Lines Matching +full:peripheral +full:- +full:to +full:- +full:memory
1 # SPDX-License-Identifier: GPL-2.0
29 Say y here to enable support for the ARM Logic Module bus
37 Driver for the Broadcom Set Top Box System-on-a-chip internal bus
42 bool "Baikal-T1 APB-bus driver"
46 Baikal-T1 AXI-APB bridge is used to access the SoC subsystem CSRs.
47 IO requests are routed to this bus by means of the DW AMBA 3 AXI
50 reported to the APB terminator (APB Errors Handler Block). This
51 driver provides the interrupt handler to detect the erroneous
53 errors counter. The counter and the APB-bus operations timeout can be
57 bool "Baikal-T1 AXI-bus driver"
61 AXI3-bus is the main communication bus connecting all high-speed
62 peripheral IP-cores with RAM controller and with MIPS P5600 cores on
63 Baikal-T1 SoC. Traffic arbitration is done by means of DW AMBA 3 AXI
65 from one SoC block to another. This driver provides a way to detect
75 Say yes here to add support for the module configuration bus found
76 on CZ.NIC's Turris Mox. This is needed for the ability to discover
77 the order in which the modules are connected and to get/set some of
87 Driver to enable I/O access to devices attached to the Low Pin
91 tristate "Support for IMX Secure AHB to IP Slave bus (AIPSTZ) bridge"
112 needed to set up various chip select configuration parameters before
116 bool "MIPS Common Device Memory Map (CDMM) Driver"
119 Driver needed for the MIPS Common Device Memory Map bus in MIPS
120 cores. This bus is for per-CPU tightly coupled devices such as the
123 For this to work, either your bootloader needs to enable the CDMM
125 platform code needs to implement mips_cdmm_phys_base() (see
140 Driver to enable OMAP interconnect error handling driver.
146 Driver to enable ocp2scp module which transforms ocp interface
147 protocol to scp protocol. In OMAP4, USB PHY is connected via
157 Say y here to enable support for the Qualcomm External Bus
158 Interface 2, which can be used to connect things like NAND Flash,
165 Say y here to enable support for initializing the bus that connects
166 the SSC block's internal bus to the cNoC (configurantion NoC) on
177 Say y to enable STM32 firewall framework and its services. Firewall
178 controllers will be able to register to the framework. Access for
179 hardware resources linked to a firewall controller can be requested
188 Say y here to enable support for Allwinner A64 DE2 bus driver. It's
189 mostly transparent, but a SRAM region needs to be claimed in the SRAM
190 controller to make the all blocks in the DE2 part accessible.
198 Say y here to enable support for Allwinner's Reduced Serial Bus
208 Driver for the Tegra ACONNECT bus which is used to interface with
213 tristate "Tegra Generic Memory Interface bus driver"
216 Driver for the Tegra Generic Memory Interface bus which can be used
217 to attach devices such as NOR, UART, FPGA and more.
241 Driver for the Technologic Systems NBUS which is used to interface
242 with the peripherals in the FPGA of the TS-4600 SoM.
250 needed to use on-board devices connected to UniPhier SoCs.
263 bool "TI da8xx master peripheral priority driver"
266 Driver for Texas Instruments da8xx master peripheral priority
267 configuration. Allows to adjust the priorities of all master
270 source "drivers/bus/fsl-mc/Kconfig"