Lines Matching +full:wcn3990 +full:- +full:bt
1 // SPDX-License-Identifier: GPL-2.0
4 /dts-v1/;
13 compatible = "qcom,msm8998-mtp", "qcom,msm8998";
14 chassis-type = "handset";
16 qcom,board-id = <8 0>;
24 stdout-path = "serial0:115200n8";
27 vph_pwr: vph-pwr-regulator {
28 compatible = "regulator-fixed";
29 regulator-name = "vph_pwr";
30 regulator-always-on;
31 regulator-boot-on;
39 compatible = "qcom,wcn3990-bt";
41 vddio-supply = <&vreg_s4a_1p8>;
42 vddxo-supply = <&vreg_l7a_1p8>;
43 vddrf-supply = <&vreg_l17a_1p3>;
44 vddch0-supply = <&vreg_l25a_3p3>;
45 max-speed = <3200000>;
50 rx-pins {
51 /delete-property/ bias-disable;
53 * Configure a pull-up on 45 (RX). This is needed to
55 * module is in tri-state (module powered off or not
58 bias-pull-up;
61 cts-pins {
62 /delete-property/ bias-disable;
64 * Configure a pull-down on 47 (CTS) to match the pull
67 bias-pull-down;
144 vdd_s1-supply = <&vph_pwr>;
147 regulator-min-microvolt = <524000>;
148 regulator-max-microvolt = <1100000>;
149 regulator-enable-ramp-delay = <500>;
152 regulator-always-on;
159 vdda-pll-supply = <&vreg_l12a_1p8>;
160 vdda-phy-dpdm-supply = <&vreg_l24a_3p075>;
168 regulators-0 {
169 compatible = "qcom,rpm-pm8998-regulators";
171 vdd_s1-supply = <&vph_pwr>;
172 vdd_s2-supply = <&vph_pwr>;
173 vdd_s3-supply = <&vph_pwr>;
174 vdd_s4-supply = <&vph_pwr>;
175 vdd_s5-supply = <&vph_pwr>;
176 vdd_s6-supply = <&vph_pwr>;
177 vdd_s7-supply = <&vph_pwr>;
178 vdd_s8-supply = <&vph_pwr>;
179 vdd_s9-supply = <&vph_pwr>;
180 vdd_s10-supply = <&vph_pwr>;
181 vdd_s11-supply = <&vph_pwr>;
182 vdd_s12-supply = <&vph_pwr>;
183 vdd_s13-supply = <&vph_pwr>;
184 vdd_l1_l27-supply = <&vreg_s7a_1p025>;
185 vdd_l2_l8_l17-supply = <&vreg_s3a_1p35>;
186 vdd_l3_l11-supply = <&vreg_s7a_1p025>;
187 vdd_l4_l5-supply = <&vreg_s7a_1p025>;
188 vdd_l6-supply = <&vreg_s5a_2p04>;
189 vdd_l7_l12_l14_l15-supply = <&vreg_s5a_2p04>;
190 vdd_l9-supply = <&vreg_bob>;
191 vdd_l10_l23_l25-supply = <&vreg_bob>;
192 vdd_l13_l19_l21-supply = <&vreg_bob>;
193 vdd_l16_l28-supply = <&vreg_bob>;
194 vdd_l18_l22-supply = <&vreg_bob>;
195 vdd_l20_l24-supply = <&vreg_bob>;
196 vdd_l26-supply = <&vreg_s3a_1p35>;
197 vdd_lvs1_lvs2-supply = <&vreg_s4a_1p8>;
200 regulator-min-microvolt = <1352000>;
201 regulator-max-microvolt = <1352000>;
205 regulator-min-microvolt = <1800000>;
206 regulator-max-microvolt = <1800000>;
207 regulator-allow-set-load;
211 regulator-min-microvolt = <1904000>;
212 regulator-max-microvolt = <2040000>;
216 regulator-min-microvolt = <900000>;
217 regulator-max-microvolt = <1028000>;
221 regulator-min-microvolt = <880000>;
222 regulator-max-microvolt = <880000>;
226 regulator-min-microvolt = <1200000>;
227 regulator-max-microvolt = <1200000>;
231 regulator-min-microvolt = <1000000>;
232 regulator-max-microvolt = <1000000>;
236 regulator-min-microvolt = <800000>;
237 regulator-max-microvolt = <800000>;
241 regulator-min-microvolt = <1808000>;
242 regulator-max-microvolt = <1808000>;
246 regulator-min-microvolt = <1800000>;
247 regulator-max-microvolt = <1800000>;
