Lines Matching +full:lvds +full:- +full:decoder
1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 #include <dt-bindings/gpio/gpio.h>
29 stdout-path = "serial0:115200n8";
32 hdmi-out {
33 compatible = "hdmi-connector";
38 remote-endpoint = <&adv7511_out>;
43 lvds-decoder {
45 vcc-supply = <&vcc3v3_d5>;
48 #address-cells = <1>;
49 #size-cells = <0>;
54 remote-endpoint = <&lvds0_out>;
61 remote-endpoint = <&adv7511_in>;
73 osc1_clk: osc1-clock {
74 compatible = "fixed-clock";
75 #clock-cells = <0>;
76 clock-frequency = <148500000>;
79 vcc1v8_d4: regulator-0 {
80 compatible = "regulator-fixed";
81 regulator-name = "VCC1V8_D4";
82 regulator-min-microvolt = <1800000>;
83 regulator-max-microvolt = <1800000>;
84 regulator-boot-on;
85 regulator-always-on;
88 vcc3v3_d5: regulator-1 {
89 compatible = "regulator-fixed";
90 regulator-name = "VCC3V3_D5";
91 regulator-min-microvolt = <3300000>;
92 regulator-max-microvolt = <3300000>;
93 regulator-boot-on;
94 regulator-always-on;
101 clock-names = "du.0", "dclkin.0";
106 clock-frequency = <16666666>;
110 clock-frequency = <32768>;
114 pinctrl-0 = <&gether_pins>;
115 pinctrl-names = "default";
117 phy-mode = "rgmii";
118 phy-handle = <&phy0>;
119 renesas,no-ether-link;
122 phy0: ethernet-phy@0 {
123 compatible = "ethernet-phy-id0022.1622",
124 "ethernet-phy-ieee802.3-c22";
125 rxc-skew-ps = <1500>;
127 interrupt-parent = <&gpio4>;
129 reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
134 pinctrl-0 = <&i2c0_pins>;
135 pinctrl-names = "default";
138 clock-frequency = <400000>;
142 #sound-dai-cells = <0>;
144 interrupt-parent = <&gpio1>;
146 avdd-supply = <&vcc1v8_d4>;
147 dvdd-supply = <&vcc1v8_d4>;
148 pvdd-supply = <&vcc1v8_d4>;
149 bgvdd-supply = <&vcc1v8_d4>;
150 dvdd-3v-supply = <&vcc3v3_d5>;
152 adi,input-depth = <8>;
153 adi,input-colorspace = "rgb";
154 adi,input-clock = "1x";
157 #address-cells = <1>;
158 #size-cells = <0>;
163 remote-endpoint = <&thc63lvd1024_out>;
170 remote-endpoint = <&hdmi_con>;
183 remote-endpoint = <&thc63lvd1024_in>;
218 pinctrl-0 = <&qspi0_pins>;
219 pinctrl-names = "default";
224 compatible = "spansion,s25fs512s", "jedec,spi-nor";
226 spi-max-frequency = <50000000>;
227 spi-rx-bus-width = <4>;
230 compatible = "fixed-partitions";
231 #address-cells = <1>;
232 #size-cells = <1>;
236 read-only;
240 read-only;
244 read-only;
248 read-only;
252 read-only;
256 read-only;
260 read-only;
262 uboot-env@700000 {
264 read-only;
280 timeout-sec = <60>;
285 pinctrl-0 = <&scif0_pins>, <&scif_clk_pins>;
286 pinctrl-names = "default";
292 clock-frequency = <14745600>;