Lines Matching +full:rx +full:- +full:input
1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
7 /dts-v1/;
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/leds/common.h>
15 compatible = "beagle,beaglev-ahead", "thead,th1520";
35 stdout-path = "serial0:115200n8";
44 pinctrl-names = "default";
45 pinctrl-0 = <&led_pins>;
46 compatible = "gpio-leds";
48 led-1 {
54 led-2 {
60 led-3 {
66 led-4 {
72 led-5 {
81 clock-frequency = <24000000>;
85 clock-frequency = <32768>;
93 bus-width = <8>;
94 max-frequency = <198000000>;
95 mmc-hs400-1_8v;
96 non-removable;
97 no-sdio;
98 no-sd;
103 pinctrl-names = "default";
104 pinctrl-0 = <&gmac0_pins>;
105 phy-handle = <&phy0>;
106 phy-mode = "rgmii-id";
111 phy0: ethernet-phy@1 {
113 interrupt-parent = <&gpio3>;
115 reset-gpios = <&gpio3 21 GPIO_ACTIVE_LOW>;
116 reset-delay-us = <10000>;
117 reset-post-delay-us = <50000>;
122 led_pins: led-0 {
123 led-pins {
129 bias-disable;
130 drive-strength = <3>;
131 input-disable;
132 input-schmitt-disable;
133 slew-rate = <0>;
139 gmac0_pins: gmac0-0 {
140 tx-pins {
148 bias-disable;
149 drive-strength = <25>;
150 input-disable;
151 input-schmitt-disable;
152 slew-rate = <0>;
155 rx-pins {
163 bias-disable;
164 drive-strength = <1>;
165 input-enable;
166 input-schmitt-disable;
167 slew-rate = <0>;
170 mdc-pins {
173 bias-disable;
174 drive-strength = <13>;
175 input-disable;
176 input-schmitt-disable;
177 slew-rate = <0>;
180 mdio-pins {
183 bias-disable;
184 drive-strength = <13>;
185 input-enable;
186 input-schmitt-enable;
187 slew-rate = <0>;
190 phy-reset-pins {
192 bias-disable;
193 drive-strength = <3>;
194 input-disable;
195 input-schmitt-disable;
196 slew-rate = <0>;
199 phy-interrupt-pins {
202 bias-pull-up;
203 drive-strength = <1>;
204 input-enable;
205 input-schmitt-enable;
206 slew-rate = <0>;
210 uart0_pins: uart0-0 {
211 tx-pins {
214 bias-disable;
215 drive-strength = <3>;
216 input-disable;
217 input-schmitt-disable;
218 slew-rate = <0>;
221 rx-pins {
224 bias-pull-up;
225 drive-strength = <1>;
226 input-enable;
227 input-schmitt-enable;
228 slew-rate = <0>;
234 bus-width = <4>;
235 max-frequency = <198000000>;
240 pinctrl-names = "default";
241 pinctrl-0 = <&uart0_pins>;