251 regulator-min-microvolt = <1200000>;
252 regulator-max-microvolt = <1200000>;
256 regulator-min-microvolt = <1808000>;
257 regulator-max-microvolt = <2960000>;
261 regulator-min-microvolt = <1808000>;
262 regulator-max-microvolt = <2960000>;
266 regulator-min-microvolt = <1000000>;
267 regulator-max-microvolt = <1000000>;
271 regulator-min-microvolt = <1800000>;
272 regulator-max-microvolt = <1800000>;
276 regulator-min-microvolt = <1808000>;
277 regulator-max-microvolt = <2960000>;
281 regulator-min-microvolt = <1880000>;
282 regulator-max-microvolt = <1880000>;
286 regulator-min-microvolt = <1800000>;
287 regulator-max-microvolt = <1800000>;
291 regulator-min-microvolt = <2704000>;
292 regulator-max-microvolt = <2704000>;
296 regulator-min-microvolt = <1304000>;
297 regulator-max-microvolt = <1304000>;
301 regulator-min-microvolt = <2704000>;
302 regulator-max-microvolt = <2704000>;
306 regulator-min-microvolt = <3008000>;
307 regulator-max-microvolt = <3008000>;
311 regulator-min-microvolt = <2960000>;
312 regulator-max-microvolt = <2960000>;
313 regulator-allow-set-load;
317 regulator-min-microvolt = <2960000>;
318 regulator-max-microvolt = <2960000>;
319 regulator-system-load = <800000>;
320 regulator-allow-set-load;
324 regulator-min-microvolt = <2864000>;
325 regulator-max-microvolt = <2864000>;
329 regulator-min-microvolt = <3312000>;
330 regulator-max-microvolt = <3312000>;
334 regulator-min-microvolt = <3088000>;
335 regulator-max-microvolt = <3088000>;
339 regulator-min-microvolt = <3104000>;
340 regulator-max-microvolt = <3312000>;
344 regulator-min-microvolt = <1200000>;
345 regulator-max-microvolt = <1200000>;
346 regulator-allow-set-load;
350 regulator-min-microvolt = <3008000>;
351 regulator-max-microvolt = <3008000>;
355 regulator-min-microvolt = <1800000>;
356 regulator-max-microvolt = <1800000>;
360 regulator-min-microvolt = <1800000>;
361 regulator-max-microvolt = <1800000>;
366 regulators-1 {
367 compatible = "qcom,rpm-pmi8998-regulators";
369 vdd_bob-supply = <&vph_pwr>;
372 regulator-min-microvolt = <3312000>;
373 regulator-max-microvolt = <3600000>;
391 gpio-reserved-ranges = <0 4>, <81 4>;
396 cd-gpios = <&tlmm 95 GPIO_ACTIVE_LOW>;
398 vmmc-supply = <&vreg_l21a_2p95>;
399 vqmmc-supply = <&vreg_l13a_2p95>;
401 pinctrl-names = "default", "sleep";
402 pinctrl-0 = <&sdc2_on &sdc2_cd>;
403 pinctrl-1 = <&sdc2_off &sdc2_cd>;
412 vcc-supply = <&vreg_l20a_2p95>;
413 vccq-supply = <&vreg_l26a_1p2>;
414 vccq2-supply = <&vreg_s4a_1p8>;
415 vdd-hba-supply = <&vreg_l26a_1p2>;
416 vcc-max-microamp = <750000>;
417 vccq-max-microamp = <560000>;
418 vccq2-max-microamp = <750000>;
423 vdda-phy-supply = <&vreg_l1a_0p875>;
424 vdda-pll-supply = <&vreg_l2a_1p2>;
432 dr_mode = "host"; /* Force to host until we have Type-C hooked up */
438 vdda-phy-supply = <&vreg_l1a_0p875>;
439 vdda-pll-supply = <&vreg_l2a_1p2>;
445 vdd-0.8-cx-mx-supply = <&vreg_l5a_0p8>;
446 vdd-1.8-xo-supply = <&vreg_l7a_1p8>;
447 vdd-1.3-rfa-supply = <&vreg_l17a_1p3>;
448 vdd-3.3-ch0-supply = <&vreg_l25a_3p3>;