Lines Matching +full:act8945a +full:- +full:charger
1 # SPDX-License-Identifier: GPL-2.0-only
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
65 charger.
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
197 tristate "X-Powers AC100"
201 If you say Y here you get support for the X-Powers AC100 audio codec
212 tristate "X-Powers AXP series PMICs with I2C"
217 If you say Y here you get support for the X-Powers AXP series power
229 tristate "X-Powers AXP series PMICs with RSB"
233 If you say Y here you get support for the X-Powers AXP series power
246 sub-devices. This driver will instantiate additional drivers such
250 called cros-ec-dev.
356 usually found on PXA processors-based platforms. This includes
359 LEDs and battery-charger under the corresponding menus.
428 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
434 This adds support for the DA9150 integrated charger and fuel-gauge
444 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
445 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
455 This adds support for the power-off functionality and access to
480 such as push-button monitor, multiple ADC's for voltage and
514 tristate "Monolithic Power Systems MP2629 ADC and Battery charger"
520 battery charger. This provides ADC, thermal and battery charger power
530 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
534 mxs-lradc-adc for ADC readings
535 mxs-lradc-ts for touchscreen support
538 called mxs-lradc.
555 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
560 We communicate with the Hi6421 via memory-mapped I/O.
570 multi-functions, such as regulators, RTC, codec, Coulomb counter,
598 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
630 thermal, charger and related power management functions
635 causes the designware-i2c driver to be builtin for the same reason.
645 thermal, charger and related power management functions
662 causes the designware-i2c driver to be builtin for the same reason.
679 needs the designware-i2c driver to be builtin for the same reason.
703 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
712 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
725 multi-function device that exposes IPC, General Control
726 Register and P-unit access. In addition this creates devices
746 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
747 options must be selected to enable device-specific functions.
753 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
757 This is the core driver for the Janz CMOD-IO PCI MODULbus
772 will be called kempld-core.
784 battery-charger under the corresponding menus.
807 battery-charger under the corresponding menus.
822 tristate "Maxim Semiconductor MAX14577/77836 MUIC + Charger Support"
830 MAX77836 Micro-USB ICs with battery charger.
876 charger, LED, onkey.
901 This is a companion Power Management IC with Flash, Haptic, Charger,
916 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
929 This is companion Power Management IC with LEDs, Haptic, Charger,
991 PMU part includes Charger, Flashlight, RGB LED
992 PMIC part includes 2-channel BUCKs and 2-channel LDOs
993 LDO part includes 4-channel LDOs
1003 It consists of a single cell battery charger with ADC monitoring, RGB
1005 voltage supply, one general purpose LDO, and the USB Type-C & PD
1006 controller complies with the latest USB Type-C and PD standards.
1028 The device supports multiple sub-devices like LED, HWMON and WDT.
1053 called ocelot-soc.
1098 certain e-book readers designed by the original design manufacturer
1102 tristate "Nokia Retu and Tahvo multi-function device"
1107 Retu and Tahvo are a multi-function devices found on Nokia
1118 so that function-specific drivers can bind to them.
1142 built-in PM8xxx PMIC chips.
1148 module. This will build a module called "pm8xxx-core".
1177 series as a module. The module will be called "qcom-spmi-pmic".
1186 To enable support for building sub-devices as modules,
1190 tristate "RDC R-321x southbridge"
1194 Say yes here if you want to have support for the RDC R-321x SoC
1218 sub-devices like charger, fuel gauge, flash LED, current source,
1242 through i2c interface. The device supports multiple sub-devices
1262 through I2C interface. The device supports multiple sub-devices
1276 through an SPI interface. The device supports multiple sub-devices
1277 including interrupts, LDO & DCDC regulators, and power on-key.
1308 module will be called sec-core.
1320 radio. This MFD driver connects the radio-si476x V4L2 module
1324 module will be called si476x-core.
1333 to be shared by all sub-devices.
1336 sub-devices represented by child nodes in Device Tree will be
1349 * SMARC-sAL28
1404 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1410 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1421 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1434 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1464 GPIO: stmpe-gpio
1465 Keypad: stmpe-keypad
1466 Touchscreen: stmpe-ts
1467 ADC: stmpe-adc
1538 TI LP8788 PMU supports regulators, battery charger, RTC,
1581 high-power "white LED driver". This boost converter is
1650 charger, wled and other features that are often used in portable
1781 will be called tps6594-i2c.
1794 will be called tps6594-spi.
1806 so that function-specific drivers can bind to them.
1808 These multi-function chips are found on many OMAP2 and OMAP3
1822 This driver uses board-specific data to initialize the resources
1852 regulators, Dual slot memory card transceivers, real-time clock
1863 driver connects the radio-wl1273 V4L2 module and the wl1273
1877 backlight or ambient-light-sensor functionality of the device.
1888 for in-vehicle infontainment, called Russellville.
1903 tristate "TQ-Systems IO controller TQMX86"
1907 TQ-Systems IO controller and watchdog device, found on their
2044 The WM8994 is a highly integrated hi-fi CODEC designed for
2058 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2072 in various ST Microelectronics and ST-Ericsson embedded
2097 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2098 management ICs mainly for battery-powered portable devices.
2101 also a single-cell linear charger, a Coulomb counter, a real-time
2114 designed to be used to power R-Car series processors.
2130 tristate "Support for STM32 Low-Power Timer"
2136 Select this option to enable STM32 Low-Power Timer driver
2141 module will be called stm32-lptimer.
2171 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2177 Support for the STMicroelectronics Multi-Function eXpander.
2227 power-on options, power-off control and system FAN control on recent
2300 called "cs40l50-i2c".
2312 called "cs40l50-spi".
2338 This option enables basic support for the SGI IOC3-based