Lines Matching +full:regulator +full:- +full:fixed +full:- +full:clock
1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for the R-Car Gen3 ULCB board
14 #include <dt-bindings/gpio/gpio.h>
15 #include <dt-bindings/input/input.h>
18 model = "Renesas R-Car Gen3 ULCB board";
37 stdout-path = "serial0:115200n8";
40 audio_clkout: audio-clkout {
43 * but needed to avoid cs2000/rcar_sound probe dead-lock
45 compatible = "fixed-clock";
46 #clock-cells = <0>;
47 clock-frequency = <12288000>;
50 hdmi0-out {
51 compatible = "hdmi-connector";
56 remote-endpoint = <&rcar_dw_hdmi0_out>;
62 compatible = "gpio-keys";
64 key-1 {
67 wakeup-source;
68 debounce-interval = <20>;
74 compatible = "gpio-leds";
84 reg_1p8v: regulator-1p8v {
85 compatible = "regulator-fixed";
86 regulator-name = "fixed-1.8V";
87 regulator-min-microvolt = <1800000>;
88 regulator-max-microvolt = <1800000>;
89 regulator-boot-on;
90 regulator-always-on;
93 reg_3p3v: regulator-3p3v {
94 compatible = "regulator-fixed";
95 regulator-name = "fixed-3.3V";
96 regulator-min-microvolt = <3300000>;
97 regulator-max-microvolt = <3300000>;
98 regulator-boot-on;
99 regulator-always-on;
102 vcc_sdhi0: regulator-vcc-sdhi0 {
103 compatible = "regulator-fixed";
105 regulator-name = "SDHI0 Vcc";
106 regulator-min-microvolt = <3300000>;
107 regulator-max-microvolt = <3300000>;
110 enable-active-high;
113 vccq_sdhi0: regulator-vccq-sdhi0 {
114 compatible = "regulator-gpio";
116 regulator-name = "SDHI0 VccQ";
117 regulator-min-microvolt = <1800000>;
118 regulator-max-microvolt = <3300000>;
121 gpios-states = <1>;
126 compatible = "fixed-clock";
127 #clock-cells = <0>;
128 clock-frequency = <24576000>;
131 x23_clk: x23-clock {
132 compatible = "fixed-clock";
133 #clock-cells = <0>;
134 clock-frequency = <25000000>;
139 cpu-supply = <&dvfs>;
143 clock-frequency = <22579200>;
147 pinctrl-0 = <&avb_pins>;
148 pinctrl-names = "default";
149 phy-handle = <&phy0>;
150 tx-internal-delay-ps = <2000>;
153 phy0: ethernet-phy@0 {
154 compatible = "ethernet-phy-id0022.1622",
155 "ethernet-phy-ieee802.3-c22";
156 rxc-skew-ps = <1500>;
158 interrupts-extended = <&gpio2 11 IRQ_TYPE_LEVEL_LOW>;
159 reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
172 clock-frequency = <16666666>;
176 clock-frequency = <32768>;
186 remote-endpoint = <&hdmi0_con>;
196 pinctrl-0 = <&i2c2_pins>;
197 pinctrl-names = "default";
201 clock-frequency = <100000>;
204 compatible = "asahi-kasei,ak4613";
208 asahi-kasei,in1-single-end;
209 asahi-kasei,in2-single-end;
210 asahi-kasei,out1-single-end;
211 asahi-kasei,out2-single-end;
212 asahi-kasei,out3-single-end;
213 asahi-kasei,out4-single-end;
214 asahi-kasei,out5-single-end;
215 asahi-kasei,out6-single-end;
218 cs2000: clk-multiplier@4f {
219 #clock-cells = <0>;
220 compatible = "cirrus,cs2000-cp";
223 clock-names = "clk_in", "ref_clk";
225 assigned-clocks = <&cs2000>;
226 assigned-clock-rates = <24576000>; /* 1/1 divide */
233 clock-frequency = <400000>;
235 versaclock5: clock-generator@6a {
238 #clock-cells = <1>;
240 clock-names = "xin";
242 idt,output-enable-active = <1>;
247 bootph-all;
250 clock-frequency = <400000>;
253 pinctrl-0 = <&irq0_pins>;
254 pinctrl-names = "default";
258 interrupts-extended = <&intc_ex 0 IRQ_TYPE_LEVEL_LOW>;
259 interrupt-controller;
260 #interrupt-cells = <2>;
261 gpio-controller;
262 #gpio-cells = <2>;
263 rohm,ddr-backup-power = <0xf>;
264 rohm,rstbmode-pulse;
268 regulator-name = "dvfs";
269 regulator-min-microvolt = <750000>;
270 regulator-max-microvolt = <1030000>;
271 regulator-boot-on;
272 regulator-always-on;
281 bootph-all;
290 pinctrl-0 = <&scif_clk_pins>;
291 pinctrl-names = "default";
301 drive-strength = <24>;
307 drive-strength = <12>;
334 power-source = <3300>;
340 power-source = <1800>;
346 power-source = <1800>;
354 sound_clk_pins: sound-clk {
367 pinctrl-0 = <&sound_pins>, <&sound_clk_pins>;
368 pinctrl-names = "default";
371 #clock-cells = <1>;
372 clock-frequency = <12288000 11289600>;
400 compatible = "cypress,hyperflash", "cfi-flash";
404 compatible = "fixed-partitions";
405 #address-cells = <1>;
406 #size-cells = <1>;
410 read-only;
414 read-only;
418 read-only;
422 read-only;
426 read-only;
430 read-only;
446 timeout-sec = <60>;
451 pinctrl-0 = <&scif2_pins>;
452 pinctrl-names = "default";
453 bootph-all;
459 clock-frequency = <14745600>;
463 pinctrl-0 = <&sdhi0_pins>;
464 pinctrl-1 = <&sdhi0_pins_uhs>;
465 pinctrl-names = "default", "state_uhs";
467 vmmc-supply = <&vcc_sdhi0>;
468 vqmmc-supply = <&vccq_sdhi0>;
469 cd-gpios = <&gpio3 12 GPIO_ACTIVE_LOW>;
470 bus-width = <4>;
471 sd-uhs-sdr50;
472 sd-uhs-sdr104;
477 /* used for on-board 8bit eMMC */
478 pinctrl-0 = <&sdhi2_pins>;
479 pinctrl-1 = <&sdhi2_pins>;
480 pinctrl-names = "default", "state_uhs";
482 vmmc-supply = <®_3p3v>;
483 vqmmc-supply = <®_1p8v>;
484 bus-width = <8>;
485 mmc-hs200-1_8v;
486 mmc-hs400-1_8v;
487 no-sd;
488 no-sdio;
489 non-removable;
490 full-pwr-cycle-in-suspend;
495 shared-pin;
499 pinctrl-0 = <&usb1_pins>;
500 pinctrl-names = "default";
507 * For sound-test.
511 * #include "ulcb-simple-audio-card.dtsi"
512 * #include "ulcb-simple-audio-card-mix+split.dtsi"
513 * #include "ulcb-audio-graph-card.dtsi"
514 * #include "ulcb-audio-graph-card-mix+split.dtsi"
515 * #include "ulcb-audio-graph-card2-mix+split.dtsi"
517 #include "ulcb-audio-graph-card2.dtsi"