Lines Matching +full:led +full:- +full:usb +full:- +full:mode

1 // SPDX-License-Identifier: GPL-2.0-only
3 /dts-v1/;
5 #include "msm8916-wingtech-wt865x8.dtsi"
10 	chassis-type = "handset";
13 	speaker_amp_left: audio-amplifier-left {
16 		pinctrl-0 = <&spk_ext_pa_left_default>;
17 		pinctrl-names = "default";
19 		mode-gpios = <&tlmm 119 GPIO_ACTIVE_HIGH>;
20 		sound-name-prefix = "Speaker Amp L";
21 		awinic,mode = <3>;
25 	speaker_amp_right: audio-amplifier-right {
28 		pinctrl-0 = <&spk_ext_pa_right_default>;
29 		pinctrl-names = "default";
31 		mode-gpios = <&tlmm 121 GPIO_ACTIVE_HIGH>;
32 		sound-name-prefix = "Speaker Amp R";
33 		awinic,mode = <3>;
36 	gpio-leds {
37 		compatible = "gpio-leds";
39 		pinctrl-0 = <&gpio_leds_default>;
40 		pinctrl-names = "default";
42 		led-0 {
45 			default-state = "off";
46 			retain-state-suspended;
49 		led-1 {
52 			default-state = "off";
53 			retain-state-suspended;
57 	usb_id: usb-id {
58 		compatible = "linux,extcon-usb-gpio";
59 		id-gpios = <&tlmm 110 GPIO_ACTIVE_HIGH>;
60 		pinctrl-0 = <&usb_id_default>;
61 		pinctrl-names = "default";
67 		compatible = "asahi-kasei,ak09911";
70 		vdd-supply = <&pm8916_l17>;
71 		vid-supply = <&pm8916_l6>;
78 		interrupts-extended = <&tlmm 115 IRQ_TYPE_EDGE_RISING>;
80 		vdd-supply = <&pm8916_l17>;
81 		vddio-supply = <&pm8916_l6>;
83 		pinctrl-0 = <&imu_default>;
84 		pinctrl-names = "default";
86 		mount-matrix = "1",  "0", "0",
87 			       "0", "-1", "0",
93 	qcom,micbias1-ext-cap;
100 	pin-switches = "Speaker", "Headphones";
101 	audio-routing = "Speaker", "Speaker Amp L OUT",
112 	aux-devs = <&speaker_amp_left>, <&speaker_amp_right>, <&headphones_switch>;
115 &usb {
124 	gpio_leds_default: gpio-leds-default-state {
127 		drive-strength = <2>;
128 		bias-disable;
131 	imu_default: imu-default-state {
134 		drive-strength = <2>;
135 		bias-disable;
138 	spk_ext_pa_left_default: spk-ext-pa-left-default-state {
141 		drive-strength = <2>;
142 		bias-disable;
145 	spk_ext_pa_right_default: spk-ext-pa-right-default-state {
148 		drive-strength = <2>;
149 		bias-disable;
152 	usb_id_default: usb-id-default-state {
155 		drive-strength = <8>;
156 		bias-pull-up;