Lines Matching full:edp

135  * @bridge_aux:   AUX-bus sub device for MIPI-to-eDP bridge functionality.
137  * @aux_aux:      AUX-bus sub device for eDP AUX channel functionality.
148  * @next_bridge:  The bridge on the eDP side.
340 	 * HPD on this bridge chip is a bit useless.  This is an eDP bridge  in ti_sn65dsi86_enable_comms()
644 	 * The eDP to MIPI bridge parts don't work until the AUX channel is  in ti_sn_aux_probe()
868 			      "Can't read eDP rev (%d), assuming 1.1\n", ret);  in ti_sn_bridge_read_valid_rates()
873 		/* eDP 1.4 devices must provide a custom table */  in ti_sn_bridge_read_valid_rates()
907 			      "No matching eDP rates in table; falling back\n");  in ti_sn_bridge_read_valid_rates()
1089 	 * this method is enabled for eDP panels. An eDP panel must support this  in ti_sn_bridge_atomic_enable()
1090 	 * authentication method. We need to enable this method in the eDP panel  in ti_sn_bridge_atomic_enable()
1344 		 * the eDP case where the panel wants to read the EDID before  in ti_sn_bridge_probe()
1346 		 * for eDP.  in ti_sn_bridge_probe()
2078 MODULE_DESCRIPTION("sn65dsi86 DSI to eDP bridge driver");