526 tristate "Monolithic Power Systems MP2629 ADC and Battery charger"
532 battery charger. This provides ADC, thermal and battery charger power
542 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
546 mxs-lradc-adc for ADC readings
547 mxs-lradc-ts for touchscreen support
550 called mxs-lradc.
567 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
572 We communicate with the Hi6421 via memory-mapped I/O.
582 multi-functions, such as regulators, RTC, codec, Coulomb counter,
601 tristate "Intel Quark MFD I2C GPIO"
607 This MFD provides support for I2C and GPIO that exist only
610 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
620 other drivers to control these functions, currently GPIO and
641 on some Intel SoC systems. The PMIC provides ADC, GPIO,
642 thermal, charger and related power management functions
647 causes the designware-i2c driver to be builtin for the same reason.
656 on Intel Broxton systems. The PMIC provides ADC, GPIO,
657 thermal, charger and related power management functions
674 causes the designware-i2c driver to be builtin for the same reason.
691 needs the designware-i2c driver to be builtin for the same reason.
715 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
724 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
737 multi-function device that exposes IPC, General Control
738 Register and P-unit access. In addition this creates devices
758 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
759 options must be selected to enable device-specific functions.
765 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
769 This is the core driver for the Janz CMOD-IO PCI MODULbus
772 CAN and GPIO controllers.
781 functions like watchdog, GPIO, UART and I2C bus.
784 will be called kempld-core.
796 battery-charger under the corresponding menus.
819 battery-charger under the corresponding menus.
834 tristate "Maxim Semiconductor MAX14577/77836 MUIC + Charger Support"
842 MAX77836 Micro-USB ICs with battery charger.
887 the following functionalities of the device: GPIO, regulator,
888 charger, LED, onkey.
913 This is a companion Power Management IC with Flash, Haptic, Charger,
928 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
941 This is companion Power Management IC with LEDs, Haptic, Charger,
1003 PMU part includes Charger, Flashlight, RGB LED
1004 PMIC part includes 2-channel BUCKs and 2-channel LDOs
1005 LDO part includes 4-channel LDOs
1015 It consists of a single cell battery charger with ADC monitoring, RGB
1017 voltage supply, one general purpose LDO, and the USB Type-C & PD
1018 controller complies with the latest USB Type-C and PD standards.
1040 The device supports multiple sub-devices like LED, HWMON and WDT.
1065 called ocelot-soc.
1110 certain e-book readers designed by the original design manufacturer
1114 tristate "Nokia Retu and Tahvo multi-function device"
1119 Retu and Tahvo are a multi-function devices found on Nokia
1130 so that function-specific drivers can bind to them.
1140 tristate "NXP PCF50633 GPIO"
1143 Say yes here if you want to include support GPIO for pins on
1154 built-in PM8xxx PMIC chips.
1160 module. This will build a module called "pm8xxx-core".
1189 series as a module. The module will be called "qcom-spmi-pmic".
1198 To enable support for building sub-devices as modules,
1202 tristate "RDC R-321x southbridge"
1206 Say yes here if you want to have support for the RDC R-321x SoC
1230 sub-devices like charger, fuel gauge, flash LED, current source,
1254 through i2c interface. The device supports multiple sub-devices
1255 like GPIO, interrupts, RTC, LDO and DCDC regulators, onkey.
1274 through I2C interface. The device supports multiple sub-devices
1288 through an SPI interface. The device supports multiple sub-devices
1289 including interrupts, LDO & DCDC regulators, and power on-key.
1320 module will be called sec-core.
1332 radio. This MFD driver connects the radio-si476x V4L2 module
1336 module will be called si476x-core.
1345 to be shared by all sub-devices.
1348 sub-devices represented by child nodes in Device Tree will be
1361 * SMARC-sAL28
1375 bool "Export GPIO via GPIO layer"
1378 This option uses the gpio library layer to export the 64 GPIO
1380 base number for the first GPIO line to register.
1416 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1422 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1433 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1446 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1466 STMPE811: GPIO, Touchscreen, ADC
1467 STMPE1601: GPIO, Keypad
1468 STMPE1801: GPIO, Keypad
1469 STMPE2401: GPIO, Keypad
1470 STMPE2403: GPIO, Keypad
1476 GPIO: stmpe-gpio
1477 Keypad: stmpe-keypad
1478 Touchscreen: stmpe-ts
1479 ADC: stmpe-adc
1539 This driver consists of GPIO and PWM drivers.
1541 general usage such like a GPIO controller and a PWM controller.
1550 TI LP8788 PMU supports regulators, battery charger, RTC,
1593 high-power "white LED driver". This boost converter is
1595 also contains a GPIO pin.
1662 charger, wled and other features that are often used in portable
1705 These include voltage regulators, gpio and other features
1793 will be called tps6594-i2c.
1806 will be called tps6594-spi.
1818 so that function-specific drivers can bind to them.
1820 These multi-function chips are found on many OMAP2 and OMAP3
1821 boards, providing power management, RTC, GPIO, keypad, a
1834 This driver uses board-specific data to initialize the resources
1864 regulators, Dual slot memory card transceivers, real-time clock
1875 driver connects the radio-wl1273 V4L2 module and the wl1273
1889 backlight or ambient-light-sensor functionality of the device.
1900 for in-vehicle infontainment, called Russellville.
1915 tristate "TQ-Systems IO controller TQMX86"
1919 TQ-Systems IO controller and watchdog device, found on their
2056 The WM8994 is a highly integrated hi-fi CODEC designed for
2058 has on board GPIO and regulator functionality which is
2070 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2072 it has on board GPIO and a touchscreen functionality which is
2084 in various ST Microelectronics and ST-Ericsson embedded
2109 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2110 management ICs mainly for battery-powered portable devices.
2113 also a single-cell linear charger, a Coulomb counter, a real-time
2126 designed to be used to power R-Car series processors.
2142 tristate "Support for STM32 Low-Power Timer"
2148 Select this option to enable STM32 Low-Power Timer driver
2153 module will be called stm32-lptimer.
2183 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2189 Support for the STMicroelectronics Multi-Function eXpander.
2239 power-on options, power-off control and system FAN control on recent
2312 called "cs40l50-i2c".
2324 called "cs40l50-spi".
2350 This option enables basic support for the SGI IOC3-based
2440 called upboard-fpga.